11-543. Using a Phillip s sc rewd river, remove the up p er an
d lower sc rews
that sec ure the sid e c over of the rear c omb ination lig ht assemb ly.
4. Remove the b ulb soc ket from the rear c omb ination lig ht assemb ly
b y turning it c ounterc loc kwise.
HBB048BA
HBB025BA
5. Remove the b ulb from the soc ket.
Turn signal light: Pull the b ulb out of the soc ket.
Brake/tail light: Remove the b ulb from the soc ket b y p ushing it and
turning it c ounterc loc kwise.
6. Install a new b ulb in the soc ket.
7. Set the b ulb hold er into the rear c omb ination lig ht assemb ly and
turn it c loc kwise until it loc ks.
8. Fit the rear c omb ination lig ht assemb ly into the vehic le b od y and
tig hten the nuts from the interior of the vehic le.
9. Reinstall the lig ht b ulb rep lac ement servic e hole c overs.
Maintenance and service11-55
–
CONTINUED –
n
Back-up and brake/tail light bulbs
HBB025BA
HBB026BC
1. Unlatc h the rear c omb ination lig ht c over b y movin g the knob up -
ward . Op en the c over up .
2. Remove the b ulb soc ket from the rear c omb ination lig ht assemb ly
b y turning it c ounterc loc kwise.
3. Remove the b ulb from the soc ket b y p ushing it and turning c oun-
terc loc kwise. Install a new b ulb in the soc ket.
4. Set the b ulb hold er into the rear c omb ination lig ht assemb ly and
turn it c loc kwise until it loc ks.
5. Close the c over and latc h the loc k.
License plate light
HBB027BA
HBF013EA
1. Remove the mounting sc rews using a p hillip s sc rew d river.