4 SYSTEM Service
Pad
indicator
Brake disc
BRAKE PAD CHECK AND . .
REPLACEMENT
brake ‘pads have wear that contact
disc when ‘the brake pad 2
The wear indicators a to warn
to have the pads replaced h&e
checked.
1.Check. brake pad.
port.
Standard’ 10 mm
,
Limit: 2.0 mm in.)
Caution
When the limit is pads on
both the left and be replaced
as a set.
2. If there is, a significant in the
thicknesses of the pads on the left and right sides,
the sliding condition- of -the
pin guide pin.
2. g u i d e c a l i p e r t h e ”
assembly toward, the inside of the wheel well
from the lock Support it
Caution
Donot wipe off the special guide
pin or allow it to
BASIC BRAKE SYSTEM
When newWhen worn
rake disc
Wear indicator
1 REAR DISC BRAKE‘ PAD
REPLACEMENT
NOTE
The brake pads have wear indicators that contact th
e brake
disc when the brake pad thickness becomes 2
in.).
The wear indicators emit a
to warn the driver
to have the pads replaced to have the brake system
checked.. .
1. Check brake pad thickness through caliper body c heck
port.
Standard value: 10 mm in.)
Limit: 2.0 mm
in.)
Caution
1. When the limit is exceeded, the brake pads on
both the left and right wheels must be replaced
as a set. ,
2 . I f t h e r e i s a s i g n i f i c a n t d i f f e r e n c e
the;
thicknesses of the pads on the left and right
check the condition of the piston, lock
pin sleeve and guide pin sleeve.
2. Remove guide pin. Lift caliper assembly, slide the
assembly toward the inside of the wheel well until
separated from the lock pin. Support it with wires.
Caution Do not wipe off the special grease that is on the g uide
pin or allow it to contaminate the guide pin.
3. Remove the following parts from caliper support. 1. Outer shim
2. Pad assembly
3. Pad and wear indicator assembly
4. Clip
TSB Revision
