2010 MITSUBISHI GRANDIS lock

7-person seatWARNING
l When
a person is sitting in the middle seat-
ing position of the second seat in a cabin
with 7-person seats, the two sides of the
second seat must have the same forward/
backward position and the same seatback
angle. Otherwise, the seat belt for the mid-
dle seating position may not be adequate-
ly effective in the event of hard braking
or a collision. CAUTION
l
The
reclining mechanism of the seatback
is spring loaded, causing it to return to
the vertical position when the lock lever
is operated. When using the lever, sit
close to the seatback or hold it with your
hand to control its return motion. Armrest
E00402400250

6 - person seat
To

adjust the armrest angle, tip the armrest forward
and then raise it to the desired position.
To return the armrest to its original position, raise
it backward. 7 - person seat
To use the armrest, fold it down.
To

return to the original position, push it backward
(into the seatback) until it is level with the seat. NOTE
l Do

not stand or sit on the armrest. It could
break.
To get in and out of the third seat E00402500222
The lever can be used to make getting in and out
easier. 1- 1- To get in or out
2-

2- To get out

Fold the seatback forward, then slide the entire seat
forward. To return the seat, slide the entire seat
fully backward to retain it and then raise the seat-
back.
After returning the seat, gently try to move it for-
ward and backward to check that it is securely re-
tained. Seat and seat belts
2-08
2
Presented by http://mmc-manuals.ru/ \251

WARNING
l Do not drive the vehicle with the seatback
folded
forward. The seat is not retained
with the seatback in this position, so seri-
ous injuries could be suffered in the event
of hard braking or a collision. CAUTION
l
The
reclining mechanism of the seatback
is spring loaded, causing it to return to
the vertical position when the lock lever
is operated. When using the lever, sit
close to the seatback or hold it with your
hand to control its return motion.
l Use a foot to operate the pedal (2).
Folding up the seat cushion E00409700021
It is possible to create a luggage area by folding up
the seat cushion and moving the seat forward. WARNING
l Do
not allow a passenger to sit on the seat
or a child to play on it with the seat cush-
ion folded up.
Otherwise, serious injuries could be suf-
fered in the event of hard braking. CAUTION
l
Do
not stack luggage above the seatback
height. Secure the luggage firmly.
Otherwise, serious accidents could result
due to restricted rear vision or unrestrain-
ed objects entering the passenger compart-
ment during sudden braking.
To fold 1. If
the seatback is reclined, raise it to the ini-
tial locked position. (Refer to “To recline the
seatback” on page 2-07.)
2. With the lever pulled on the side you wish to fold, fold up the seat cushion.
6-person seat
7-person seat To return
With

the lever pulled, return the seat cushion to its
original position.
Then, check that the seat is securely retained.
NOTE
l With the seat in its most forward position,
the seat cushion cannot be returned to its orig-
inal position.
To adjust the seat forward or backward with the
seat cushion folded up
Adjust the seat forward or backward with the lever
pulled. Seat and seat belts
2-09 2
Presented by http://mmc-manuals.ru/ \251

After making the adjustment, gently try to move it
forward
and backward to check that it is securely re-
tained.
6-person seat
7-person seat NOTE
l The

seat can slide further forward only when
the seat cushion is folded up. To adjust the seat cushion angle
E00410300014
If,

while raising the seat cushion, you release the
lever when the seat cushion reaches some desired
angle, the seat cushion will be held at that angle.
6-person seat
7-person seat Third seat*
E00402700282
When

sitting in the third seat, adjust the head re-
straints to heights at which they lock in position. Re-
fer to “Head restraints” on page 2-11.
To recline the seatback E00402800140
In order to recline the seatback, lean forward slight-
ly,

pull the seatback lock lever up, and then lean
backward to the desired position and release the lev-
er. The seatback will lock in that position. NOTE
l It

is possible to adjust the seatback angle in-
dependently on each side of the seats. Seat and seat belts
2-10
2
Presented by http://mmc-manuals.ru/ \251

CAUTION
l
The reclining mechanism of the seatback
is spring loaded, causing it to return to
the vertical position when the lock lever
is operated. When using the lever, sit
close to the seatback or hold it with your
hand to control its return motion.
Folding the seatbacks forward E00402900024
Larger objects can be loaded into the vehicle if a
seatback is folded forwards. WARNING
l The
luggage compartment in the rear of
the vehicle should never be used as a play
area by children. Children should be seat-
ed with seat belts fastened when the vehi-
cle is in motion. Be sure that the rear seat-
backs are returned to their fully upright
position and locked in place. CAUTION
l
Do
not stack luggage above the seatback
height. Secure the luggage firmly.
Otherwise, serious accidents could result
due to restricted rear vision or unrestrain-
ed objects entering the passenger compart-
ment during sudden braking. To fold
Pull

the belt (A) behind the seatback that you wish
to fold, then tilt the seatback forwards until it locks. To return
1. Pull
the belt (A) behind the seatback which
is desired to be raised, then raise the seatback
until it locks securely into place.
2. Push lightly on the seatback to confirm that it has actually been secured. Head restraints
E00403301240 WARNING
l Driving
without the head restraints in
place can cause you and your passengers
serious injury or death in an accident. To
reduce the risk of injury in an accident, al-
ways make sure the head restraints are in-
stalled and properly positioned when the
seat is occupied.
l Never place a cushion or similar device
on the seatback. This can adversely affect
head restraint performance by increasing
the distance between your head and the
restraint.
To adjust height
Adjust
the head restraint height so that the centre
of the restraint is as close as possible to eye level to
reduce the chances of injury in the event of colli-
sion. Any person too tall for the restraint to reach
their seated eye level, should adjust the restraint as
high as possible. Seat and seat belts
2-11 2
Presented by http://mmc-manuals.ru/ \251

To raise the head restraint, move it upward. To low-
er
the restraint, move it downward while pushing
the height adjusting knob (A) in the direction of the
arrow. After adjustment, push the head restraint
downward and make sure that it is locked. To remove
Lift

the head restraint with the height adjusting
knob (A) pushed in. To install
Confirm

that the head restraint is facing the correct
direction, and then insert it into the seatback while
pressing the height adjusting knob (A) in the direc-
tion indicated by the arrow. CAUTION
l
Confirm
that the height adjusting knob
(A) is correctly adjusted as shown in the
illustration, and also lift the head re-
straints to ensure that they do not come
out of the seatback. CAUTION
l
The
head restraints for the seats differ in
shape and size. When installing head re-
straints, make sure the head restraints
are fitted in their respective seats.
Failure to do so could cause serious in-
jury if involved in an accident. Seat and seat belts
2-12
2
Presented by http://mmc-manuals.ru/ \251

Making a luggage area
E00403400039WARNING
l If required, always operate the seating be-
fore the vehicle is in motion.
l After seat operations are made, ensure
the seating is locked in position by attempt-
ing to move the seat and seatback for-
ward and rearward without using the ad-
justing mechanism.
l The luggage compartment in the rear of
the vehicle should never be used as a play
area by children. Children should be seat-
ed with seat belts fastened when the vehi-
cle is in motion. Be sure that the rear seat-
backs are returned to their fully upright
position and locked in place. CAUTION
l
Do
not stack luggage above the seatback
height.
Secure the luggage firmly.
Otherwise, serious accidents could result
due to restricted rear vision or unrestrain-
ed objects entering the passenger compart-
ment during sudden braking.
l Make sure that the seat is operated by an
adult. If it is operated by a child, an unex-
pected accident might occur.
l When folding or storing the seat, be sure
not to catch your hand or leg. Stowing the third seat
E00404100020
The

third seat can be stowed under the floor to cre-
ate a luggage area.
NOTE
l Each side of the third seats can be stowed in-
dependently of the other.
To stow 1. Remove the head restraints from the thirdseats. (Refer to “Head restraints” on page
2-11.)
2. Fold the seatback forward and make sure it is securely retained against the seat cushion.
(Refer to “Folding the seatbacks forward” on
page 2-11.)
NOTE l The seatback cannot be retained if any object
is trapped between the seatback and seat cush-
ion.
l If the seatback is not retained against the seat
cushion when the seat is stowed, it may get
caught on the floor and prevent the seat from
being returned to its original position. 3. Pull the belt (A) on the back of the seat cush-
ion until it clicks. 4. Tip
the entire seat backward. Hold the han-
dle (B) on the back of the seat cushion and
lower the seat into the floor. Seat and seat belts
2-13 2
Presented by http://mmc-manuals.ru/ \251

CAUTION
l
When stowing the seat, hold it with your
hands and lower it slowly. Unless you
hold the seat securely, it may suddenly tip
under its own weight, trapping your
hands.
l Do not pull the belt while a person is sit-
ting on the seat. The seat could tip back-
ward, resulting in an accident.
NOTE l The

removed third seat head restraints (C)
can be fitted together and stored in the cargo
net in the luggage area. (Refer to “Cargo net”
on page 5-45.) To return
1. Use
the handle (B) to lift the entire seat. Slow-
ly tip the seat forward, then push it until it
locks securely in position. 2. Pull
the belt (D) on the back of the seatback.
With the belt pulled, raise the seatback to its
original position. 3. After
raising the seatback to its original posi-
tion, push lightly on it to confirm that it has
been secured.
4. Install the head restraints. Making a flat seat
E00404300064
By

removing the head restraints and fully reclining
the seatbacks of the seats, one large flat seat is ach-
ieved. WARNING
l Never
drive with luggage or passengers
on the flat seat. This is highly dangerous.
In a collision, people or children riding un-
restrained in these areas are more likely
to be seriously injured or killed.
Do not allow people or children to ride in
any area of your vehicle that is not equip-
ped with seats and seat belts, and make
sure that everyone travelling in your vehi-
cle is in a seat and wearing a seat belt, or
in the case of a child is strapped in a child
restraint.
In the interest of their safety, children
should not be allowed to adjust the seats. CAUTION
l
To
make a flat seat, stop the vehicle in a
safe place.
l Make sure that the seat is adjusted by an
adult. If it is adjusted by a child, an unex-
pected accident might occur.
l When sliding the seat, be sure not to
catch your hand or leg.
l Do not walk around on top of the seats af-
ter they have been laid flat.
l To ensure the seats are locked securely, at-
tempt to move them back and forth. Seat and seat belts
2-14
2
Presented by http://mmc-manuals.ru/ \251

5. Tip the seatbacks of the third seats back-
ward. (Refer to “To recline the seatback” on
page 2-10.) 6. Move
the front seats backward until they
touch the second seats. Lock them in that po-
sition. The flat seat configuration is now com-
plete.
To return the seats to their normal positions,
reverse the above procedure. NOTE
l You

can store the head restraints (A) re-
moved from the second seat (except the mid-
dle seating position) by inserting their rods
between the tipped third seat and the wall of
the luggage area on the right side. l
The
head restraints (B) removed from the
third seat and the second seat (the middle seat-
ing position) can be fitted together and stor-
ed in the cargo net in the luggage area. Seat belts
E00404800593
To

protect you and your passengers in the event of
an accident, it is most important that the seat belts
be worn correctly while driving.
The front seat belts have a pretensioner system.
These belts are used the same way as a convention-
al seat belt.
Refer to “Seat belt pretensioner system and force
limiter system” on page 2-20 . WARNING
l Always
place the shoulder belt over your
shoulder and across your chest. Never
put it behind you or under your arm.
l One seat belt should be used by only one
person.
Doing otherwise can be dangerous.
l The seat belt will provide its wearer with
maximum protection if the recliner seat-
back is placed in fully upright position.
When the seatback is reclined, there is
greater risk that the passenger will slide
under the belt, especially in a forward im-
pact accident, and may be injured by the
belt or by striking the instrument panel
or seatbacks.
l Seat belts should always be worn by ev-
ery adult who drives or rides in this vehi-
cle, and by all children who are tall
enough to wear seat belts properly.
l Remove any twists when using the belt. Seat and seat belts
2-17 2
Presented by http://mmc-manuals.ru/ \251