2011 NISSAN LEAF Owners Manual

5. Remove the protective cap*Aof the hose
and screw the hose securely onto the tire
valve. Make sure that the pressure release
valve
*Bis securely tightened. Make sure
that the air compressor switch is in the OFF
(O) position, and then insert the power plug
into the power outlet in the vehicle.

If the tire pressure does not increase to26
psi (180 kPa) within 10 minutes, the tire
may be seriously damaged and the tire
cannot be repaired with this tire repair
kit. Contact a NISSAN certified LEAF
dealer.
7. When the tire pressure is at the specified amount, turn the air compressor off. If the
tire cannot be inflated to the specified
amount, the air compressor can be turned
off at the minimum of 26 psi (180 kPa) .
Remove the power plug from the power
outlet and quickly remove the hose from the
tire valve. Attach the protective cap and
valve cap. Properly stow the emergency tire
puncture repair kit in the cargo area.

.NISSAN recommends using only
NISSAN Genuine Emergency Tire
Sealant provided with your vehicle.
Other tire sealants may damage the
valve stem seal which can cause the
tire to lose air pressure.

WARNING
.Always follow the instructions be-
low. Failure to do so could result in
damage to the DC/DC converter and
cause personal injury.

compartment and that the cable
clamps do not contact any other
metal.
8. Start the engine of the booster vehicle
*B.
9. While the booster vehicle
*Bengine is
running, place the EV system in the READY
to drive position.

in the P (Park) position, and the electric
parking brake cannot be applied. If this
occurs, place suitable blocks at both
the front and back of a wheel to prevent
the vehicle from moving. Failure to
block a wheel may allow the vehicle to
move unexpectedly which may result in
serious personal injury or death.
To place the vehicle in the READY position so
the vehicle can be driven, charge the Li-ion
battery until the driving range on the instrument
panel changes from “---” to a numeric distance.