1991 MITSUBISHI 3000GT Service Manual

AUTOMATIC TRANSAXLE - Transaxle Assemblv
23-69
(15)Remove the set screw from the manual control shaft and
remove the manual control shaft assembly.
(16)Remove the detent assembly.
(17)Remove the differential cover and gasket.
(18)Remove the differential front bearing cap.
(19)Remove the differential bearing retainer, spacer, and outer
race.
(20)Remove the differential assembly
(21)Remove the end clutch cover mounting bolts and remove
the end clutch cover.
[ TSB Revision

23-70AUTOMATIC TRANSAXLE - Transaxle Assembly
(22)Remove the end clutch assembly.
TFAOl24(23)Remove the thrust plate.
(24)Remove the end clutch hub.
(25)Remove the thrust bearing.
NOTEThe bearing may be adhering to the end clutch hub.
(26)Pull out the end clutch shaft.(27)Remove the idler gear cover mounting bolts and remove
the idler gear cover and gasket.

AUTOMATIC TRANSAXLE - Transaxle Assembly23-71(28)Straighten the lock where it forms over the bolt and remove
the bolt.
(29)Pull off the idler shaft and remove the idler gear and bearing
inner race.
I
(30)Remove the spacer.
(3l)Remove the oil pump bolts.
’(32)Using the special tool, remove the oil pump.
1 TSB Revision

23-72
AUTOMATIC TRANSAXLE - Transaxle Assembly(33)Remove the thrust washer and thrust race.
(34)Holding ‘onto the input shaft, remove the front clutch
assembly and rear clutch assembly together.(35)Remove the thrust bearing.(36)Remove the rear clutch hub.
NOTEThe thrust race may be sticking to the clutch hub.(37)Remove the thrust bearing.
TSB Revision

AUTOMATIC TRANSAXLE - Transaxle Assembly23-73(38IRemove the kickdown drum.(39)Remove the kickdown band.(40Enap off the snap ring and remove the kickdown servo
switch.
(41 )Using the special tool, push ,in the kickdown servo piston to
snap off the snap ring.(42)Remove the kickdown servo piston.
TSB Revision

23-74AUTOMATIC TRANSAXLE - Transaxle Assembly(43)Remove the anchor rod.(44)Remove the plug and pull out the air exhaust plug.(45)Remove the snap ring.
(46)Using the special tool, remove the center support(47)Remove the reverse sun gear and forward sun gear.
TSB Revision1

iAUTOMATIC TRANSAXLE
- Transaxle Assembly
23-75
(48)Remove the planetary carrier assembly.
(49)Remove the wave spring, return spring, reaction plate,
brake disc, and brake plate.
(50)Remove the screw and remove the rear bearing retainer.
(51)Snap off the snap ring and remove the output flange
Iassemblv.
(52)Remove the output bearing retainer mounting bolts and
remove the output bearing retainer and outer race.
TFAOl491
TSB Revision

AUTOMATIC TRANSAXLE - Transaxle Assemblv
(54)Using a sliding hammer, remove the outer race.(55)Remove oil seals.
TFA0478
TSB Revision