Page 5 of 6
TRANSMISSION OIL COOLER INSTALLATION ± TC003±97 October 17, 1997
ProcedureJ. Install the 190 mm (7.48º) hose
(Continued) between the oil cooler tube No.1
and transaxle oil cooler tube.
NOTE:
Install the hose clamps with the hose
clamp clips at the positions shown, and
use pliers to pull off the clips in the
direction indicated by the arrows.
K. Install the oil cooler onto the center
brace and front cross member
using the two bolts and nut as
illustrated in figure 12.
Torque: 65.5 in±lbf
(7.4 N±m/75.5 kgf±cm)
L. Connect the hoses to the pipes.
NOTE:
Install the hose clamps with the hose
clamp clips at the positions shown, and
use pliers to pull off the clips in the
direction indicated by the arrows.
Fig. 11
5 mm (0.20º)
190 mm Hose
5 mm (0.20º) Oil Cooler Tube No. 1
Fig. 13
A/C COMPRESSOR INSTALLATION PROCEDURE ± AC003-04March 1, 2004
Page 2 of 2
1. AZ Series Engine:
Install A/C Compressor
A. Loosely install the compressor
(with the 3 bolts and nut or
4 bolts.)
Push down on the rear side of the
compressor and tighten the
bolts/nut in the order shown.
Torque: 24.5 N m (250 kgf cm, 18 ft lbf)
2. ZZ Series Engine:
Install A/C Compressor
A. Loosely install the compressor
(with the 2 bolts and nut or
3 bolts).
Push down on the rear side of
the compressor and tighten the
bolts/nut in the order shown.
Torque: 29 N m (295 kgf cm, 21 ft lbf) Installation
Procedure
(Continued)
BoltBoltPush
Nut or Bolt
Bolt12
34
BoltPush
Nut or Bolt Bolt
12
3
