2010 JAGUAR XFR Crank

Engine - V8 S/C 5.0L Petrol - Crankshaft Front Seal
Removal and Installation Published: 11-May-2011


Removal


NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

2. Refer to: Crankshaft Pulley (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).


3. CAUTION: Do not over tighten the crankshaft front seal.
Failure to follow this instruction may result in damage to
the vehicle.
Special Tool(s): 303-1434 303-1434
Remover/Installer, Front Crankshaft Seal Special Tool(s)

Installation

1. CAUTIONS:


Do not over tighten the crankshaft front seal. Failure to follow this
instruction may result in damage to the vehicle.


Take extra care not to damage the seal.

To install, reverse the removal procedure.

303-1438
Crankshaft Damper Bolt Remover/Installer

303-1439
Crankshaft Damper Removal Plate

303-1440
Crankshaft Damper Removal/Installation Stud

303-1441
Crankshaft Damper Remover/Installer Body
303-1448
Locking Tool

12.
























13. NOTE: The graphic shows the tool position for LH
thread only, RH thread will be the opposite.
Support the special tool using a suitable vehicle stand.






















CAUTION: Discard the bolt.

NOTES:


The graphic shows the step for LH thread only, RH
thread will be the opposite.


The crankshaft pulley bolt will be very tight.


The thread is left handed.

14.
15.
16.

























Remove the special tool.

















NOTES:


If the crankshaft damper is fitted with an early RH
thread crankshaft bolt then the pulley can be removed with
a standard puller.


Discard the bolt after removal. www.JagDocs.com

21.
22.
23.


























CAUTION: Discard the friction washer after removing
the crankshaft pulley.


NOTE: Make sure to clean the threads in the end of
the crankshaft and that the crank nose is free of any foreign
materials.

2. CAUTION: Install a new friction washer before
installing the crankshaft pulley.
NOTES:


Make sure to clean the threads in the end of the
crankshaft and that the crank nose is free of any foreign
materials.


Skip to step 11 for engines fitted with early RH thread
crankshaft bolt.












3. Install the special tool. www.JagDocs.com

6. CAUTION: Rotate the crankshaft pulley installation tool
anti-clockwise until the pulley is fully located, do not over
tighten. Failure to do this may result in damge to the
components.




















7. Remove the special tool.