Driving information
E00509000067
For vehicles with MITSUBISHI MOTORS genu-
ine audio
The
momentary fuel consumption, average fuel con-
sumption, driving range and average speed can be
displayed.
When the ignition switch is turned to the “ON” po-
sition, the display shows the 4 items sequentially
and returns to the original display that is shown be-
fore the ignition switch was last turned to the
“OFF” position.
NOTE
l If the “DISP” button is pressed while the dis-
play is scrolling through the sequence men-
tioned above, the display stops scrolling and
shows the item that was shown before the ig-
nition switch was last turned to the “OFF” po-
sition.
Except for vehicles with MITSUBISHI MOTORS
genuine audio
Only the momentary fuel consumption can be dis-
played. Refer to “Momentary fuel consumption”
on page 3-13.
Change of driving information (For vehicles with
MITSUBISHI MOTORS
genuine audio)E00509100068
Every time the “DISP” button is pressed lightly
(less than 5 seconds), the display can be changed. Momentary fuel consumption → Average fuel con-
sumption → Driving range → Average speed
Momentary fuel consumption
E00509200014
This value shows the momentary fuel consumption
(in
L/100 km, km/L or mpg). Calculation and indi-
cation of the value begin when the vehicle speed
rises above 6 km/h (4 mph). Average fuel consumption
E00509300073
This
value shows the average fuel consumption (in
L/100 km, km/L or mpg). NOTE
l When
the ignition switch is turned to the
“ON” position, the average fuel consumption
which was being displayed when the ignition
switch was previously turned off will be dis-
played once again.
l Average fuel consumption varies according
to the conditions under which a vehicle is trav-
elling (road conditions, the manner in which
the vehicle is being driven, etc.).
Observe this display for reference because
the fuel consumption display may differ
from the actual fuel consumption.
To reset the display
You can switch from the automatic reset mode to
the manual reset mode by performing the following
operations: Instruments and controls
3-13 3
Presented by http://mmc-manuals.ru/ \251
H - km
M - mile
3. If
the km unit was selected in step 2, the fuel
consumption unit must be subsequently selec-
ted using the “H” button (C) or “M” button
(B).
Use the “H” button (C) or “M” button (B) to
select the desired fuel consumption unit, then
press the “SET” button (D) to enter the setting. H - L/100 km
M - km/L
4. When
you have finished setting the fuel con-
sumption unit (or if you selected miles in
step 2), the system will require you to pro-
ceed to select, using the “H” button (C) or
“M” button (B), whether times should be dis-
played in the 12-hour format or in the
24-hour format. The currently selected for-
mat will be displayed.
Use the “H” button (C) or “M” button (B) to
choose your desired time display format, and
then press the “SET” button (D) to enter the
setting. H - 12-hour format
M - 24-hour format
5. The
display will return to the original display
item.
NOTE l If you selected the mile unit in step 2, the
speed and fuel consumption units will be as
follows.
• Speed: mph (miles per hour)
• Fuel consumption: mpg (miles per gallon) Instruments and controls
3-17 3
Presented by http://mmc-manuals.ru/ \251
