SERVICEPROCEDURES
Compressor -Model DKV-11D andDKV-14D
(ZEXEL make)
SHA927DB
SEC.
274
Clutchdisc ~4
-6
(0.4 -0.6, 35•52)
Thermalprotector
~ 15-18 (1.5 -1.8, 11•13)
~ :N'm (kg-m, in-Ib)
~ :N'm (kg-m, ft-Ib)
Drive plate
Shim SHA098EA Compressor
Clutch
REMOVAL
• When removing centerbolt,holdclutch discwithclutch disc
wrench.
• Remove thedrive plateusing ToolKV99232340.
Insert holder's threepinsintothedrive plate. Rotate the
holder clockwise tohook itonto theplate. Then, tighten the
center bolttoremove thedrive plate.
When tightening thecenter bolt,insert around bar
(screwdriver, etc.)between twoofthe pins (asshown inthe
left-hand figure)toprevent driveplaterotation. Afterremov-
ing the drive plate, remove theshims fromeither thedrive
shaft orthe drive plate.
HA-77
•
COMPRESSOR SERVICE
DATAANDSPECIFICATIONS (50S)
General Specifications
LUBRICANT
GA15DE,
SR20DE GA14DE
GA16DE
engine engineandCD20
Model engines
CALSONIC ZEXELZEXEL
make makemake
CR-14 DKV-14D DKV-11D
Type Vanerotary
Displacement 144(8.79) 140(8.54) 110(6.71)
cm
3
(cuin)/Rev
Direction ofrotation Clockwise
(Viewed fromdrive end)
GA engine model:PolyV
Drive belt SRengine model:PolyV
CD engine model:TypeA ZEXEL
make
CALSONIC make
Model DKV-11D
DKV-14D CR-14
Name Nissan
A/C
System Oil
Type R
Part number KLHOO-PAGRO
CapacitymC (Impfloz)
Total insystem 200
(7.0) 180(6.3)
Compressor (Ser-
vice parts) 200(7.0) 180
(6.3)
charging amount
REFRIGERANT
TypeCapacity kg
(Ib) HFC-134a
RHD models (Except Austra-
lia)
Australia (SR20DEengine)
Australia (GA16DE engine)
and LHD models forEurope 0.45
-0.55 (0.99 -1.21)
0.50 -0.60 (1.10 -1.32)
0.60 -0.70 (1.32 -1.54)
ENGINE IDLINGSPEED
When AICisON
Refer toEC section. Inspection
andAdjustment
COMPRESSOR
Model DKV-11D,DKV-14DandCR-14
Clutch disc-to-pulley clearance 0.3-0.6
mm (in) (0.012-0.024)
BELT TENSION
Refer toChecking DriveBelts(MAsection).
HA-84
PRE-DELIVERYINSPECTIONITEMS
Shown belowarePre-delivery InspectionItemsrequired forthe new vehicle. Itis recommended that
necessary itemsotherthanthose listedherebeadded, payingdueregard tothe conditions ineach
country.
Perform applicable itemsoneach model. Consult textofthis section forspecifications .
UNDER HOOD-engine off
o
Radiator coolantlevelandcoolant hosecon-
nections forleaks
o
Battery fluidlevel, specific gravityandcondi-
tions ofbattery terminals
o
Drive beltstension
D
Fuel filter forwater ordusts, andfuel lines
and connections forleaks
[] Engine oillevel andoilleaks
D
Clutch andbrake reservoir fluidlevel and
fluid lines forleaks
o
Windshield andrear window washerand
headlamp cleanerreservoir fluidlevel
D
Power steering reservoir fluidlevel andhose
connections forleaks
ON INSIDE ANDOUTSIDE
D
Remove frontspring/strut spacer(Ifapplica-
ble)
D
Operation ofall instruments, gauges,lights
and accessories
o
Operation ofhorn(s), wiperandwasher
[] Steering lockforoperation
[] Check airconditioner forgas leaks
o
Front andrear seats, andseat belts foroper-
ation
n
All moldings, trimsandfittings forfitand
alignment
[J
Allwindows foroperation andalignment
n
Hood, trunklid,door panels forfitand align-
ment
[1
Latches, keysandlocks foroperation
rl
Weatherstrips foradhesion andfit
[l
Headlamp aiming
I~ Tighten wheelnuts(Inc. inner nutsifapplica-
ble)
IJ Tire pressure (Inc.spare tire)
Il
Check frontwheels fortoe-in
IJ Install clock/voltmeter/room lampfuse(If
applicable)
~ Install deodorizing filtertoair purifier (If
applicable)
~ Remove wiperbladeprotectors (Ifapplicable)
UNDER
BODY
o
Manual transmission/transaxle, transferand
differential gearoillevel
D
Brake andfuel lines andoil/fluid reservoirs
for leaks
D
Tighten boltsandnuts ofsteering linkageand
gear box,suspension, propellershaftsand
drive shafts
~ Tighten rearbody boltsandnuts (Models with
wooden bedonly)
ROAD TEST
D
Clutch operation
D
Parking brakeoperation
[J
Service brakeoperation
D
Automatic transmission/transaxle shifttiming
and kickdown
[] Steering controlandreturnability
o
Engine performance
D
Squeaks andrattles
ENGINE OPERATING ANDHOT
D
Adjust idlemixture andspeed (andignition
timing*1)
n
Automatic transmission/transaxle fluidlevel
~ Engine idlingandstop knob operation (Diesel
only)
FINAL INSPECTION
n
Install necessary parts(outside mirror,wheel
covers, seatbelts, mat,carpet ormud flaps)
[1
Inspect forinterior andexterior metaland
paint damage
[] Check forspare tire,jack, tools (wheel
chock), andliterature
n
Wash, cleaninterior andexterior
"1: Not required onmodels withadirect ignition system
~ :Not appiicable tothis model.
•
MA-5
