2001 TOYOTA SEQUOIA height

05_SEQUOIA_U (L/O 0408)
170
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
CHECKING SERVICE REMINDER
INDICATORS (except the low fuel level
warning light and low windshield
washer fluid level warning light)
1. Apply the parking brake.
2. Open one of the side doors or back
door.
The open door warning light should
come on.
3. Close the door.
The open door warning light should go
off.
4. Turn the ignition key to ªONº, but do
not start the engine.
All the service reminder indicators ex-
cept the open door warning light should
come on. The ªABSº and ªVSC TRACº
warning lights, low tire pressure warn-
ing light and engine oil replacement
reminder light go off after a few sec-
onds. The SRS warning light goes off
after about 6 seconds. (The ªTRAC
OFFº (two±wheel drive models) or
ªVSC OFFº (four±wheel drive models),
ªRSCA OFFº indicator lights, height
control indicator light, manual control
mode indicator light and slip indicator
light also come on and go off after a
few seconds.)If any service reminder indicator or warn-
ing buzzer does not function as described
above, have it checked by your Toyota
dealer as soon as possible.

05_SEQUOIA_U (L/O 0408)
171
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
OPERATION OF INSTRUMENTS AND
CONTROLS
Ignition switch, Transmission and Parking brake
Ignition switch with steering lock172 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Automatic transmission173 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Four±wheel drive system177 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Traction control system182 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Active traction control system184 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Vehicle stability control system186 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear height control air suspension189 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tire pressure warning system198 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parking brake204 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cruise control205 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SECTION 1± 7

05_SEQUOIA_U (L/O 0408)
189
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
1: Mode select switch
2: Height select switch
This rear height control air suspension
controls the vehicle height depending
on vehicle driving conditions.
You can choose automatic control mode
or manual control mode. In automatic
control mode, you can select the ve-
hicle height between ªHIº (high), ªNº
(normal) and ªLOº (low) modes with the
height select switch. In manual control
mode, you can adjust the vehicle height
seamlessly with the height select
switch.
To change the mode between automatic
control mode and manual control mode,
use the mode select switch.The vehicle height is automatically ad-
justed to a selected height mode. Howev-
er, when the front drive control is in ª4LOº
mode, the vehicle height cannot be ad-
justed automatically even if the vehicle
condition changes, but height mode can
be changed manually with the height se-
lect switch.
(a) Vehicle height modes
ªNº (normal) modeÐ
The vehicle height in this mode is stan-
dard. Regardless of the number of occu-
pants or the luggage loading condition, the
vehicle height is always automatically ad-
justed to a fixed height in this mode while
the engine is running.
This mode is suitable for ordinary driving.
ªHIº (high) modeÐ
The vehicle height is about 40 mm (1.6
in.) higher at rear than ªNº mode height.
This mode is suitable when driving on
bumpy roads and through water.
However, when the vehicle speed exceeds
30 km/h (18 mph) in ªHIº mode, ªNº mode
is automatically selected.
CAUTION
ªHIº mode should be only used for
severe off±road driving conditions.
Because the vehicle's center of gravi-
ty is higher in this setting, the ve-
hicle may become unstable when
turning abruptly, resulting in an acci-
dent.
Rear height control air
suspensionÐÐAutomatic control mode

05_SEQUOIA_U (L/O 0408)
190
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
ªLOº (low) modeÐ
Two±wheel drive modelsÐThe vehicle
height is about 15 mm (0.6 in.) lower at
rear than ªNº mode height.
Four±wheel drive modelsÐThe vehicle
height is about 30 mm (1.2 in.) lower at
rear than ªNº mode height.
This mode allows for easy access to the
vehicle (getting in and out) and easy load-
ing and unloading.
This mode is available when the vehicle
speed is 12 km/h (7 mph) or less.
NOTICE
Use ªLOº mode when the vehicle is
stopped. Otherwise, when the vehicle
speed exceeds 12 km/h (7 mph), ªNº
mode is selected automatically. Prop-
er caution should be taken in places
where the overhead height is limited.
(b) Vehicle height mode changing con-
dition
To change the vehicle height, it is neces-
sary to meet the following conditions.

The engine should be running.

The manual control mode indicator light
should go off.

When selecting a mode, there is a ve-
hicle speed limit. Refer to the following
table.
Yes = The mode can be selected.
No = The mode cannot be selected.
ªLOº
modeªNº
modeªHIº
mode
12 km/h
(7 mph) or
less
Ye sYe sYe s
30 km/h
(18 mph) or
less
NoYe sYe s
Over
30 km/h
(18 mph)
NoYe sNo
However, when you are driving on bumpy
roads, which may cause the suspension to
fully elongate, the rear height control air
suspension may not operate.
If the vehicle height is adjusted on the
slope, or with the selector lever in a posi-
tion other than ªPº or ªNº while the vehicle
is stopped, you may hear a sound caused
by the expansion and contraction of the
propeller shaft. This does not indicate a
malfunction.

05_SEQUOIA_U (L/O 0408)
191
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
(c) Vehicle height adjustment
To change the mode, push the height
select switch on either side of ª
º
(higher) or ªº (lower).
The height control indicator light indicates
which mode is selected. (See ª(d) Indica-
tor lightsº described below.)
Selecting ªHIº modeÐ
Push the height select switch on the ª
º
side when the vehicle speed is 30 km/h
(18 mph) or less.
To change ªNº mode to ªHIº, push the
switch once.To change ªLOº mode to ªHIº, push the
switch twice.
Selecting ªNº modeÐ
To change ªHIº mode to ªNº, push the
height select switch on the ªº side once.
If the underbody of the vehicle has
touched the surface on bumpy roads, the
vehicle height cannot be lowered with the
height select switch.
To change ªLOº mode to ªNº, push the
height select switch on the ª
º side once.
Selecting ªLOº modeÐ
Push the height select switch on the ªº
side while the vehicle is stopped.
To change ªNº mode to ªLOº, push the
switch once.
To change ªHIº mode to ªLOº, push the
switch twice.
If the underbody of the vehicle has
touched the surface on bumpy roads, the
vehicle height cannot be lowered with the
height select switch.Even if the engine is stopped while the
vehicle height is being lowered, the opera-
tion continues for up to 35 seconds. If,
within this 35 seconds, any of the side
doors or the back door is opened, opera-
tion will continue for a further 15 seconds.
When adjusting the vehicle height with
one or more doors open, make sure that
there is nothing that might come into con-
tact with the vehicle body or around the
doors.

05_SEQUOIA_U (L/O 0408)
192
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
NOTICE

If the vehicle height is changed fre-
quently when the vehicle is heavily
loaded, the compressor may over-
heat, causing the vehicle height ad-
justment operation to stop.

Before you lower the vehicle height
with the height select switch, check
under the vehicle to make sure
nothing to damage the vehicle or
no one to be injured is there and
that the underbody of the vehicle
does not touch the ground.

After unloading, the height of a ve-
hicle equipped with the rear height
control air suspension becomes
slightly higher than the normal ve-
hicle height. Take sufficient care
where the overhead height is re-
stricted.

Do not select ªLOº mode for bumpy
roads. If the underbody of the ve-
hicle touches the road surface, the
vehicle may be damaged.
If you attempt to adjust the vehicle height
with anything such as snow, ice, or stones
in contact with the vehicle body, the ve-
hicle height may not change. In this case,
stop the vehicle, press the mode select
switch, and check that manual control
mode indicator light comes on. Then, re-
move the obstruction.
CAUTION
If you drive through water, set the
vehicle height to ªHIº with the height
select switch and then change to
manual control mode by pushing the
mode select switch. Do not exceed 30
km/h (18 mph) or ªHIº mode will au-
tomatically change to ªNº mode. Do
not drive through water deeper than
about 700 mm (28 in.) even if the
vehicle height is in ªHIº mode.
NOTICE

When jacking up or installing tire
chains, be sure to set manual con-
trol mode by pushing the mode se-
lect switch and stop the engine.
Otherwise, the vehicle height may
change because of the automatic
leveling function, resulting in an ac-
cident.

If your vehicle must be towed, set
the vehicle height to ªNº and
change to manual control mode.
Otherwise, the vehicle height may
change because of the automatic
leveling function, resulting in an ac-
cident.

If your vehicle gets stuck in a
ditch, set manual control mode by
pushing the mode select switch.
Otherwise, the vehicle height may
change because of the automatic
leveling function, resulting in an ac-
cident.

05_SEQUOIA_U (L/O 0408)
193
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
(d) Indicator lights
1. Height control indicator lights
2. Manual control mode indicator light
When the ignition switch is turned on, all
the indicator lights come on. The indicator
light showing the present mode only re-
mains on and all other lights go off after
a few seconds. This means the system
operates correctly.If you change the vehicle height mode,
the indicator lights change as follows:
When changing the vehicle height from
ªNº mode to ªHIº:
1. The ªNº mode indicator light goes off
and the ªHIº mode indicator light blinks.
2. After the vehicle height control reaches
ªHIº mode, the ªHIº mode indicator light
remains on.If the underbody of the vehicle has
touched the surface on bumpy roads or
the area around the rear suspension is
coated with ice, the vehicle height cannot
be changed with the height select switch.
In this case, move the vehicle or remove
the ice around the rear suspension. The
vehicle height will change to the selected
mode, after a while, when the ignition
switch is turned to the ªONº position.
In the following cases, there is a problem
somewhere in you rear height control air
suspension. Although there is no problem
to continue normal driving, have the rear
height control air suspension checked by
your Toyota dealer as soon as possible.

The height control indicator light and
manual control mode indicator light do
not come on when the ignition switch
is turned on.

The manual control mode indicator light
blinks.

05_SEQUOIA_U (L/O 0408)
194
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
(e) Parking and stopping tips
If you immediately stop the engine to park
the vehicle after off±road driving, the ve-
hicle height is lowered slightly as the ve-
hicle becomes cool. When parking, make
sure there is nothing that will be in con-
tact with the underbody of the vehicle.
When you start the engine, the vehicle
returns to the previous height.
If you park the vehicle for a long time,
the vehicle height may be gradually low-
ered. When parking for a long time, make
sure there is nothing that will be in con-
tact with the underbody of the vehicle.
When you start the engine, the vehicle
returns to the previous height.
If you stop the engine, the vehicle height
may change in accordance with the
change in the temperature. When you
start the engine, the vehicle returns to the
previous height.(f) Rear height control failure warning
If there is a problem somewhere in the
rear height control air suspension, ªNº
mode is automatically selected. If this oc-
curs, the manual control mode indicator
light blinks and the vehicle height control
cannot be activated until the malfunction
is corrected. If this is the case, bring your
vehicle to your Toyota dealer as soon as
possible and have it checked.
(a) Selecting manual control mode
To select manual control mode, push
the mode select switch with the vehicle
stopped. The manual control mode indi-
cator light comes on and the vehicle
height is fixed at the current height.
The height can be adjusted by pushing
the height select switch.
The selected height is memorized in the
system even after the engine is stopped.
If you push the mode select switch again,
the manual control mode indicator light
goes out and automatic control mode is
selected.
ÐManual control mode