F01195
Bolt
Adjusting
ValueSet Bolt
15'
30'Adjusting Bolt90105-15001 90105-15004 90105-15005 90105-15006
45'
1°00'
1°15'
1°30'121212121 Dot 2 Dots 3 Dots
W00533
W00533
SA-6
- SUSPENSION AND AXLEFRONT WHEEL ALIGNMENT
822 Author: Date:
1996 TERCEL (RM440U)
If the camber is not within the specification, using the table be-
low, estimate of how much additional camber adjustment will be
required, and select the camber adjusting bolt.
(i) Follow the above mentioned steps again. Between step
(b) and (c), exchange 1 or 2 selected bolts.
HINT:
When exchanging the 2 bolts, exchange 1 bolt for each time.
6. ADJUST TOE-IN
(a) Remove the boot clamps.
(b) Loosen the tie rod end lock nuts.
(c) Turn the left and right rack ends an equal amount to adjust
the toe-in.
Toe-in
(total)A + B: 0.1° ± 0.2°
C - D: 1 ± 2 mm (0.04 ± 0.08 in.)
HINT:
Try to adjust the toe-in to the center value.
Make sure that the lengths of the left and right rack ends
are the same.
Tie rod end length difference: 1.5 mm (0.059 in.) or
less
(d) Torque the tie rod end lock nuts.
Torque: 47 N´m (480 kgf´cm, 35 ft´lbf)
(e) Place the boots on the seat and install the clamps to them.
HINT:
Make sure that the boots are not twisted.
