2010.5 Citroen C4 PICASSO Owner's Manual

20
F A M I L I A R I S A T I O N
Take care to attach the third-row pas-
senger seat belts to the rings provided
for this purpose.

Do not attach the belts to the load
anchorage points marked with a red
cross (see illustration above).
Stowing the tongue of the third-row
seat belt

 130
Using the third-row passenger seat
belts (CITROËN Grand C4 Picasso)
P A S S E N G E R S A F E T Y

 Insert tongue C into the buckle on
the right, then insert the second
tongue D into the buckle on the left.

 129
Seat belts
Second row centre seat belt

21
F A M I L I A R I S A T I O N
SECOND ROW SEATS
The 3 second-row seats are independ-
ent of each other and are all the same
width. They can all be adjusted to the
"comfort" position.
Placing a seat in the "comfort"
position
Returning the seat to its original position

 69 Forwards-backwards adjustment
Lift up control
A , located at the front of
the seat, and adjust the seat into the
desired position.
I N T E R I O R
"Comfort" position

 Pull on strap B .
The backrest reclines and the seat base
pivots slightly.

 Pull on strap B and guide the seat
forwards.

22
F A M I L I A R I S A T I O N
I N T E R I O R
Folding the seats
From the boot - whilst loading,
for example (CITROËN Grand
C4 Picasso)
SECOND ROW SEATS
From outside

 Pull fi rmly upwards on strap C , as
indicated by the red arrow, to unlock
the seat; keep pulling until the seat
is fully folded.

 Slide latch A of the panel down-
wards, to unlock it.

 Return the panel to the upright posi-
tion, then slide latch A upwards to
lock it.
Before deploying the rigid panels, check
that the second row seats are in their
fully rear position.

 71
Having fi rstly folded the third-row
seats.

 Pull on strap D to unlock the re-
quired seat. Repositioning the seats
Return the rigid panels of the second-
row seats to their initial (upright) position
and lock them in position (CITROËN
Grand C4 Picasso).
Raise the backrest and push it back-
wards until it locks in position.
Rigid panel (CITROËN Grand
C4 Picasso)
A rigid panel is attached to each sec-
ond-row seat backrest.
Unlocking/Locking the rigid panel

23
F A M I L I A R I S A T I O N
Fold the concertina boards ( 1 2 3 ) ar-
ranged above each of the third-row
seats.
Pull on the black strap F , located on the
seat backrest.

 73
Before moving the third-row seats,
do not forget to lock in the rigid pan-
els fi rst (located at the base of the
second-row seat backrests).
Installing the seats
Put the three sections of the concertina
boards ( 1 2 3 ) to their vertical position,
then pull on the red strap G .
Before moving the third-row seats, re-
turn the rigid panels to the upright posi-
tion and lock them. Pull on control
E , located at the top of
the second-row seats backrest.

 72
I N T E R I O R
Stowing the seats Access to third-row seats
Do not leave objects either on or un-
derneath the second-row seats when
you are folding them.
THIRD ROW SEATS (CITROËN
Grand C4 Picasso)

24
F A M I L I A R I S A T I O N
Ring B Ring D: rear screen wipe Stop.
Intermittent.
Timed wash and wipe. Fixed centred controls steering
wheel
Lighting stalk
Ring A

 94 Stalk C: windscreen wipe

 99
D R I V I N G

1. Off

2. Automatic illumination of headlamps

3. Sidelamps

4. Dipped/main beam headlamps
Front foglamps
Rear foglamp Wiper stalk

1. Optional function controls

2. Cruise control/speed limiter and
parking space sensor

3. Audio system controls

4. Multifunction screen controls

 157

5. Horn

 123

6. Warning lamps for direction indica-
tors and vehicle lamps

 32

 93 Switching on "AUTO" mode

 Press the stalk down and release.
Switching off "AUTO" mode

 Press the stalk up and return it to
position "0" .
The automatic rain sensitive wipers
must be reactivated each time the ve-
hicle is started.
Under certain climatic conditions (low
temperature, humid), condensation
may appear on the inner surfaces of
the headlamps and rear lamps. This
is not an indication of a fault and the
condensation disappears a few min-
utes after switching on the lamps.

25
F A M I L I A R I S A T I O N

 163
Electric parking brake
Before leaving the vehicle, check
that the electric parking brake warn-
ing lamp P (red) is on fi xed (not
fl ashing).
If you leave the vehicle with the en-
gine running, apply the parking brake
manually.
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake. Parking space sensor
You can activate this function by pressing
button
A .
Once the space has been measured, the
system displays the following messages:
< 12 mph (20 km/h)

Parking possible

Parking diffi cult

Parking not advised
This device combines:
- automatic functions: Automatic ap-
plication when the engine stops and
automatic release on use of the ac-
celerator (automatic operation by
default);
- manual use: Manual application/re- lease of parking brake is possible
by operating control lever A .
When in automatic mode, it remains
possible to apply or release the parking
brake at any time:

 To apply it, pull on the lever A .

 To release it, pull then release lever A . Hill start assist
To aid starting on a gradient, your vehicle is
equipped with a system which keeps it im-
mobilised for about 2 seconds, the approx-
imate time it takes to move your foot from
the brake pedal to the accelerator pedal.

 143
D R I V I N G

 136
Do not drive if the parking brake
warning lamp and the P indicator on
the lever A are on.

26
F A M I L I A R I S A T I O N
6-speed electronic gearbox
system

R Reverse

N Neutral

A Automatic mode

M Manual mode
Using control paddles 1 "+" and 2 "-" :
- gear changing in manual mode,
- temporary manual operation in au- tomatic mode.
P Park

R Reverse

N Neutral

D Automatic mode

M Sequential mode
Using control paddles 1 "+" and 2 "-" :
- gear changing in sequential mode,
- temporary manual operation in au- tomatic mode.
Starting

 Check that the selector lever 3 is in
neutral (position N ).

 Press fi rmly on the brake pedal and
turn the ignition key.

 146 Starting

 Check that the selector lever
3 is in
position P or N and turn the ignition
key.
To exit position P , press on the brake
pedal before moving the selector lever.

 153
D R I V I N G
Automatic gearbox

27
F A M I L I A R I S A T I O N
D R I V I N G
Stop & Start
Engine going into STOP mode The "ECO" warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system ; at speeds below
4 mph (6 km/h), press the brake
pedal or put the selector lever into
neutral (position N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
warning lamp fl ashes for a few seconds,
then goes off.

 150 The
"ECO" warning lamp goes
off and the engine restarts:
- with the selector lever in position A
or M , release the brake pedal,
- or with the selector lever in position
N and the brake pedal released,
change to position A or M ,
- or select reverse gear.
In certain circumstances, START mode
may be invoked automatically; the

"ECO" warning lamp fl ashes for a few
seconds, then goes off.

 151 Deactivation/Reactivation
You can deactivate the system at any
time by pressing the
"ECO OFF" button;
the button’s warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key. Before refuelling or doing an-
ything under the bonnet, you
must switch off the ignition
with the key.

 151
Going into engine START mode