2011 NISSAN LEAF Owners Manual

4. Store in its case.NOTE:
Perform the following procedure to
store the EVSE (Electric Vehicle Supply
Equipment) in the case.
a. Wind the charge cable into a sizethat will allow it to be stored in the
case (approximately 9.8 in (250 mm)
in diameter) .
b. Place the EVSE (Electric Vehicle Supply Equipment) control box into
the back of the case.
c. Place the charge cable and charge connector into the case in front of the EVSE (Electric Vehicle Supply
Equipment) control box.
WARNING
WARNING
.
Always use a quick charger that is
compatible with the LEAF. Using an
incompatible quick charger may
cause a fire or malfunction resulting
in serious personal injury or death.
. Before starting the quick charge,
carefully read the instructions pro-
vided on the quick charger and
make sure the quick charge con-
nector is properly connected and
locked. Failure to connector or op-
erate the quick charger correctly
could cause damage to the vehicle
or the charging equipment.
ChargingCH-15

To start charging:
1. Push the P position switch to place thevehicle in the P (Park) position and apply the
electric parking brake.
2. When charging the Li-ion battery, place the power switch in the OFF position. When the
power switch is in the ON position, the Li-
ion battery will not start charging.
3. Open the charge port lid and charge port cap. See “Charge port lid” and “Charge port
cap” in the “3. Pre-driving checks and
adjustments” section.
CAUTION
.Be sure to insert the charge con-
nector straight into the quick charge
port right up to the base. Failure to
do so may result in the Li-ion battery
not charging or could cause damage
to the charging equipment.

CAUTION
.As the quick charge connector is
heavier in comparison to the other
charge connectors, allowing it to
drop could cause damage to the
vehicle or charge connector or per-
sonal injury. When removing the
connector, be sure to pull it out
straight and as carefully as possible.
and
touch [Charging Timer].
CHARGING METHODS