2000 SUBARU LEGACY Owners Manual

5-40CAUTION
Use only music CDs identified by
mark.
Do not use CDs listed below which could cause damage to the
CD player. Any disc with a peel-off or seal on it.
Any disc with scratches and/or dust.
Bent disc.
Cleaning disc.
CD accessory. (E.g., 3-inch (8 cm) disc adapter)
Do not insert or remove any disc when the automatic transmis-
sion selector lever is in the park position; the selector lever in that position can interfere with disc insertion or removal, causing
scratches on the disc surface (for AT vehicles).
To insert a disc
Be sure to hold a d isc with the lab el sid e (the sid e where titles are
p rinted ) up .
Push the d isc into the slot.
The d isc will b e automatic ally set in p osition b y t he auto-load ing
mec hanism and b eg in p laying .
The d isc ind ic ator will turn on as the CD b eg ins p l aying .
n Disc indicator
Lit: A d isc is in the slot (When the ig nition switc h is in the “ON ” or
“ ACC ” p osition).
OFF: No d isc is load ed or the ig nition switc h is in the “Loc k ” p osition.
To remove disc left in slot
Simp ly p ress the “Ejec t b utton ”
3 and the d isc will b e ejec ted . This
p roc ed ures is effec tive even when the ig nition swit c h is in the “LOCK ”
p osition. n Function control
Refer to CD p layer c ontrol op erating instruc tions d esc rib ed in the
“ Typ e P119 and P120 aud io sets ” sec tion.

Audio5-41
–
CONTINUED –
CD player 2 (if equipped)
Compact disc player operation
HB5044BB
1 Ejec t b utton
2 Rep eat/rand om b utton
3 Sc an/top b utton
4 Disc slot 5
Fast forward and trac k up
b utton
6 Play/p ause b utton
7 Fast reverse and trac k d own
b utton
To playback a compact disc
n When CD is not in the player
Hold a d isc with a fing er in the c enter hole while g rip p ing the ed g e of
the d isc , then insert it in to the slot (with the l ab el sid e up ) and the
p layer will automatic ally p ull the d isc into p ositi on.
A 8 c m/3 inc h CD may also b e used without any ad ap t er.
NOTE DO NOT INSERT TWO DISCS INTO THE DISC INSERTION
SLOT AT A TIME. Be sure to always insert a disc with the label side up. If a disc
is inserted with the label side down, it might be ejected or theplayer might shut off. After the last song finishes, the player will automatically return
to track 1 (the first song on the disc).

5-42n
When CD is in the player
When the “ /❚❚ ” b utton 6 is p ressed , the p layer will start p layb ac k.
NOTE After the last song finishes, the player will automatically return to track 1 (the first song on the disc). To stop playback of a CD
When the “ /❚❚ ” b utton 6 is p ressed d uring p layb ac k of a CD, the
CD stop s p laying temp orarily. To let the CD resume p laying , p ress the
b utton ag ain. To select a song from its beginning
n Forward direction
Briefly p ress the “ ❚” b utton 5 to skip to the b eg inning of the next
trac k. Eac h time the b utton is p ressed , the ind ic at ed trac k numb er will
inc rease. n Backward direction
Briefly p ress the “❚ ” b utton 7 to skip to the b eg inning of the c ur-
rent trac k. Eac h time the b utton is p ressed , the in d ic ated truc k num-
b er will d ec rease. Fast forwarding and fast reverse
n Fast forward
Press the “ ❚” b utton 5 c ontinuously for more than 0.5 sec ond to
fast forward the d isc .
Release the b utton to stop fast forward ing . n Fast reverse
Press the “❚ ” b utton
7 c ontinuously for more than 0.5 sec ond to
fast reverse the d isc .
Release the b utton to stop fast reverse. Repeat playback
Use this to p lay a c ertain trac k rep eated ly. During p layb ac k, p ress the
“ RPT/RDM ” b utton
2 and release it in less than 2 sec ond s. The “RPT ”
ind ic ator will c ome on and the song will b e p layed c ontinuously. To

Audio5-43
–
CONTINUED –
c anc el the rep eat mod e, p ress the b utton ag ain. The
n the “RPT ” ind i-
c ator g oes out, and normal p layb ac k mod e is restore d .
Random playback
Use this to p lay the trac ks on the d isc in rand om o rd er. During p lay-
b ac k, p ress the “RPT/RDM ” b utton
2 and hold it in for more than 2
sec ond s. The “RDM ” ind ic ator will c ome on and all song s on the d isc
will b e p layed in a rand om ord er.
To c anc el the rand om mod e, p ress the b utton ag ain. Then the “RDM ”
ind ic ator g oes out, and normal p layb ac k mod e is res tored .
Scan
Press the “SCN/TOP ” b utton
3 and release it in less than 2 sec ond s,
and you c an hear the first 10 sec ond s of eac h trac k to seac h for the
d esired p rog ram. To c ontinue listening to the p rog r am, p ress the
“ SCAN ” b utton ag ain. After all trac ks on the d isc has b ee n sc anned ,
normal p layb ac k mod e is restored . To p
Use this to return to the first trac k on the d isc d uring p layb ac k. Press
the “SCN/TOP ” b utton
3 and hold it in for more than 2 sec ond s. Play-
b ac k returns to the b eg inning of the first trac k on the d isc .
To eject a disc from the player
When a d isc is b eing p layed b ac k or when a d isc is in the p layer,
p ress the ejec t b utton “
”. The d isc will b e ejec ted .
The d isc may b e removed even when the ig nition swit c h is in the
“ LOCK ” p osition.
NOTE Avoid driving the vehicle with a CD sticking out, because
vibration might make it fall out. To protect the disc, the disc is automatically loaded if it is left
in the ejected position for more than approximately 15 seconds(Auto Reload). In this case, the disc is not played.

5-44In-dash 6 CD auto changer (if equipped)
HB5040BB
1 Disc slot
2 Disc ind ic ators (d isc No.1 to 6) 3
Disc selec t b uttons
(d isc No.1 to 6)
4 Ejec t b utton
CAUTION
Do not attempt to insert two or more discs into the slot at a
time. Doing so can cause mechanical damage to the CD changer. Use only music CDs identified by a
mark.
Do not use CDs listed below which could cause damage to the
CD player.
3-inch (8 cm) compact disc.
Any disc with a peel-off or seal on it.
Any disc with scratches and/or dust.
Bent disc.
Cleaning disc.
CD accessory. (E.g., 3-inch (8 cm) disc adapter)
Do not insert or remove any disc when the automatic transmis-
sion selector lever is in the park position; the selector lever in that position can interfere with disc insertion or removal, causing
scratches on the disc surface (for AT vehicles).

Audio5-45
–
CONTINUED –

To insert a disc
1. Press one of the “Disc selec t ” b uttons 3 (numb ered from 1 to 6)
for whic h the d isc ind ic ator lig ht 2 is “OFF ”.
The Disc ind ic ator lig hts are loc ated d irec tly ab ov e the c orresp ond ing
“ Disc selec t ” b uttons.
2. The ind ic ator will b eg in b linking . The b linking w ill last for 15 se-
c ond s.
During this p eriod , insert a d esired d isc , and the d isc will b eg in to
p lay. (If any d isc is not inserted d uring this p eri od , the “Disc slot ”
1
d oor will c lose. Rep eat step 1.)
Be sure to hold a d isc with the lab el sid e (the sid e where titles are
p rinted ) up .
3. To insert another d isc , rep eat step 1 and 2 c hoos ing a d ifferent
d isc selec t b utton. To insert six discs at a time
1. Press and hold the “Disc selec t ” b utton numb er 1 until all d isc ind i-
c ators b eg in b linking (ab out 1.5 sec ond s).
2. The ind ic ators will b link for 15 sec ond s. During this p eriod , insert
d esired six d isc s.
3. When all d isc s are load ed , the first d isc will b e g in to p lay. (If no
d isc is inserted within this 15 sec ond s, the entire d isc load seq uenc e
will b e c anc eled .) To remove a disc
1. Press the d esired one of the “Disc selec t ” b uttons
3 (numb ered
from 1 to 6) for whic h the d isc ind ic ator lig ht is on.
2. Press the “Ejec t b utton ”
4 . The selec ted d isc will b e ejec ted and
the ind ic ator lig ht will b eg in b linking .
3. To remove another d isc , rep eat step 1 and 2 c hoos ing a d ifferent
“ Disc selec t ” b utton.
(To remove d isc s when the ig nition switc h is in the “Loc k ” p osition,
p ress the “Ejec t ” b utton, and the first d isc will b e ejec ted . Press the
“ Ejec t ” b utton ag ain, and the next d isc will b e ejec ted an d so on. At
this time, the “Disc selec t ” b uttons are d isab led .)

5-46
To remove all discs at one time
1. Press and hold the “Ejec t ” b utton 4 until all “Disc ” ind ic ators b eg in
b linking (ab out 1.5 sec ond s), and the first d isc wi ll b e ejec ted .
2. When the d isc is removed , the next one will b e ej ec ted , and so on.
To replace a playing disc with another
Simp ly p ress the d esired one of “Disc selec t ” b uttons
3 (numb ered
from 1 to 6) or p ress the “DISC UP ” or “DISC DOWN ” b utton on the
rad io unit to selec t the d esired d isc , and the d isc will b eg in to p lay.
Disc indicators
Lit: when the c orresp ond ing storag e tray is oc c up ie d b y a d isc .
Blinking : Disc p layer is either in load ing , ejec t o r c hang ing mod e.
OFF: No d isc is load ed or the ig nition switc h is in the “LOCK ” p osition.
Function control
Refer to CD p layer c ontrol op erating instruc tions d esc rib ed in the
“ Typ e P119 and P120 aud io sets ” or “Typ e P121 aud io set ” sec tion.

Audio5-47
–
CONTINUED –
Precautions to observe when handling a compact disc (CD)
To remove a d isc from the c ase, p ress the c enter of the c ase and hold
b oth ed g es of the d isc . If the d isc surfac e is touc hed d irec tly, c ontamina-
tion c ould c ause p oor tone q uality. Do not touc h th e d isc surfac e.
Use a c lean d isc whenever p ossib le. If there are d e p osits, wip e the
d isc surfac e from the c enter outward with a d ry, so ft c loth. Be sure not to
use a hard c loth, thinner, b enzene, alc ohol, etc . Never use a b ad ly d amag ed , d eformed or c rac ked d isc . Malfunc tions
or p rob lems mig ht result. A d isc is vulnerab le to heat. Never keep it either in p lac es exp osed to
d irec t sunlig ht, near heaters or in vehic les p arked in the sun or hot d ays.
OM-4747