2001 TOYOTA SEQUOIA Back Seat

05_SEQUOIA_U (L/O 0408)
11 9
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Move seat fully back
CAUTION

A forward±facing child restraint sys-
tem should be allowed to be
installed on the front passenger
seat only when it is unavoidable.
Always move the seat as far back
as possible even if the front pas-
senger occupant classification indi-
cator light indicates ªOFFº, because
the front passenger airbag could in-
flate with considerable speed and
force. Otherwise, the child may be
killed or seriously injured.

On vehicles with side airbags and
curtain shield airbags, do not allow
the child to lean his/her head or
any part of his/her body against the
door or the area of the seat, front
or rear pillar or roof side rail from
which the side airbags or curtain
shield airbags deploy even if the
child is seated in the child restraint
system. It is dangerous if the side
airbag and curtain shield airbag in-
flate, and the impact could cause
death or serious injury to the child.
Same angle
Same position

When installing a child restraint
system in the third seat center
position, adjust both seat cushions
to the same position and align both
seatbacks at the same angle. Other-
wise, the child restraint system can-
not be securely restrained and this
may cause death or serious injuries
in a collision.

05_SEQUOIA_U (L/O 0408)
125
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
Anchor brackets Symbol mark
Use the anchor brackets on the back of
the third seats to attach the top strap.
Anchor bracket is installed for right side
and center seating positions.
This symbol indicates the locations of
user ready anchor bracket.TO USE THE ANCHOR BRACKET (right
side):
1. Remove the head restraint.
Ð U sin g a to p st rap
(for third seats)

05_SEQUOIA_U (L/O 0408)
129
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Most upright
position
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Fold down the seatback and back to
the most upright position until it
locks into place.
Make sure the seatback is locked secure-
ly.
Canada onlyCovers Cap
Ty p e ACanada onlyCovers Cap
Ty p e B

05_SEQUOIA_U (L/O 0408)
131
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Most upright
position
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Fold down the seatback and back to
the most upright position until it
locks into place.
Make sure the seatback is locked secure-
ly.
Canada onlyCovers
Ty p e ACanada onlyCovers
Ty p e B

05_SEQUOIA_U (L/O 0408)
132
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
2. Turn up the covers for the lower an-
chorages. Confirm the position of
the lower anchorages below the but-
ton on the cover.
3. Type AÐLatch the hooks of lower
straps onto the anchorages and
tighten the lower straps.
Type BÐLatch the buckles onto the
anchorages.
For owners in CanadaÐThe symbol on
a child restraint system indicates the pres-
ence of a lower connector system.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see ªÐUsing
a top strap (for separate type second
seats)º on page 123 in this section.)
For installation details, refer to the instruc-
tion manual equipped with each product.CAUTION

When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.

Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.

After securing the child restraint
system, never slide or recline the
seat.

Do not install a child restraint sys-
tem on the second seat if it inter-
feres with the lock mechanism of
the front seats. Otherwise, the child
or front seat occupant(s) may be
killed or seriously injured in case
of sudden braking or a collision.
Lower anchorages for the child restraint
systems complying with the FMVSS225
or CMVSS210.2 specifications are
installed in the right side position of
the third seats.
The anchorages are installed in the clear-
ance between the seat cushion and seat-
back for right side position of the third
seats.
Child restraint systems complying with the
FMVSS213 or CMVSS213 specification
can be fixed to these anchorages. In this
case, it is not necessary to fix the child
restraint system with a seat belt on the
vehicle.
ÐInstallation with child
restraint lower anchorages
(for third seats)

05_SEQUOIA_U (L/O 0408)
133
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Most upright
position
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Fold down the seatback and back to
the most upright position until it
locks into place.
Make sure the seatback is locked secure-
ly.
Canada only Covers
Ty p e ACanada only Cover
Ty p e B

05_SEQUOIA_U (L/O 0408)
134
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
2. Turn up the cover for lower anchor-
ages of the right side position. Con-
firm the position of the lower an-
chorages below the button on the
cover.
3. Type AÐLatch the hooks of lower
straps onto the anchorages and
tighten the lower straps.
Type BÐLatch the buckles onto the
anchorages.
For owners in CanadaÐThe symbol on
a child restraint system indicates the pres-
ence of a lower connector system.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see ªÐUsing
a top strap (for third seats)º on page 125
in this Section.)
For installation details, refer to the instruc-
tion manual equipped with each product.CAUTION

When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.

Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.

When using lower anchorages for a
child restraint system on the third
seats, ensure that the seat is
moved to the rear±most position,
with the seatback close to the child
restraint system.

After securing the child restraint
system, never slide or recline the
seat.

Do not install a child restraint sys-
tem on the third seat if it interferes
with the lock mechanism of the sec-
ond seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.

05_SEQUOIA_U (L/O 0408)
168
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
In the following cases, contact your Toyota
dealer:

The warning light does not come on
after the ignition key is turned to ªONº.

The warning light remains on after the
ignition key is turned to ªONº.

The warning light comes on while driv-
ing.
(i) Open Door Warning Light
This light remains on until all the side
doors and back door are completely
closed.
(j) SRS Warning Light
This light will come on when the igni-
tion key is turned to the ªONº position.
After about 6 seconds, the light will go
off. This means the system of the air-
bag and front seat belt pretensioner are
operating properly.This warning light system monitors the
airbag sensor assembly, front airbag sen-
sors, side and curtain shield airbag sen-
sors, curtain shield airbag sensors, driv-
er 's seat position sensor, driver 's seat belt
buckle switch, front passenger occupant
classification system and indicator light,
front passenger 's seat belt buckle switch,
seat belt pretensioner assemblies, inflat-
ors, warning light, ªRSCA OFFº indicator
light, interconnecting wiring and power
sources.
If either of the following conditions occurs,
this indicates a malfunction somewhere in
the parts monitored by the warning light
system. Contact your Toyota dealer as
soon as possible to service the vehicle.

The light does not come on when the
ignition key is turned to the ªONº posi-
tion or remains on for more than 6
seconds.

The light comes on while driving.(k) Automatic Transmission Fluid Tem-
perature Warning Light (four±wheel
drive models)
This light warns that the automatic trans-
mission fluid temperature is too high.
If this light comes on while you are driv-
ing, slow down and pull off the road. Stop
the vehicle at a safe place and put the
selector lever in ªPº. With the engine id-
ling, wait until the light goes off. If the
light goes off, you may start the vehicle
again. If the light does not go off, call a
Toyota dealer or qualified repair shop for
assistance.
NOTICE
Continued driving with the warning
light on may damage the automatic
transmission.