2004 Acura TSX Owner's Manual

Pull the bulb straight out of its
socket.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Push the new bulb straight into
the socket until it bottoms.
Put the inner f ender cover in place.
Install the holding clips. Lock each
oneinplacebypushingonthe
center.
Remove the light assembly cover
by pulling its outside edge.Remove the socket f or that bulb
by turning it one-quarter turn
counterclockwise.
Turn on the parking lights to
make sure the new bulb works.
Open the trunk.
Determine which of the three
bulbs is burned out: brake/
taillight turn signal light or side
marker light.
1.
3.
2.
6.
7.
8.
4.
Replacing Rear Bulbs
(in Fenders)
Lights
Maint enance286
COVER

Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Install the light assembly cover.
Make sure it snaps into place.To replace a bulb on the lef t side,
remove the screws in the center of
each of the two f asteners. On the
right side, remove the screw of the
f astener.
Pull the lining back caref ully.
Turn on the lights to make sure
the new bulb is working.
Open the trunk. Determine which of the two bulbs
is burned out: taillight or back-up
light.
1.
2.
5.
6.
7.
4.
3.
CONT INUED
Replacing Rear Bulbs
(in T runk L id)
Lights
Maint enance287

Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
Turn on the lights to make sure
the new bulb is working.Reinstall the trunk lid trim. Make
sure it is installed under the edge
of the trunk lid seal.
Put each trim clip in the hole on
the trunk lid trim and push on the
center until it locks (the center is
flushwiththehead).
Each outside mirror has side turn
signal lights. The lights should be
replaced by your Acura dealer.
5.
6.
7.
8. 9.
10. Side T urn Signal L ight
Lights
Maint enance288

Open the trunk and remove the
socket f rom the light assembly by
turning it one-quarter turn counter-
clockwise.
Remove the burned-out bulb by
pulling it straight out of the socket.
Install the new bulb and reinstall
the socket. Make sure the new
bulb is working.The license plate has two lights
above it. The bulbs should be
replaced by your Acura dealer.
1. 2.
3. Replacing a High-mount Brake
Light Bulb Rear L icense Plate Bulb
Lights
Maint enance289

Removethelensbycarefully
prying on the edge of the lens with
a f ingernail f ile or a small f lat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens.
Door light:Pry on the top lef t or right of the
lens.
Ceiling light: Pry on the f ront edge of the lens
near both sides.
Spotlights: Pry on the inner edge of both
spotlights. Remove the bulb by pulling it
straight out of its metal tabs.
Push the new bulb into the metal
tabs. Carefully snap the lens back
in place.
The ceiling light, door lights and
vanity mirror lights come apart the
same way, but they do not use the
same type of bulb.
1.
2.
3.
Lights
Maint enance
Replacing Bulbs in the Interior
Lights
290
CEILING LIGHT
BULB SPOTLIGHTS
BULBS

Lights
Maint enance291
BULB
DOOR COURTESY LIGHT
BULB
VANITY MIRROR LIGHT

Pull the bulb straight out of the
holder. Push the new bulb straight
into the holder until it bottoms.Put the light assembly back into
the hole, left side first. Push on
the right side until it snaps into
place.
Open the trunk.
Put a cloth on the right side edge
of the trunk light assembly.
Remove the trunk light assembly
by using a small f lat-tipped
screwdriver to pry caref ully on the
right edge of the assembly.
1.
2. 3.
Replacing the T runk L ight Bulb
Lights
Maint enance292

Block the rear wheels.
Fill the f uel tank.
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc. are
completely dry.
If you need to park your car f or an
extended period (more than one
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your car back on the road. If
possible, store your car indoors.
If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Leave one window open slightly (if
the car is being stored indoors).
Disconnect the battery.
Support the f ront wiper blade
arms with a f olded towel or rag so
they do not touch the windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a car
body wax to the painted surf aces
that mate with the door and trunk
seals.
Change the engine oil and f ilter
(see page ).
Leave the parking brake off. Put
the transmission in Reverse
(manual) or Park (automatic). Coverthecarwitha‘‘breathable’’
cover, one made f rom a porous
material such as cotton.
Nonporous materials, such as
plastic sheeting, trap moisture,
which can damage the paint.
If possible, run the engine f or a
while periodically (pref erably once
amonth).
If you store your car f or 12 months
or longer, have your Acura dealer
perf orm the inspections called f or in
the 24 months maintenance schedule
(Normal Conditions) as soon as you
take it out of storage (see page ).
The replacements called f or in the
maintenance schedule are not
needed unless the car has actually
reached that time or mileage.
246
234
St oring Your Car
Maint enance293