Page 1249 of 3870
FAN CONTROL RELAY CONTINUITY CHEC
K
RADIATOR REMOVAL AND INSTALLATION BATTERY VOLTAGE
TERMINAL NO. TO
BE CONNECTED TO
TESTER
CONTINUITY
TEST RESULTS
Not applied
4-2
Open circuit
Connect terminal No.3 and
battery (-) terminal. Connect
terminal No. 1 and battery (+)
terminal.
4-2
Less than 2 ohms
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1250 of 3870
Fig. 46: Removing/Installing Radiator Components
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1251 of 3870
REMOVAL SERVICE POINTS << A >> RADIATOR UPPER HOSE/RADIATOR
LOWER HOSE DISCONNECTION Make mating marks on the radiator hose and the hose clamp. Disconnect the
radiator hose.
Fig. 47: Disconnecting Radiator Hose
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
<>A/T OIL COOLER HOSE REMOVAL After removing the hose from the radiator, plug the hose and the radiator nipple to prevent dust or forei
gn particles from
gettin
g in.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1252 of 3870
INSTALLATION SERVICE POINT> >A<< RADIATOR LOWER HOSE/RADIATOR
UPPER HOSE CONNECTION 1. Insert each hose as far as the projection of the water inlet fitting.
2. Align the mating marks on the radiator hose and hose clamp, and then connect
the radiator hose.
Fig. 48: Aligning Mating Marks On Radiator Hose And Hose Clamp
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
THERMOSTAT REMOVAL AND INSTALLATION
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1253 of 3870
Fig. 49: Removing/Installing Thermostat Components (1 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1254 of 3870
Fig. 50: Removing/Installing Thermostat Components (2 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
REMOVAL SERVICE POINT << A >> RADIATOR LOWER HOSE DISCONNECTION Make mating marks on the radiator hose and the hose clamp. Disconnect the
radiator hose.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1255 of 3870
Fig. 51: Disconnecting Radiator Lower Hose
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSTALLATION SERVICE POINTS > >A<< THERMOSTAT INSTALLATION Install the thermostat so that the jiggle valve is facing straight up. Be careful not to
fold or scratch the rubber rin
g.
CAUTION: Make absolutely sure that no oil adheres to the
rubber ring of the thermostat. Also do not fold or
scratch the rubber ring during installation.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
Page 1256 of 3870
Fig. 52: Installing Thermostat
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
> >B<< RADIATOR LOWER HOSE CONNECTION 1. Insert each hose as far as the projection of the water inlet fitting.
2. Align the mating marks on the radiator hose and hose clamp, and then connect
the radiator hose.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor
