1996 NISSAN PATHFINDER Owners Manual

Page 41 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual The key can only be inserted fully in the
ignition key cylinder. For the door, back door
and glove box key cylinders, it is normal for the
key not to go into the key cylinder all the way.
Record the k

Page 42 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual children and others from unintention-
ally opening the doors, and will help
keep out intruders.
IBefore opening any door, always look
for and avoid oncoming traffic.
IWhen locking the door this way, b

Page 43 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual curs it will be difficult to help them.It is possible to lock/unlock all doors including
the back door.
Be sure to remove the key from the vehicle
before locking the doors and leaving it.
The remote c

Page 44 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual Unlocking doors
1. Push the ªº button on the multi-
remote controller.
2. Only the driver side door will unlock. Push
the ª
º button on the multi-remote con-troller again within 5 seconds.
3. All

Page 45 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual troller and vehicle is more than approx.
49 ft (15 m).
IWhen one of the doors is ajar, only the
unlock function can be operated.
Replace the two batteries as follows:
1. Remove the screw and open the

Page 46 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual FCC Notice:
This device complies with FCC rules part
15. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference and (2) this de-
vice must accept any

Page 47 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual 1. Turn the key counterclockwise to unlock the
back door.
2. Pull the opener handle to open the back
door.
3. To lock the back door, push it down firmly
and turn the key clockwise.
IAlways check the b

Page 48 of 223

NISSAN PATHFINDER 1996 R50 / 2.G Owners Manual Open the rear window after the wiper
returns to the STOP position.
1. Pull the hood lock release handle located
below the instrument panel; the hood will
then spring up slightly.
2. Raise the lever at