Page 231 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
& K D Q J L Q J ( Q J L Q H 2 L O D Q G ) L O W H UDrain the engine oil while the engine is still
warm.
64MS151
(1) Engine oil filler cap (D13A engine)
(2) Engine oil filler cap (D16AA engine)
1) Remove the oil filler cap.
2) Place a drain pan under the drain plug.
3) Using a wrench, remove the drain plug
and drain out the engine oil.
60G306
7 L J K W H Q L Q J W R U T X H I R U G U D L Q S O X J
1 P N J P O E I W
4) Reinstall the drain plug
Z L W K Q H Z
gasket.
Tighten the plug with a
wrench to the
specified torque.
5 H S O D F H W K H 2 L O ) L O W H U ) R U ' $ ' L H V H O ( Q J L Q H 0 R G H O
NOTE:
Since special procedures and tools are
required, it is recommended that you trust
this job to your D X W K R U L V H G 0 D U X W L
6 X ] X N L Z R U N V K R S.
1) Using a socket or a ring spanner
remove oil filter housing cover (3).
61M7001
(1) Loosen
(2) Tighten
2) Remove the old oil filter element and
replace it with a new oil filter element.
3) Clean the surface of oil filter cap and
replace the O-ring.4)
Tighten the oil filter housing cover on
the oil filter housing using a socket or
ring spanner to the specified torque.
& $ 8 7 , 2 1
7 K H H Q J L Q H R L O W H P S H U D W X U H P D \ E H
K L J K H Q R X J K W R E X U Q \ R X U I L Q J H U V
Z K H Q W K H G U D L Q S O X J L V O R R V H Q H G : D L W
X Q W L O W K H G U D L Q S O X J L V F R R O H Q R X J K W R
W R X F K Z L W K \ R X U E D U H K D Q G V
(2)
(1)
Open
Close
( ; $ 0 3 / (
: $ 5 1 , 1 *
1 H Z D Q G X V H G R L O F D Q E H K D ] D U G R X V
& K L O G U H Q D Q G S H W V P D \ E H K D U P H G E \
V Z D O O R Z L Q J Q H Z R U X V H G R L O . H H S Q H Z
D Q G X V H G R L O D Q G X V H G R L O I L O W H U V D Z D \
I U R P F K L O G U H Q D Q G S H W V
5 H S H D W H G S U R O R Q J H G F R Q W D F W Z L W K
X V H G H Q J L Q H R L O P D \ F D X V H V N L Q F D Q
F H U
% U L H I F R Q W D F W Z L W K X V H G R L O P D \ L U U L W D W H
V N L Q
7 R P L Q L P L ] H \ R X U H [ S R V X U H W R X V H G
R L O Z H D U D O R Q J V O H H Y H V K L U W D Q G P R L V
W X U H S U R R I J O R Y H V V X F K D V G L V K Z D V K
L Q J J O R Y H V Z K H Q F K D Q J L Q J R L O , I R L O
F R Q W D F W V \ R X U V N L Q Z D V K W K R U R X J K O \
Z L W K V R D S D Q G Z D W H U
/ D X Q G H U D Q \ F O R W K L Q J R U U D J V L I Z H W
Z L W K R L O
5 H F \ F O H R U S U R S H U O \ G L V S R V H R I X V H G
R L O D Q G R L O I L O W H U
(1)
(2)
(3)
( ; $ 0 3 / (
Page 232 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
7 L J K W H Q L Q J W R U T X H I R U R L O I L O W H U
' $ ' L H V H O H Q J L Q H
1 P N J P O E I W
5 H I L O O Z L W K 2 L O D Q G & K H F N I R U / H D N V1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to the “Capacities” item in the
“SPECIFICATIONS” section.
2) Start the engine and look carefully for
leaks at the oil filter and drain plug. Run
the engine at various speeds for at least
5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
oil if necessary. Check for leaks again.
) R U ' $ $ ' L H V H O ( Q J L Q H 0 R G H OSince spec
ial procedures and tools are
requ
ired,
it is recommended that you trust
this job to your
A U T H O R I S E D - A R U T I
3 U Z U K I W O R K S H O P
( Q J L Q H & R R O D Q W 6 H O H F W L R Q R I & R R O D Q WTo m a
inta
in opt
imum performance and
durab
ility of your eng
ine, use MARUTI
Genu
ine Coolant or equ
ivalent
.
Th
is type of coolant
is best for your cool
ing
system as
it:
• Helps mainta
in proper eng
ine tempera-
ture
.
•G
ives proper protect
ion aga
inst freez
ing
and bo
iling.
•G
ives proper protect
ion aga
inst corro-
s
ion and rust
.
Failure to use the proper coolant can dam-
age your cooling system. Your D X W K R U L V H G
0 D U X W L 6 X ] X N L Z R U N V K R S can help you
select the proper coolant.
NOTICE
7 R S U H Y H Q W R L O O H D N D J H P D N H V X U H
W K D W W K H R L O I L O W H U L V W L J K W E X W G R Q R W
R Y H U W L J K W H Q L W
NOTICE
Page 235 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
V S H H G P D Q X D O W U D Q V D [ O H
71LS10701
7 R F K H F N W K H J H D U R L O O H Y H O X V H W K H I R O
O R Z L Q J S U R F H G X U H 1) Park the vehicle on a level surface with
the parking brake applied. Then, stop
the engine.
2) Remove the oil filler and level plug.
3) If gear oil flows from the plug hole, the oil
level is correct. Reinstall the plug. If gear
oil does not flow from the plug hole, add
oil through the filler plug hole until oil
flows a little from the plug hole. 7 L J K W H Q L Q J W R U T X H I R U R L O I L O O H U D Q G O H Y H O
S O X J
0 D Q X D O W U D Q V D [ O H R U
1 P N J P O E I W
* H D U 2 L O & K D Q J HSince special procedures, materials and
tools are required, it is recommended that
you trust this job to your D X W K R U L V H G 0 D U X W L
6 X ] X N L Z R U N V K R S.
& $ 8 7 , 2 1
$ I W H U G U L Y L Q J W K H Y H K L F O H W K H J H D U R L O
W H P S H U D W X U H P D \ E H K L J K H Q R X J K W R
E X U Q \ R X : D L W X Q W L O W K H R L O I L O O H U D Q G
O H Y H O S O X J L V F R R O H Q R X J K W R W R X F K
Z L W K \ R X U E D U H K D Q G V E H I R U H L Q V S H F W
L Q J J H D U R L O O H Y H O
(2)
( ; $ 0 3 / (
NOTICE
: K H Q W L J K W H Q L Q J W K H S O X J D S S O \ W K H
I R O O R Z L Q J V H D O L Q J F R P S R X Q G R U
H T X L Y D O H Q W W R W K H S O X J W K U H D G V W R S U H
Y H Q W R L O O H D N D J H
0 $ 5 8 7 , 6 8 = 8 . , % R Q G 1 R