2003 LEXUS LS430 replacement

Fig. 11: Removing Bolt And Hook
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
6.REMOVE HOOD SUPPORT ASSY LH (See REPLACEMENT
)
7.REMOVE HOOD SUPPORT ASSY RH
8.REMOVE HOOD LOCK ASSY
a. w/ Pre-collision safety system:
Separate the battery negative (-) terminal.
b. w/ Pre-collision safety system:
Disconnect the connector.
c. w/ Pre-collision safety system:
Remove the 3 bolts and millimeter wave radar sensor.

Fig. 29: Installing Lever With Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is a standard bolt (see STANDARD BOLT ).
1.REMOVE HOOD SUPPORT ASSY LH
a. Remove the 2 bolts and hood support.
HINT:
<00350048005000520059004800030057004b00480003004b005200520047000300560058005300530052005500570003005a004b004c004f004800030056005800530053005200550057004c0051004a00030057004b00480003004b005200520047000300
53004400510048004f0003005a004c0057004b0003005c0052[ur hands.

Fig. 30: Removing Hood Support While Supporting Hood Panel
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2.INSTALL HOOD SUPPORT ASSY LH
a. Install the hood support with the 2 bolts.
Torque: 22 N.m (225 kgf.cm, 19 ft.lbf)
DISPOSAL
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.DISPOSE OF HOOD SUPPORT ASSY LH
a. Remove the support (see REPLACEMENT
).
b. Horizontally fix the support in a vise with the piston-rod pulled out.

Fig. 49: Removing Outer Rear View Mirror Assy LH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
8.REMOVE FRONT DOOR ECU
a. Disconnect the connector.
b. Remove the 2 screws and ECU.
9.REMOVE FRONT NO.1 SPEAKER ASSY (See REPLACEMENT
)
10.REMOVE FRONT DOOR BELT MOULDING ASSY LH (See REPLACEMENT
)
11.REMOVE FRONT DOOR WINDOW FRAME MOULDING REAR LH (See REPLACEMENT
)
12.REMOVE FRONT DOOR WINDOW FRAME MOULDING FRONT LH (See REPLACEMENT
)
13.REMOVE FRONT DOOR GLASS RUN LH
a. Using a drill of less than +/- 4 mm (0.16 in.), drill out the heads of the 5 rivets and remove the glass
run.

Fig. 86: Inspecting Rear Door Panel Sub-Assy LH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
AREA MEASUREMENT REFERENCE STANDARD:
2.ADJUST REAR DOOR PANEL SUB-ASSY LH
a. Disconnect the negative (-) terminal cable from the battery.
b. Remove the front door inside scuff plate (see REPLACEMENT
).
c. Remove the rear door inside scuff plate (see REPLACEMENT
).
d. Remove the center pillar lower garnish (see REPLACEMENT
).
e. Remove the retractor part of the front seat belt (see REPLACEMENT
).
AreaMeasurementAreaMeasurement
A8.0 +/- 1.5 mm (0.315 +/- 0.059 in.)C4.0 +/- 1.5 mm (0.157 +/- 0.059 in.)
B2.5 +/- 1.5 mm (0.098 +/- 0.059 in.)D4.0 +/- 1.5 mm (0.157 +/- 0.059 in.)

Fig. 103: Removing Remaining Tape On Door Side
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
8.REMOVE REAR DOOR ECU
a. Remove the 2 screws and ECU.
9.REMOVE REAR SPEAKER ASSY NO.2 (See REPLACEMENT
)
10.REMOVE REAR SPEAKER ASSY (See REPLACEMENT
)
11.REMOVE REAR DOOR BELT MOULDING ASSY LH (See REPLACEMENT
)
12.REMOVE REAR DOOR WINDOW FRAME MOULDING FRONT LH (See REPLACEMENT
)
13.REMOVE REAR DOOR WINDOW FRAME MOULDING UPPER LH (See REPLACEMENT
)
14.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSY LH
a. Remove the 2 nuts, bolt and division bar.

Fig. 148: Removing Luggage Compartment Door Assist Grip
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
7.REMOVE REAR LAMP ASSY LH (See OVERHAUL
)
8.REMOVE REAR LAMP ASSY RH
9.REMOVE LICENSE PLATE LAMP LENS (See REPLACEMENT
)
10.REMOVE LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSY OUTSIDE (See
REPLACEMENT
)
w/ Smart key system:
11.REMOVE LUGGAGE ELECTRICAL KEY SWITCH
a. Disconnect the connector.
b. Remove the 2 nuts and key switch.
12.w/o Smart key system:
REMOVE LUGGAGE ELECTRICAL KEY SWITCH COVER
a. Remove the 2 nuts and cover.

Fig. 153: Removing Luggage Door Closer Assy
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
17.REMOVE LUGGAGE COMPARTMENT DOOR SUPPORT ASSY (See REPLACEMENT
)
18.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
a. Remove the 4 bolts and 4 luggage compartment trim hooks No. 1.
b. Remove the mat.
c. Remove the 2 clips and 2 deck side trim boards.