µµÎ
Î
Î
Î
Specif ications
T echnical Inf ormation334
Weights Dimensions
Air Conditioning
Capacities Capacities
1.43 US gal (5.4
)
1.40 US gal (5.3)
Gross vehicle weight rating See the certification label attached to the driver’s doorjamb.
HFC-134a (R-134a)
25 27 oz (700 750 g)
Length
Width
Height
Wheelbase
Track
105.1 in (2,670 mm)
59.6 in (1,515 mm)
59.6 in (1,515 mm) 183.3 in (4,657 mm)
69.4 in (1,762 mm)
57.3 in (1,456 mm)
ND-OIL8
Refrigerant type
Charge quantity
Lubricant type
Fuel tank 1.96 US gal (7.4
)
1.93 US gal (7.3)
4.4 US qt (4.2
)
4.2 US qt (4.0
)
5.6 US qt (5.3
)
2.1 US qt (2.0)
2.3 US qt (2.2)
3.0 US qt (2.8)
6.9 US qt (6.5)
Engine
coolant
Engine oil
Manual trans-
mission oil
Automatic
transmission
fluid
Windshield
washer
reservoir
4.8 US qt (4.5
)
2.6 US qt (2.5)
Including the coolant in the reserve tank and that remaining in the
engine.
Reserve tank capacity: 0.16 US gal (0.6
)
Excluding the oil remaining in the engine.
17.1 US gal (64.7
)
Approx.
Front
Rear
Change
Manual
Automatic
Total Manual
Automatic
Change Including
filter
Without
filter
Total
Change
Total
Change
Total
U.S. Cars
Canada Cars
1:
2:
1
2
µ
The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices and dif f erences in
road characteristics and climate. The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades. Quality grades can be f ound where
applicable on the tire sidewall
between the tread shoulder and the
maximum section width. For
example: The tires on your car meet all U.S.
Federal Saf ety Requirements. All
tires are also graded for treadwear,
traction, and temperature perform-
ance according to Department of
Transportation (DOT) standards.
The f ollowing explains these
gradings.
T echnical Inf ormation
Treadwear Traction AA, A, B, C
T readwear 200
Traction AA
Temperature A
Unif orm T ire Quality Grading
DOT T ire Quality Grading (U.S. Cars)
337
µ
µ
µ
µµ
µ
µ
µµ
µ µ
Whenever tires are replaced, they
should be replaced with tires of the
same size. Following is an example
tire size with an explanation of what
each component means. Vehicletype(Pindicates
passenger vehicle).
Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial). Load index (a numerical code
associated with the maximum
load the tire can carry). Rim diameter in inches.
Speed symbol (an
alphabetical code indicating
the maximum speed rating).
Tire Identif ication Number (TIN) is
a group of numbers and letters that
look like the f ollowing example TIN.
This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.Manuf acturer’s
identification mark.
Tire type code. Date of manuf acture.
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
P
225
55
R 94
V 16
DOT
B97R
FW6X2202
Tire Labeling
Tire Size
T ire Ident if icat ion Number
Tire Inf ormation
T echnical Inf ormation339
P225/55R16 94VDOT B97R FW6X 2202
