2023 HYUNDAI IONIQ 6 air condition
[x] Cancel search: air conditionPage 234 of 582
Convenience Features
5-56
repeatedly to prevent battery
discharge.
• Do not leave the trunk open for a long period of time. This may drain the
battery.
• Do not modify or repair any part of the power trunk by yourself. Contact an
authorized HYUNDAI dealer.
• Do not operate the power trunk under the following conditions. The power
trunk may not operate properly.
- One side of the vehicle is lifted to inspect the vehicle or change a tire
- Parking on an uneven road such as a slope, etc.
• Close the trunk completely and lock all doors and trunk using the central door
lock button before using an automatic
car wash.
• Do not spray high pressure water directly on the power trunk outside
open/close button. The trunk may open
unintentionally.
Information • In cold and wet climates, the outside power trunk open button may not work properly
due to freezing conditions. If this occurs,
remove the ice before using the outside
power trunk open/close button or use the
power trunk open/close button on the smart
key or the instrument panel.
• If you leave the smart key in the trunk and close the trunk, a warning will sound for
about 5 seconds. If this occurs, open the
trunk by pressing the power trunk open
button on the outside of the trunk.
• If there are obstacles such as snow on the trunk, the trunk may not open
automatically. After removing the obstacle,
try to open it again.
• Be careful where there is an incline, as the trunk lid may drop slightly when it is
stopped before it fully opens.
Operating the Power Trunk
Power trunk open button (Smart
key)
B5011101
When the trunk is closed, press the power
trunk open button for 1.5 second. The
trunk will open with a warning sound.
While the trunk is opening, press the
button to stop power trunk operation.
Power trunk open/close button
(Instrument panel)
B5011102
When the trunk is closed, press the power
trunk open/close button. The power trunk
will open with a warning sound.
While the trunk is opening, press the
button to stop power trunk operation.
When the trunk is opened, press and hold
the trunk open/close button to close the
power trunk. If you release the button
while the trunk is closing, power trunk
operation will stop with a warning sound
for 5 seconds.
Hyundai_CE_en_US.book Page 56
Page 243 of 582
5
5-65
Over-The-Air Software
if equipped
Update
The Over-The-Air software update
feature allows you to wirelessly update
software to the latest version. Using this
feature, you can keep your vehicle system
up to date with the latest software.
Downloading Software
The latest software can be downloaded
automatically while driving. After the
latest software has been successfully
downloaded, you will receive a
notification on your phone or the vehicle
screen that the software update and
ready to install.
Approving Software Update
B5015301
After the vehicle is turned off, the vehicle
system will allow you to start the update.
• To start the update, press 'Start' (1).
• To postpone the update, press 'Later'
(2).
Preparing Software Update
If you press the 'Start' button on the
screen, the vehicle will begin installing
the update automatically. The following
conditions must be satisfied:
• The vehicle must be off. • The gear must be in P (Park).
• The Electronic Parking Brake (EPB)
must be applied.
• The exterior lights must be turned off.
• The hood must be closed.
• The battery must be sufficient.
• The systems to be updated must not be running.
Information The battery and system status are
automatically checked by the vehicle.
B5015302
• To update immediately, press 'Update
Now' .
• To cancel the update, press 'Cancel
Update' .
Updating Software
B5015401
You can see the progress of the update on
the screen.
12
Hyundai_CE_en_US.book Page 65
Page 254 of 582
Convenience Features
5-76
• There is a light that has a similar shape as a vehicle’s light.
• Headlights have been damaged or not repaired properly.
• Headlights are not aimed properly.
• Driving on a narrow curved road, rough road, uphill or downhill.
• Vehicle in front is partially visible on a crossroad or curved road.
• There is a traffic light, reflecting sign, flashing sign or mirror ahead.
• There is a temporary reflector or flash ahead (construction area).
• The road conditions are bad such as being wet, iced or covered with snow.
• A vehicle suddenly appears from a curve.
• The vehicle is tilted from a flat tire or is being towed.
• Light from an oncoming or front vehicle is not detected due to obstacles in the
air such as exhaust fume, smoke, fog,
snow, or water spay or blizzard on the
road, or fogging in the light, etc.
Information For more information on the limitations of the
Front View Camera, refer to the “Forward
Collision-Avoidance Assist (FCA)” section in
chapter 7.
WARNING • At times, High Beam Assist may not work properly. High Beam Assist is for
your convenience only. It is the
responsibility of the driver for safe
driving practices and always check the
road conditions for your safety.
• When High Beam Assist does not operate properly, change the headlight
position manually between high beam
and low beam.
• When starting up or initializing the front camera (rebooting, etc.), the High
Beam Assist function may not work for
about 15 seconds.
Hyundai_CE_en_US.book Page 76
Page 256 of 582
Convenience Features
5-78
If the wiper switch is set in AUTO mode
when the Start/Stop button is in the ON
position, the wiper will operate once to
perform a self-check of the system. Set
the wiper to the OFF position when the
wiper is not in use.
WARNING To avoid personal injury from the
windshield wipers, when the vehicle is
running and the windshield wiper switch
is placed in the AUTO mode:
• Do not touch the upper end of the windshield glass facing the rain sensor.
• Do not wipe the upper end of the windshield glass with a damp or wet
cloth.
• Do not put pressure on the windshield glass.
NOTICE [ : K H Q Z D V K L Q J W K H Y H K L F O H V H W W K H Z L S H U V Z L W F K L Q W K H 2 ) ) S R V L W L R Q W R V W R S
W K H D X W R Z L S H U R S H U D W L R Q 7 K H Z L S H U
P D \ R S H U D W H D Q G E H G D P D J H G L I W K H
V Z L W F K L V V H W L Q W K H $ 8 7 2 P R G H Z K L O H
Z D V K L Q J W K H Y H K L F O H
[ ' R Q R W U H P R Y H W K H V H Q V R U F R Y H U O R F D W H G R Q W K H X S S H U H Q G R I W K H
S D V V H Q J H U V L G H Z L Q G V K L H O G J O D V V
' D P D J H W R V \ V W H P F R P S R Q H Q W V F R X O G
R F F X U D Q G P D \ Q R W E H F R Y H U H G E \ \ R X U
Y H K L F O H Z D U U D Q W \
[ % H F D X V H R I X V L Q J D S K R W R V H Q V R U W H P S R U D U \ P D O I X Q F W L R Q F R X O G R F F X U
D F F R U G L Q J W R V X G G H Q D P E L H Q W O L J K W
F K D Q J H P D G H E \ V W R Q H D Q G G X V W Z K L O H
G U L Y L Q J
Front Windshield Washers
B5019701
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles. The spray and wiper operation will
continue until you release the lever. If the
washer does not work, you may need to
add washer fluid to the washer fluid
reservoir.
Recirculating air when washer fluid
is used
When washer fluid is used, in order to
reduce any objectionable scent of the
washer fluid from entering the cabin,
recirculation mode and air conditioning
are automatically activated depending on
the outside temperature. If you select
fresh mode while the function is
operating, the function will resume after a
certain amount of time. It may not work in
some conditions such as cold weather or
vehicle off.
For more information, refer to the
“Climate Control Additional Features”
section in this chapter.
WARNING When the outside temperature is below
freezing, ALWAYS warm the windshield
using the defroster to help prevent the
washer fluid from freezing on the
windshield and obscuring your vision
which could result in an accident and
serious injury or death.
Hyundai_CE_en_US.book Page 78
Page 258 of 582
Convenience Features
5-80
Automatic Climate Control System
Climate control panel
A5019801Infotainment System (Climate)
A5019802The actual shape for the climate control panel and infotainment system may differ from the illustration.
(1) Driver’s temperature control
(2) Passenger’s temperature control
(3) Display the air flow direction
(4) View climate infotainment system
(5) AUTO (automatic control)
(6) Mode selection button
(7) Fan speed up
(8) Fan speed down/OFF
(9) Front windshield defroster
(10) Rear windshield defroster
(11) Air intake control
(12) Driver only mode
(13) A/C (air conditioning) ON/OFF
(14) Heating ON/OFF
1
56
8
2
16
171213
1415
Hyundai_CE_en_US.book Page 80
Page 261 of 582
5
5-83
2. Adjust the temperature with the temperature control icon.
The fan speed level only can be changed
manually.
The following systems can be
respectively adjusted while the AUTO
climate control is on. When those systems
are adjusted, AUTO indicator lights will
turn off.
• Fan speed level
• A/C (Air condition)
• Mode selection
• Front windshield defroster (When defroster is turned off, AUTO indicator
light will illuminate)
For your convenience and to improve the
efficiency of the climate control, use the
AUTO button and set the temperature to
72 °F (22 °C).
To change the temperature unit from °C
to °F or °F to °C:
Select Setup > General > Unit >
Temperature Unit > °C/°F from the Settings menu in the infotainment
system.
B5019903
Manual Temperature Control
Mode
The heating and cooling system can be
controlled manually by selecting
functions other than
'AUTO'. In this case,
the system works sequentially according
to the order of the functions selected.
When selecting any other functions
except 'AUTO' while using automatic
operation, the functions not selected will
be controlled automatically.
1. Start the vehicle.
2. Set the mode to the desired position.
To improve the effectiveness of heating
and cooling, select the mode according
to the following:
• Heating:
• Cooling:
3. Set the temperature control to the desired value.
4. Set the air intake control to Fresh or Recirculation mode.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
7. Select 'AUTO' to revert back to full
automatic control of the system.
LevelAUTO
IndicatorClimate
InformationFan
Speed Level
3 HIGH 1-8
2 MEDIUM 1-6
1 LOW 1-4
Hyundai_CE_en_US.book Page 83
Page 264 of 582
Convenience Features
5-86
Face-Level (B, D)
Air flow is directed toward the upper body
and face. Additionally, each outlet can be
controlled to direct the air discharged
from the outlet.
Bi-Level (B, C, D, E)
Air flow is directed towards the face and
the floor.
All Level (A, B, C, D, E, F)
Air flow is directed toward the face, the
floor and the windshield.
Floor-Level (A, C, D, E)
Most of the air flow is directed to the
floor, with a small amount of the air being
directed to the windshield and side
window defrosters.
Floor/Defrost-Level (A, C, D, E)
Most of the air flow is directed to the floor
and the windshield with a small amount
directed to the side window defrosters.
Defroster-Level (A, D)
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side window defrosters.Front windshield defroster
B5020003
Defrost-level (A, D)
Press the icon, and the indicator light will
illuminate and the windshield defroster
indicator will appear on the climate
control panel.
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side window defrosters.
When Defogging logic is enabled, Fresh
mode is selected and air conditioning is
selected according to outside
temperature.
If the icon is pressed again, the indicator
light will turn off and the previous settings
will be selected.
Hyundai_CE_en_US.book Page 86
Page 265 of 582
5
5-87
Instrument panel vents
Front seat
B5020004Rear seat
B5020005
The instrument panel vent air flow can be
directed up/down or left/right using the
vent adjustment lever.
The air flow can also be CLOSED using the
vent adjustment lever.
Front seat
Move the lever away horizontally from the
seat to close until the levers click and
lock. Slightly move the lever toward the
seating position to unlock and open.
Rear seat
Move the lever downward to close the air
flow. Move the lever upward to open the
air flow.
Temperature control
Climate control panel
B5020006Infotainment system
B5020007
Touch the or icon to select the
temperature.
The temperature can be increased or
decreased by increments of 1 °F (0.5 °C)
for each incremental location. When set
to the lowest temperature setting, the air
conditioning will operate continuously to
quickly cool the interior of the vehicle
initially. After interior temperature has
been cooled down sufficiently, select
'AUTO' and set the temperature to 72 °F
(22 °C).
Hyundai_CE_en_US.book Page 87