2007 INFINITI FX35 check oil

[x] Cancel search: check oil

Page 2841 of 4366

INFINITI FX35 2007  Service Manual FUEL INJECTOR AND FUEL TUBE EM-49
[VQ35DE]
C 
D  E 
F 
G  H 
I 
J 
K  L 
M  A
EM 
Revision: 2006 July  2007 FX35/FX45
Tighten mounting bolts in two steps in numerical order as 
shown in the figure.

Page 2847 of 4366

INFINITI FX35 2007  Service Manual FRONT TIMING CHAIN CASE EM-55
[VQ35DE]
C 
D  E 
F 
G  H 
I 
J 
K  L 
M  A
EM 
Revision: 2006 July  2007 FX35/FX45
16. Remove collared O-ring from front timing chain case (left and 
right side). 
17. R

Page 2854 of 4366

INFINITI FX35 2007  Service Manual EM-62
[VQ35DE]
FRONT TIMING CHAIN CASE
Revision: 2006 July 2007 FX35/FX45
e. Tighten mounting bolts in numerical order as shown in the fig- 
ure. 
9. Install crankshaft pulley as follows: 
a. Fix cran

Page 2855 of 4366

INFINITI FX35 2007  Service Manual FRONT TIMING CHAIN CASE EM-63
[VQ35DE]
C 
D  E 
F 
G  H 
I 
J 
K  L 
M  A
EM 
Revision: 2006 July  2007 FX35/FX45
Warm up engine thoroughly to make sure there is no leakage of fuel, or any oil/fluids

Page 2867 of 4366

INFINITI FX35 2007  Service Manual TIMING CHAIN EM-75
[VQ35DE]
C 
D  E 
F 
G  H 
I 
J 
K  L 
M  A
EM 
Revision: 2006 July  2007 FX35/FX45
g. After installing rear timing chain case, check the surface height 
difference between the foll

Page 2873 of 4366

INFINITI FX35 2007  Service Manual TIMING CHAIN EM-81
[VQ35DE]
C 
D  E 
F 
G  H 
I 
J 
K  L 
M  A
EM 
Revision: 2006 July  2007 FX35/FX45
e. After installing front timing chain case, check the surface height 
difference between the fol

Page 2874 of 4366

INFINITI FX35 2007  Service Manual EM-82
[VQ35DE]
TIMING CHAIN
Revision: 2006 July 2007 FX35/FX45
c. Tighten crankshaft pulley bolt. 
d. Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt.  
e. Fur

Page 2884 of 4366

INFINITI FX35 2007  Service Manual EM-92
[VQ35DE]
CAMSHAFT
Revision: 2006 July 2007 FX35/FX45
INSPECTION AFTER INSTALLATION 
Inspection of Camshaft Sprocket (INT) Oil Groove
CAUTION:
Perform this inspection only when DTC P0011 or P002