BO3TB±01
H15446
Passenger Airbag Assembly
Front Pillar Garnish
No. 2 Side Defroster Nozzle
No. 3 Register
Cluster Finish
Panel
Front Pillar
Garnish
Combination Meter
No. 1 Side Defroster Nozzle
Instrument Panel
No. 1 Register
Instrument Panel
Reinforcement
Upper Column Cover
Spiral Cable
Lower Column Cover
Lower Finish Panel
Front Door Scuff Plate
Cowl Side
TrimHood Lock Release LeverFront Door
Scuff Plate
Rear Console Box
Console Compartment
Door
Lower Center
Cluster Finish Panel
Glove Compartment
Door
Cowl Side Trim
Steering Wheel
Steering Wheel Pad
Finish Panel
No. 1 BraceCluster Finish
Panel Assembly
Radio Tuner Opening Cover
Hazard Warning Switch
N´m (kgf´cm, ft´lbf)
: Spesified torque
A
A
B
BNNC
HH
G
GG
G
D
D
II
G
G
D
D
I
O
50 (510, 37)
20 (204, 15)
KK
w/ Glove compartment door reinforcement:
Glove Compartment Door Reinforcement
L
L
HH
LL
EE
FF
± BODYINSTRUMENT PANEL
BO±59
1844 Author: Date:
2001 PRIUS (RM778U)
INSTRUMENT PANEL
COMPONENTS
BO3TC±01
H154373 Clips
H154384 Clips
H15519
BO±62
± BODYINSTRUMENT PANEL
2001 PRIUS (RM778U)
REMOVAL
1. REMOVE STEERING WHEEL PAD AND STEERING
WHEEL (See page SR±4)
2. REMOVE FRONT DOOR SCUFF PLATES
3. REMOVE COWL SIDE TRIMS
4. REMOVE FRONT PILLAR GARNISHES
5. REMOVE LOWER FINISH PANEL
(a) Remove the 2 screws and hood lock release lever.
(b) Zip the shifting hole cover open.
(c) Remove the bolt and screw.
(d) Using a screwdriver, remove the lower finish panel, then
disconnect the connectors and DLC3.
(e) Remove the shifting hole cover from the lower finish pan-
el.
6. REMOVE FINISH PANEL
7. REMOVE COLUMN COVERS (See page SR±4)
8. REMOVE SPIRAL CABLE (See page SR±4)
9. REMOVE GLOVE COMPARTMENT DOOR
(a) Rotate the stoppers of the glove compartment door to 90°
and pull them out inward.
(b) Remove the 2 screws and glove compartment door.
(c) Remove the 2 screws and glove compartment door lock
from the glove compartment door.
10. REMOVE LOWER CENTER CLUSTER FINISH PANEL
(a) Remove the 2 clips.
(b) Using a screwdriver, remove the lower center cluster fin-
ish panel.
HINT:
Tape the screwdriver tip before use.
(c) Disconnect the connector.
11. w/ Glove compartment door reinforcement:
REMOVE GLOVE COMPARTMENT DOOR RE-
INFORCEMENT
12. DISCONNECT PASSENGER AIRBAG CONNECTOR
(a) Disconnect the passenger airbag connector.
NOTICE:
When disconnecting the airbag connector, take care not to
damage the airbag wire harness.
(b) Disengage the airbag connector clamp from the center
bracket.
