2004 DACIA SOLENZA remote start

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 36
Diag nostic
THE CONFORMITY CHECKING
N ext, the checking of different states and configurations of the anti starting system is to be
performed.
RECOMMENDATION In case of finding some failures at the diagnostic by means of
the CLIP tester, analyse them based on the diagnostic (ALP)
corresponding to the respective failure.
Crt. Function State/ configuration Obse rvations
Nr. 1. Conformity E.C.U decoder. Computer identification Display of the E.C.U. decoder item.
2. Remote control type 2G = remote control IR = infrared configuration RF = radio frequency
3. Ceiling delayed lamp Without ceiling delayed lamp or Validation on the blue button with ceiling delayed lamp on CLIP screen.
4. Key programming 3G = configuration key With one or 2 keys. programming
5. Configuration petrol/ diesel 3D = configuration coded diesel Without = for petrol engine
electric valve. or diesel without electric
valve.
6. Forced starting protection 9D = forced protecting mode ACTIVE = only after validation on the blue button.
7. Anti starting state 10G = anti starting ACTIVE = with the contact
taken off or after 10 seconds
from th e contact taken off.
8. Key presence 8D = key present ACTIVE at the setting on
the contact if there is a
coded key.
REMARK: the states 8D,
9D, 10 D must be ACTIVE
at a correc t operation.
9. Code key receiving 9D = received key code ACTIVE at the setting on
the contact if the key is
coded in a good format.
10. Correct key code 10D = right key code ACTIVE at the setting on the contact if the key is
coded in a good format and
has the correct code.
REMARK: after the analyse
of the states 8D, 9D, 10 D
the contact will be set on
when the LED indicator
b links ( ACTIVE anti
starting).
vnx.su

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 37
Diag nostic
11. Remote control signal reception. 11G = activate the RF remote ACTIVE for 3 secondscontrol. if the decoder
Received signal indication receives the remote control signal.
12. Remote control signal validation 11D = activate the RF remote ACTIVE for 3 sec. control. if the signal received
Good signal indication at the decoder
is good.
13. Communication doors locking 14G = blocking/unlocking ACTIVE wh en the E.C.U.
switch - E.C.U. decoder. decoder receives control from the
doors’ locking switch.
14. Communication E.C.U .decoder - 14D =activation of the doors ACTIVE when the doors actuators actuators E.C.U. decoder
sends the command
blocking/unlocking to
th e actuators of t he doors.
15. The condition of the doors contact 16G = doors contact ACTIVE when the front doors are opened.
16. Remote controls synchronisation 17G = programming ACTIVE when the
in process or resynchronisation TIR/ TRF remote control resynchronisation
procedure is in process.
17. RF remote controls synchronisation 17D = not performed ACTIVE when the not perfor med TIR programming remote control
synchronisation is not
performed.
18. Not performed key code programming 19G = unperformed key ACTIVE when the
programmingkey programming is
not pe rformed.
19. Validated key code programming 19D = unblocked key ACTIVE when the programming validation of the key
programming is not
performed.
20. The programming of the first key. 18G = the memorising of the ACTIVE when the first key programming of the
fir st key is in process.
vnx.su

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 39
Diagnostic – General
REMARK : the de coder bushing i s not
coded
DISMOUNTING – REMOUNTING
Dismoun t the half-cases under the steering
wheel, extract the bushing from the starting
contact and disconnect its connector.
CONNE CTING

Pin Denomination 1N ot in use
2 Mass
3+ After contact
4 Outlet signal
DESCRIPTION OF THE SYSTEM
By means of this system, the anti-starting is
activated few seconds after the contact has been
taken off (signalized by the blinking of the anti-
starting red indicator).
Its components are :
〈 key-head, equipped with a coded
electronic circuit (A).
OBSERVATION : the anti-starting
electronic is integrated in the remote control
printed circuit.
〈 anti-starting bushing (B), placed around the
ignition-start ing contact, equipped with an
electronic circuit having the purpose of key code
transmitting to the Cockpit Central Unit (UCH).
A
B
vnx.su

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 44
Diagnostic – General
-If doors are unlocked and none of them is
not opened in the next 30 seconds, the system
is automatically re-locking the vehicle doors
(without hazard lights blinking). -Cockpit central Unit is controlling the
vehicle inside lightening. In case a ceiling lamp
still lighted, Cockpit Central Unit is cutting the
supplying after approximately 30 minutes.
- The model “Full equipment” is controlling
the ceiling lamp progressive turning off, after
doors blocking by means of the remote control.
- Cockpit Central Unit may set on the hazard
lights in case of “shock connection” information
coming from UCE airbag.
-S pare parts keys are delivered not coded,
so they have no code.
-I t is possible in case of key’s l oss, theft or
by client’s request, that one vehicle ke y is
decommissioned. This one may be re-assigned
on the same vehicle, if necessary.
ATT E NT ION:
〈〈 〈〈
By this sy stem , i t i s i mp os s ib le th e
replacem ent of Coc kpit Central Unit and
keys in the same time. These parts are sold
not coded. 〈〈〈〈
The code me morized by the system’s
elements can not be erased (Cockpit
Central Unit and injection computer). The
memorized code can not be erased.
GENERAL
Cockpit Central Unit (UCH) is replacing
the UCE decoder.
Cockpit Ce ntral Unit is located under
dashboard, left side.
I MPORTANT
When replacing the Cockpit central Unit
it will be necessary to set the function
correspon ding to the vehicle equipment level,
by means of the CLIP tester.
ATT E NT ION
Starting is impossible unless the anti-
starting programming procedure is
performed.
When replacing a Cockpit Central Unit, it
is necessary to perform the programming and
settin g corresponding to the vehicle equipment
level.
When adding a key it is necessary that keys
re-assignation procedure be performed.
System’s characteristics.
- This system may work with maximum 4
remote controls (Cockpit central unit can
manage only 4 different codes).
-Radio-fr equenc y si gnal receive r i s
integrated in Cockpit Central Unit
-D oors central locking button is not
activated when doors ha ve be en c losed by
means of the remote control.
-Doors locking and unlocking using the
remote control may be visualized by hazard
lights signals (if all doors are properly closed);
- locking : 2 signals
- unlocking: 1 signal
vnx.su