B: BULB REPLACEMENT
B6M0348A
1Tachometer and temperature
gauge illumination
2Oil pressure
3CHECK ENGINE (Malfunction Indi-
cator Light)
4Tachometer illumination
5Turn signal (RH)
6Headlight beam
7Door open
8Seat belt
9TCS (Operation indicator)
10Turn signal (LH)
11Speedometer illumination
12Speedometer and fuel gauge illumi-
nation
13Low fuel
14Charge
15Brake fluid level/parking brake
16FWD
17AT oil temperature
18ABS
19TCS (Warning)
34
6-2SERVICE PROCEDURE
13. Combination Meter
D: BASIC DIAGNOSTICS PROCEDURE
Start security system check.
Fully open all door windows and turn ignition switch OFF.
Take key out of ignition, exit vehicle and lock driver’s door.
Indicator light illuminates.
OK The light flashes.
The light does not
illuminate.
Check indicator harness.
Check security indicator light.
Check driver’s door key cylinder lock/unlock switch.
Check security control module.
Check whether switch input signal remains UNLOCK.
Check wiring harness.
Check switch input signals.
(Harnesses and switches separately)
(Tamper, door, hood, trunk and rear gate
switch)Check security control module.
Wait for 30 seconds.
Indicator light flashes at long intervals (0.2 sec. ON and 2.4 sec.
OFF).
OK
Not OK
Check security control module.
Unlock driver’s door using the inside lock knob and open door.
The horn sounds and headlights flash intermittently at 0.2 sec. ON
and 0.6 sec. OFF intervals.
The engine will not start even if the ignition switch is turned to
START. Indicator lamp goes out.
OK Starter motor runs.
All are not OK.
Check driver’s door switch.
Check wiring harness.
Check security control module.
Horn is not OK.
Check horn
operation by
pushing horn pad
on steering wheel.
OK
Not OK
Check horn.
Check horn relay.
Check security control module.
Check harness between horn relay and security control module.
Headlights are not
OK.
Check headlights
operation by
turning light switch
ON/OFF.
OK
Not OK
Check headlight
bulbs.
Check combination
switch.
Check headlight
relay.
Check starter interrupt relay.
Check wiring harness.
Check security control module.Check headlight alarm relay.
Check security control module.
Check wiring harness.
The alarm system continues to operate for 150 seconds.
OK Not OK
The horn and
headlights turn off.
The starter motor
does not run.
OK
Not OK
Check security
control module.
Unlock the driver’s door using ignition key.
Continues to next step.
88
6-2DIAGNOSTICS
6. Security System
