2000 TOYOTA CAMRY fog light

CAMRY ± NEW FEATURES
No.4 INJECTOR
SPARK PLUGSIGNITERS and
IGNITION COILS
No.2 INJECTOR
No.1 INJECTOR
No.3 INJECTOR
SENSORS ACTUATORS
MANIFOLD ABSOLUTE
PRESSURE SENSORSFI PIM#10+
CRANKSHAFT POSITION
SENSORNE
CAMSHAFT POSITION
SENSORG
ENGINE COOLANT TEMP.
SENSORTHW
INTAKE AIR TEMP. SENSORTHA
THROTTLE POSITION SENSORVTA
COMBINATION METER
SPD
Vehicle Speed Signal
AIR FUEL RATIO SENSOR
(Bank 1, Sensor 1)AF
HEATED OXYGEN SENSOR
(Bank 1, Sensor 2)OX2
POWER STEERING OIL
PRESSER SWITCHPSW
TAILLIGHT & REAR WINDOW
DEFOGGER SYSTEMELS
IGNITION SWITCHSTA
PARK / NEUTRAL POSITION
SWITCHNSW
STOP LIGHT SWITCHSTP
AIRBAG SENSOR ASSEMBLY
F/PS
Fuel Cut-Off Signal
#10
#20+
#20
#30+
#30
#40+
#40
ESA
IGT1,
IGT2
IGF
CONTROL VALVEIACRSD
VSV EGREGR
AIR FUEL RATIO SENSOR
HEATER AIR FUEL RATIO SENSOR
HEATER CONTROLHTAF
HEATED OXYGEN SENSOR
HEATER OXYGEN SENSOR HEATER
CONTROLHT2
MAGNET CLUTCH RERAYAIRE CONDITIONING
CUT-OFF CONTROLMGC
FUEL GAGE
LOW FUEL LEVEL WARNING
LIGHT
ECM
AIR CONDITIONING SWITCHA/C SW
R, 2, L
FUEL
FUEL W
50
Construction
The configuration of the engine control system in the 5S-FNE engine is as shown in the following chart.
(Continued)

2. Except Delco Battery:
CHECK BATTERY VOLTAGE AND SPECIFIC
GRAVITY
A. Maintenance Free Battery
Measure the battery voltage between the terminals
negative (±) and positive (+) of the battery.
Standard voltage:
12.7 ± 12.9 V at 205C (685F)
HINT:
wBefore measuring the voltage, turn the ignition
switch to LOCK and turn off the electrical sys±
tems (headlight, blower motor, rear defogger etc.)
for 60 seconds to remove the surface charge.
wIf the vehicle has been running, wait 5 minutes or
more after the vehicle stops before measuring
the battery voltage.
If the voltage is less than specification, charge the
battery.
HINT: Check the indicator as shown in the illustration. 1. Except Delco Battery:
CHECK BATTERY ELECTROLYTE LEVEL
Check the electrolyte quantity of each cell.
A. Maintenance Free Battery
If under the lower level, replace the battery (or add
distilled water if possible). Check the charging system.
B. Except Maintenance Free Battery
If under the ªLOWERº or ªMINº line, add distilled
water.
BATTERY INSPECTION
± 5S±FE ENGINEENGINE MECHANICALEG1±9

wManifold absolute pressure sensor
wThrottle position sensor Manifold absolute pressure sensor
wDefogger relay
wTaillight relay Engine coolant temp. sensorData link connector 1 and 2
Data link connector 1 and 2Malfunction indicator lamp Injectors (No.2 and No.4)
No.1 vehicle speed sensorThrottle position sensor
Throttle position sensorIntake air temp. sensorEG R gas temp. sensor
Circuit opening relay
Main oxygen sensor
Data link connector 1Sub oxygen sensor Terminal
No.Terminal
No.
A/C amplifier
EFI main relayEFI main relay Sensor ground
Sensor groundA/C amplifier
Power ground
ECM groundConnection Connection
VSV for EG R
Knock sensorSymbol Symbol
Battery Igniter
± 5S±FE ENGINETERMINALS OF ECMEG1±319

*
: Only for California specification vehicles.
*: Except California specification vehicles with A/T.wStoplight switch
w Stoplight
w Park/neutral position switch wDefogger relay
wTaillight relay
Park/neutral position switchPark/neutral position switch
Park/neutral position switch
Malfunction indicator lampData link connector 1 and 2 Data link connector 1 and 2No.1 vehicle speed sensor
Throttle position sensor
Throttle position sensorEGR gas temp. sensor
Circuit opening relay Data link connector 1Data link connector 2
Cruise control ECUO/D main switch Terminal
No.Terminal
No.Connection
A/C amplifier
EFI main relay Sensor ground
Sensor ground
A/C amplifierEFI main relay
Knock sensorStarter relay Connection Symbol
Symbol
Battery
± 5S±FE ENGINETERMINALS OF ECMEG1±321

Parts NameCode
Front Bumper CoverTSOP
Radiator Grille (Models Except USA & CANADA)ABS
Headlight (For USA & CANADA)PC/PP
Front Turn Signal LightPMMA/ASA
Front Fog Light (Models Except USA & CANADA)PC/PP
Side Turn Signal Light (Models Except USA & CANADA)SAN/AAS
Outer Rear View MirrorABS
Outside Handle (Front, Rear)PC/PBT
Front Fender Outside MouldingPVC
Door Outsider Moulding (Front, Rear)PVC
Quarter Panel Outside Moulding (Front, Rear) (For Europe)PVC
Front Fender Mudguard (For USA & CANADA)PP/PMMA
Front Fender Mudguard (Models Except USA & CANADA)PP/EPDM
Quarter Panel Mudguard (For USA & CANADA)PP/PMMA
Quarter Panel Mudguard (Models Except USA & CANADA)PP/EPDM
Rear Bumper Cover (For USA & CANADA)PUR
Rear Bumper Cover (Models Except USA & CANADA)TSOP
Rear Combination Light (For USA & CANADA) PMMA/ASA
PMMA/ABS/PC
Rear Combination Light (Models Except USA & CANADA)PMMA/ASA
Licence Plate LightPC
Back±up Light (Rear Light)PMMA/ASA
LOCATION OF PLASTIC BODY PARTS
HINT:

Resin material differs with model.
/ Made up of 2 or more kinds of materials.
PLASTIC BODY PARTSPP-4

CAMRY ± NEW FEATURES
BATT
BATTERY
PS
IMLD
EGR
EVP1
TPC
W
ELS
STP
PTNK
TRC
TXCT
KSW
TC
SIL
EFI MAIN RELAY
+B
EFI ELS2 POWER STEERING OIL
PRESSURE SWITCH
TAILLIGHT & REAR WINDOW
DEFOGGER
STOP LIGHT SWITCH
VAPOR PRESSURE SENSOR
ABS & TRAC ECU*
1
TRANSPONDER KEY
AMPLIFIER*2
UNLOCK WARNING SWITCH*2
DATALINK CONNECTOR 1
DATALINK CONNECTOR 3EGR CONTROL
VSV
EVAP CONTROL
VSV
VAPOR PRESSURE CONTROL
VSV
THEFT DETERRENT INDICATOR
LIGHT*2
MALFUNCTION INDICATOR
LAMP
HTSOXYGEN SENSOR HEATER
CONTROL
HEATED OXYGEN SENSOR
HEATER (Bank 1, Sensor 2)
RXCK
CODE
12
*1: Applicable only to vehicles equipped with the TRAC System.
*
2: Applicable only to vehicles equipped with the Engine Immobiliser System.

'99camry U
3
1. Power rear view mirror control switch
2. Headlight and turn signal switch
3. Wiper and washer switches
4. Clock
5. Emergency flasher switch
6. Car audio
7. Rear window and outside rear view
mirror defoggers switch
8. Air conditioning controls
9. Front ashtray
10. Power outlet
11. Cigarette lighter
12. Ignition switch
13. Cruise control switch
14. Tilt steering lock release lever
15. Traction control system off switch
16. Instrument panel light control knob

'99camry U
79
Part 1
OPERATION OF
INSTRUMENTS AND
CONTROLSÐ
Chapter 1±4
Lights, Wipers and
Defogger

Headlights and turn signals

Emergency flashers

Instrument panel light control

Interior light

Ignition switch light

Personal light

Windshield wipers and washer

Rear window and outside
rear view mirror defoggers
Headlights and turn signals
HEADLIGHTS
To turn on the following lights: Twist
the headlight/turn signal lever knob.
Position 1ÐParking, tail, license plate,
side marker and instrument panel lights
Position 2ÐHeadlights and all of the
above
The lights automatically turn off when the
driver 's door is opened with the ignition
turned off. To turn them on again, turn the
key to the ºONº position or actuate the
headlight switch. If you are going to park
for over one week, make sure the head-
light switch is off.
NOTICE
To prevent the battery from being dis-
charged, do not leave the lights on
for a long period when the engine is
not running.
Daytime running light system
The headlights turn on at reduced intensi-
ty when the parking brake is released with
the engine started, even with the light
switch in the ºOFFº position. They will not
go off until the ignition switch is turned
off.
To turn on the other exterior lights and
instrument panel lights, twist the knob to
the position 1.
Twist the knob to the position 2 to turn
the headlights to full intensity for driving
at night.
The headlights automatically turn to full
intensity in the twilight even with the light
switch in the ºOFFº position.