2000 SUBARU LEGACY instrument panel

4-4
Heating and air conditioning system
Control panel
HB5004BC
1. Temp erature c ontrol d ial
2. Fan sp eed c ontrol d ial
3. Air flow c ontrol d ial
4. Air c ond itioner b utton (if eq uip p ed )
5. Air inlet selec tion b utton
6. Rear wind ow d efog g er b utton (Refer to “Rear wind ow d efog g er ” in
c hap ter 3.) n Temperature control dial
This d ial reg ulates the temp erature of air flow fro m the air outlets over
a rang e from the b lue area (c ool) to red area (warm ).
n Fan speed control dial
The fan op erates only when the ig nition switc h is t urned to the “ON ”
p osition. The fan sp eed c ontrol d ial is used to sel ec t four fan sp eed s.
n Air flow control dial
This d ial has the following five p ositions:
: Air flows throug h the instrument p anel outlets.
: Air flows throug h the instrument p anel outlets and the foot
outlets.

Interior equipment6-9
–
CONTINUED –
Cup holder
CAUTION
When not in use, always keep the holder stored while driving
to reduce the risk of injury in the event of a sudden stop or an accident. Do not pick up a cup from the cup holder or put a cup in the
holder while you are driving, as this may distract you and lead toan accident. Take care to avoid spills. Beverages, if hot, might burn you or
your passengers. Spilled beverages may also damage upholstery,carpets or audio equipment.
Front cup holder
n In instrument panel
HB7004BAHB7003BB
The c up hold er is loc ated b esid e the c limate c ontro l p anel. To use the
c up hold er, p ush on the its front surfac e and it wi ll automatic ally p op
out. Then p ull it out c omp letely.

Interior equipment6-11
–
CONTINUED –
Cigarette lighter (if equipped)
CAUTION
The electrical power socket located on the lower part of the instrument panel is designed to use only a SUBARU genuine cig-arette lighter plug. Do not use non-genuine cigarette lighter plugsor any “plug-in” type electrical accessories in the socket. Doing
so may cause a short-circuit and overheating, resulting in a fire.
HB6011BA
The elec tric al p ower soc ket loc ated on the lower p a rt of the instrument
p anel c an only b e used as c ig arette lig hter soc ket. A c ig arette lig hter
p lug is an op tional ac c essory. It is availab le from your SUBARU d ealer.
If smoking is not d esired , always p ut the c ap on th e soc ket to p revent
any foreig n ob jec t from entering it.
Cigarette lighter (if equipped)
WARNING
To avoid being burned, never grasp the lighter by the end with the heating element. Doing so could result in injury and couldalso damage the heating element.
CAUTION
Do not hold the lighter pushed in, because it will overheat.

6-14
HB7008BA
HB6018BA
Elec tric al p ower (12V DC) from the b attery is on ta p at the soc ket
when the ig nition switc h is either in the “ACC ” or “ON ” p osition.
You c an use an in-c ar use elec tric al ap p lianc e b y c onnec ting it to the
soc ket. Electrical power socket located on the lower part of the instru- ment panel
CAUTION
The electrical power socket located on the lower part of theinstrument panel is designed to use only a SUBARU genuine cig-arette lighter plug. Do not use non-genuine cigarette lighter plugsor any “plug-in” type electrical accessories in the socket. Doing
so may cause a short-circuit and overheating, resulting in a fire.Refer to the “Cigarette lighter ” section in this chapter.

11-6
HBB003BA
To op en the hood :
1. Pull the hood release knob und er the instrument panel.
2. Release the sec ond ary hood release loc ated und er the front g rille b y
moving the lever toward the left. Lift up the hood , release the hood p rop
from its retainer and p ut the end of the hood p rop into the slot in the
hood .
To c lose the hood :
1. Lift the hood slig htly and remove the hood p rop f rom the slot in the
hood and return the p rop to its retainer.
2. Lower the hood until it ap p roac hes ab out 6 in. (1 5 c m) from the
c losed p osition and let it d rop .
3. After c losing the hood , b e sure the hood is sec ur ely loc ked .
If this d oes not c lose the hood , release it from a slig htly hig her p osition.
Do not p ush the hood forc ib ly to c lose it. It c ould d eform the metal.