2002.5 Peugeot 307 Break Owner's Manual

09-09-2002
CHANGING A BULB
Front lights
Note:on the right–hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the
bulbs with a dry cloth.
1 Dipped beam headlamps (H755W).
2 Main beam headlamps (H155W).
3 Front fog lamps (H155 W). Turn the protective cover corresponding to the faulty
bulb a quarter of a turn and remove it.
Disconnect the connector.
Press the end of the securing clip to free it. Change the
bulb.
When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing clip
is fixed properly.
Reconnect the connector.
Refit the protective cover, positioning it with the arrow
upwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with a
protective coating.
Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product. Use
a sponge and soapy water.
4 Side lights W 5 W. Pull the socket rearwards, remove the bulb and change
it.
5 Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
Change the bulb.
Note : In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
PRACTICAL INFORMATION
148

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
PRACTICAL INFORMATION
150
Number plate lights
(W 5 W) Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.

Remove the bulb holder pressing
on the tabs A,
Change the faulty bulb.
Note: f necessary, use the wheel
brace to remove the nuts.
When refitting, take care to position
the bulb holder and the light correct
ly. Third brake light (saloon)
4 W 5 W bulbs
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direc
tion of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
When refitting, ensure that the
light unit tabs are engaged cor
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1 Brake lights (P 21 W).
2 Side lights (R 5 W).
3 Direction indicators (P 21 W).
4 Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by
removing the light: Remove the light fixing nut inside
the boot,
Remove the light fixing nut out
side the boot,
Remove the light,
Unclip the harness,

09-09-2002
PRACTICAL INFORMATION
150
Number plate lights
(W 5 W) Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.

Remove the bulb holder pressing
on the tabs A,
Change the faulty bulb.
Note: f necessary, use the wheel
brace to remove the nuts.
When refitting, take care to position
the bulb holder and the light correct
ly. Third brake light (saloon)
4 W 5 W bulbs
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direc
tion of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
When refitting, ensure that the
light unit tabs are engaged cor
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1 Brake lights (P 21 W).
2 Side lights (R 5 W).
3 Direction indicators (P 21 W).
4 Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by
removing the light: Remove the light fixing nut inside
the boot,
Remove the light fixing nut out
side the boot,
Remove the light,
Unclip the harness,

CHANGING A FUSE
The fuse boxes are located under
the fascia (left hand side) and in the
engine compartment.
The spare fuses and special pliers A
are fixed to the inside of the lid of the
fascia panel fuse box.
Removing and changing a
fuse
Before changing a fuse you must find
out the cause of the fault and have it
corrected. The fuse numbers are
indicated on the fuse box. Use the special pliers A.
Always change a faulty fuse for
one of the same rating. Fascia fuses
Unscrew the bolt a quarter of a
turn with a coin, then pull the
handle to open the cover and
access the fuses.
PRACTICAL INFORMATION 151
Fuse N° Rating Functions
1 10 A Rear fog lamp.
2 15 A Rear screen wiper.
4 15 A Front electric window/sunroof.
5 15 A Left brake light including trailer.
7 20 A Rear courtesy light, front courtesy light, map readers
Lighter 12 V front socket Glove box lighting.
Correct
PliersAIncorrect
09-09-2002

09-09-2002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery): unclip the cover.
Carefully close the cover and refit
the style cover when you have fin
ished.
PRACTICAL INFORMATION 153
The electrical system of
your vehicle is designed to
operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes.
* The maxifuses provide addi tional protection for the electrical
systems. All work must be car
ried out by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 30 A Fan unit.
2* 30 A ESP/ABS pump motor.
3* 30 A ESP/ABS solenoid valves.
4* 60 A Builtin Systems Interface supply.
5* 70 A Builtin Systems Interface supply.
6* — Not used.
7* 30 A Ignition switch, power.
8* 70 A Power steering electropump unit.

09-09-2002
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch Automatic gearbox starting inhibitor relay
control Manual gearbox reversing lights switch Vehicle speed sen sor
Water in diesel sensor.
2 15 A Canister solenoid valve Fuel pump.
3 10 A Power steering control unit ABS or ESP control unit.
4 10 A Injection control unit Fan unit relay control Additional heating relay control
Automatic gearbox control unit Automatic gearbox sequential cont rol
Automatic gearbox shiftlock relay.
5 15 A Particulate emission filter control unit.
6 15 A Front fog lamps.
7— Not used.
8 20 A Fan unit relay control Engine management control unit supply
Injection pump (Diesel).
9 15 A Left dipped beam.
10 15 A Right dipped beam.
11 10 A Right main beam.
12 10 A Left main beam.
13 15 A Horn.
14 10 A Front and rear headlamp wash pump.
15 30A Oxygen sensors Exhaust gas recirculation solenoid valve Ignition co il
Diesel high pressure regulator Injectors supply (petrol) Preheat co ntrol unit
Air flow sensor (Diesel) Engine management control unit (Diesel)
Injection pump (Diesel) Diesel heater.
16 40A Petrol engine air pump with automatic gearbox.
17 30A Front wiper low/high speed.
18 40A Air conditioning blower.
PRACTICAL INFORMATION
154