2005 NISSAN NAVARA oil level

TF-102
FRONT OIL SEAL
INSTALLATION
1. Install the front oil seal until it is flush with the end face of the
front case, using Tool.
CAUTION:
lDo not reuse oil seal.
lApply petroleum jelly to oil seal.
2. Align the matching mark of the front drive shaft with the match-
ing mark of the companion flange, then install the companion
flange.
3. Install the self-lock nut and tighten to the specified torque, using
Tool. Refer toTF-112, "
COMPONENTS".
CAUTION:
Do not reuse self-lock nut.
4. Install the front propeller shaft. Refer toPR-4, "
Removal and
Installation".
5. Refill the transfer with fluid and check fluid level. Refer toTF-12,
"FILLING".
6. Check the transfer for fluid leakage. Refer toTF-12, "
FLUID
LEAKAGE AND FLUID LEVEL". Tool number : KV38100500
LDIA0145E
SDIA2214E
Tool number : KV40104000
LDIA0147E

TF-104
REAR OIL SEAL
3. Install the dust cover to the rear case, using suitable tool.
CAUTION:
lDo not reuse dust cover.
lApply petroleum jelly to dust cover.
4. Install the rear propeller shaft. Refer toPR-8, "
Removal and
Installation".
5. Refill the transfer with fluid and check fluid level. Refer toTF-12,
"FILLING".
6. Check the transfer for fluid leakage. Refer toTF-12, "
FLUID
LEAKAGE AND FLUID LEVEL".SDIA3257E

TF-112
TRANSFER ASSEMBLY
INSTALLATION
Note the following, and install in the reverse order of removal.
lTighten the bolts to specification.
lAfter the installation, check the transfer fluid level and fluid leak-
age. Refer toTF-12, "
FLUID LEAKAGE AND FLUID LEVEL".
lAfter filling, start the engine for one minute. Then stop the
engine and recheck the transfer fluid.
lAfter the installation, check the 4WD shift indicator pattern. If
NG, adjust the position between the transfer assembly and
transfer control unit. Refer toTF-4, "
Precautions for Transfer
Assembly and Transfer Control Unit Replacement".
Disassembly and AssemblyEDS0032P
COMPONENTS
Bolt length : 45 mm (1.77 in)
Tightening torque : 36 N·m (3.7kg-m, 27 ft-lb)
SDIA3181E
1. Baffle plate 2. Breather tube 3. Front case
4. Snap ring 5. Input oil seal 6. Self-lock nut
7. Companion flange 8. Front oil seal 9. 4LO switch (gray with green paint)
10. ATP switch (black) 11. Rear case 12. Wait detection switch (gray)
13. Gasket 14. Filler plug 15. Check ball
16. Check spring 17. Check plug 18. Drain plug
19. O-ring 20. Transfer control device 21. Harness bracket
SDIA3419E