2010 MITSUBISHI GRANDIS fold seats

Seat
E004001014496-person seat7-person seat1-Front seat
l To adjust forward or backward
® p. 2-05
l To recline the seatback

® p. 2-06
l To adjust seat cushion height ® p. 2-06
l Armrest* ® p. 2-06
l Heated seats*
® p. 2-06
2- Second seat l To adjust forward or backward
® p. 2-07
l To recline the seatback
® p. 2-07
l Armrest ® p. 2-08
l To get in and out of the third seat
® p. 2-08
l Folding up the seat cushion
® p. 2-093-Third seat*
l To recline the seatback
® p. 2-10
l Folding the seatbacks forward
® p. 2-11
l Stowing the third seat
® p. 2-13Seat and seat belts
2-02
2
Presented by http://mmc-manuals.ru/ \251

CAUTION
l
Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater
to low to keep it warm. Slight variations
in seat temperature may be felt while us-
ing the heated seats. This is caused by the
operation of the heater’s internal thermo-
stat and does not indicate a malfunction.
l If the following types of persons use the
heated seats, they might become too hot
or receive minor burns (red skin, heat blis-
ters, etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcoholor sleep inducing medication (cold
medicine, etc.)
l Do not use a blanket, cushion, or other ma-
terial with high heat insulation properties
on the seat while using the heater; this
might cause the heater element to overheat
l Turn the heater off immediately if it ap-
pears to be malfunctioning during use.
NOTE l Do

not place heavy objects on the seat or
stick pins, needles, or other pointed objects
into it.
l When cleaning the seat, do not use benzene,
kerosene, petrol, alcohol, or other organic sol-
vents; these might damage the surface of the
seat and also the heater element.
l If water or any other liquid is spilled on the
seat, allow it to dry thoroughly before attempt-
ing to use the heater. Second seat
E00402000227
When

a person is sitting in the middle seating posi-
tion of the second seat in a cabin with 7-person
seats, adjust the head restraints to heights at which
they lock in position. Refer to “Head restraints” on
page 2-11.
NOTE
l It is possible to adjust each side of the sec-
ond seats forward and backward independent-
ly of the other side, to adjust the seatback an-
gle independently on each side, and to fold
up the seat cushion independently on each
side.
To adjust forward or backward E00402100097
Pull the seat adjusting left- or right-hand lever and
adjust

the seat forward or backward to the desired
position. After adjustment, release the adjusting lev-
er to lock the seat in position.
6-person seat
7-person seat WARNING
l To
ensure the seat is locked securely, try
to move the seat forward or backward
without using the adjusting lever.
To recline the seatback E00402200186
In order to recline the seatback, lean forward slight-
ly,

pull the seatback lock lever up, and then lean
backward to the desired position and release the lev-
er. The seatback will lock in that position.
6-person seat Seat and seat belts
2-07 2
Presented by http://mmc-manuals.ru/ \251

7-person seatWARNING
l When
a person is sitting in the middle seat-
ing position of the second seat in a cabin
with 7-person seats, the two sides of the
second seat must have the same forward/
backward position and the same seatback
angle. Otherwise, the seat belt for the mid-
dle seating position may not be adequate-
ly effective in the event of hard braking
or a collision. CAUTION
l
The
reclining mechanism of the seatback
is spring loaded, causing it to return to
the vertical position when the lock lever
is operated. When using the lever, sit
close to the seatback or hold it with your
hand to control its return motion. Armrest
E00402400250

6 - person seat
To

adjust the armrest angle, tip the armrest forward
and then raise it to the desired position.
To return the armrest to its original position, raise
it backward. 7 - person seat
To use the armrest, fold it down.
To

return to the original position, push it backward
(into the seatback) until it is level with the seat. NOTE
l Do

not stand or sit on the armrest. It could
break.
To get in and out of the third seat E00402500222
The lever can be used to make getting in and out
easier. 1- 1- To get in or out
2-

2- To get out

Fold the seatback forward, then slide the entire seat
forward. To return the seat, slide the entire seat
fully backward to retain it and then raise the seat-
back.
After returning the seat, gently try to move it for-
ward and backward to check that it is securely re-
tained. Seat and seat belts
2-08
2
Presented by http://mmc-manuals.ru/ \251

After making the adjustment, gently try to move it
forward
and backward to check that it is securely re-
tained.
6-person seat
7-person seat NOTE
l The

seat can slide further forward only when
the seat cushion is folded up. To adjust the seat cushion angle
E00410300014
If,

while raising the seat cushion, you release the
lever when the seat cushion reaches some desired
angle, the seat cushion will be held at that angle.
6-person seat
7-person seat Third seat*
E00402700282
When

sitting in the third seat, adjust the head re-
straints to heights at which they lock in position. Re-
fer to “Head restraints” on page 2-11.
To recline the seatback E00402800140
In order to recline the seatback, lean forward slight-
ly,

pull the seatback lock lever up, and then lean
backward to the desired position and release the lev-
er. The seatback will lock in that position. NOTE
l It

is possible to adjust the seatback angle in-
dependently on each side of the seats. Seat and seat belts
2-10
2
Presented by http://mmc-manuals.ru/ \251

Making a luggage area
E00403400039WARNING
l If required, always operate the seating be-
fore the vehicle is in motion.
l After seat operations are made, ensure
the seating is locked in position by attempt-
ing to move the seat and seatback for-
ward and rearward without using the ad-
justing mechanism.
l The luggage compartment in the rear of
the vehicle should never be used as a play
area by children. Children should be seat-
ed with seat belts fastened when the vehi-
cle is in motion. Be sure that the rear seat-
backs are returned to their fully upright
position and locked in place. CAUTION
l
Do
not stack luggage above the seatback
height.
Secure the luggage firmly.
Otherwise, serious accidents could result
due to restricted rear vision or unrestrain-
ed objects entering the passenger compart-
ment during sudden braking.
l Make sure that the seat is operated by an
adult. If it is operated by a child, an unex-
pected accident might occur.
l When folding or storing the seat, be sure
not to catch your hand or leg. Stowing the third seat
E00404100020
The

third seat can be stowed under the floor to cre-
ate a luggage area.
NOTE
l Each side of the third seats can be stowed in-
dependently of the other.
To stow 1. Remove the head restraints from the thirdseats. (Refer to “Head restraints” on page
2-11.)
2. Fold the seatback forward and make sure it is securely retained against the seat cushion.
(Refer to “Folding the seatbacks forward” on
page 2-11.)
NOTE l The seatback cannot be retained if any object
is trapped between the seatback and seat cush-
ion.
l If the seatback is not retained against the seat
cushion when the seat is stowed, it may get
caught on the floor and prevent the seat from
being returned to its original position. 3. Pull the belt (A) on the back of the seat cush-
ion until it clicks. 4. Tip
the entire seat backward. Hold the han-
dle (B) on the back of the seat cushion and
lower the seat into the floor. Seat and seat belts
2-13 2
Presented by http://mmc-manuals.ru/ \251