5AT-97
AT Main Case
AUTOMATIC TRANSMISSION
24) Install the extension case.
STALLATION, Extension Case.>
25) Install the control valve body.
INSTALLATION, Control Valve Body.>
26) Install the converter case assembly to the
transmission case assembly.
STALLATION, Converter Case.>
27) Install the air breather hose.
INSTALLATION, Air Breather Hose.>
28) Install the ATF filter pipe.
STALLATION, ATF Cooler Pipe & Hose.>
29) Install the oil charge pipe together with an O-
ring.
Pipe.>
30) Install the torque converter assembly.
5AT-62, INSTALLATION, Torque Converter As-
sembly.>
31) Install the transmission assembly to the vehi-
cle.
Transmission Assembly.>
32) Perform Clear Memory 2 operation.
5AT(diag)-17, CLEAR MEMORY MODE, OPERA-
TION, Subaru Select Monitor.>
33) Perform the inspection with driving the vehicle
at the end of repair work, and make sure there is no
faulty as below;
•Excessive shift shock
•Oil leakage from the transmission body, etc.
•Occurrence of noise caused by interference etc.
NOTE:
If excessive shift shock is felt, execute advance op-
eration of learning control.
PROCEDURE, Learning Control.>
C: DISASSEMBLY
1. INPUT CLUTCH PACK ASSEMBLY
1) Remove the front sun gear.
2) Remove the thrust bearing.
3) Remove the snap ring, and then remove the
front carrier.
4) Remove the input clutch assembly from rear in-
ternal gear.
D: ASSEMBLY
1. INPUT CLUTCH PACK ASSEMBLY
1) Assemble the input clutch assembly to rear inter-
nal gear.
2) Install the front carrier, and then install the snap
ring.
AT-02007
AT-02008
AT-02009
AT-02009
AT-02008
