2020 FIAT 500 Owner handbook (in English)

Children over 1.50 m in height can wear
seat belts like adults.
60F0S0414
61F0S0413
79

PASSENGER SEAT COMPLIANCE WITH REGULATIONS ON UNIVERSAL CHILD
RESTRAINT SYSTEM USE
The car complies with European Directive 2000/3/EC which governs the arrangement possibilities for child restraint systems on
the various seats of the car as shown in the following table:
Group Weight rangeFront passenger(*)Rear passenger
Airbag enabled Airbag disabled
Group 0, 0+ up to 13 kgXUU
Group 1 9 - 18 kgXUU
Group 2 15 - 25 kgUUU
Group 3 22–36 kgUUU
(*) IMPORTANT: NEVER fit a rearward-facing child seat in the front passenger seat if the airbag is active. If you wish to fit a rearward-facing child restraint system in
the front passenger seat, first deactivate the relative airbag (see instructions in the paragraph "Supplementary protection system (SRS) – Airbag”).
X Seat not suitable for children in this weight category.
U Suitable for child restraint systems in the "Universal" category, according to European Standard ECE-R44 for the specified "Groups".
80
SAFETY

INSTALLING AN ISOFIX
CHILD CARSEAT
97) 98) 99) 100) 101)
The car is equipped with ISOFIX
anchorages, a new standard which
makes fitting a child restraint system
quick, simple and safe.
The ISOFIX system lets you install the
ISOFIX child restraining system without
using the car seat belts but connecting
them directly to the carseat with three
anchors in the car. Traditional child
restraint systems can be fitted
alongside ISOFIX child restraint systems
on different seats in the same vehicle.
To install an ISOFIX child restraint
system, attach it to the two metal
anchor points A fig. 62 located where
the rear seat cushion meets the
backrest and identified by the symbol
, then remove the parcel shelf
and fix the upper strap (available
together with the restraint system) to
the anchor point B fig. 63 located at the
bottom behind the backrest.
As an example, fig. 64 shows an
example of a Universal Isofix child
restraint system for weight group 1.
IMPORTANT The diagram is indicative
and for fitting purposes only. Fit the
child restraint system according to the
instructions, which must be included.NOTE When a Universal ISOFIX child
restraint system is used, only ECE R44
"ISOFIX Universal” (R44/03 or further
upgrades) type-approved child restraint
systems can be used.
The Universal Isofix “Duo Plus” child
restraint system and the special "G 0/1"
seat are available from Lineaccessori
MOPAR
®.
For any further details on installation/
use, refer to the instruction manual for
the child restraint system.
62F0S0133
63F0S013464F0S0132
81

SUITABILITY OF PASSENGER SEATS FOR ISOFIX CHILD RESTRAINT SYSTEM USE
The table below shows the various possibilities for installing Isofix child restraint systems on seats fitted with specific
attachments in accordance with European standard ECE 16.
Weight groupChild restraint system
positionIsofix size class Rear side Isofix position
Group 0 up to 10 kg Rear facing EX
Group0+0to13kgRear facing E
X
Rear facing DX
Rear facing CX
Group1from9to18kgRear facing D
X
Rear facing CX
Forward facing BIUF
Forward facing B1IUF
Forward facing AIUF (*)
X: Isofix position not suitable for Isofix child restraint system in this weight group and/or size class.
IUF: Suitable for forward facing Isofix child restraint systems in the Universal category and type-approved for the use in the weight group.
(*)This Isofix position is not suitable for Isofix child restraint systems in this group of weight and/or size class.
The other weight groups are covered by specific ISOFIX child restraint systems, which can be used only if specifically tested for
this car (see list of cars provided with the child restraint system).
82
SAFETY

SUITABILITY OF
PASSENGER SEATS FOR
i-SIZE CHILD RESTRAINT
SYSTEM USE
(for versions/markets, where provided)
These child restraint systems, built
and type-approved according to the
i-Size (ECE R129) standard, ensure
better safety conditions to carry
children on board a vehicle:
the child must be transported
rearward facing until 15 months;
child restraint system protection is
increased in the event of a side
collision;
the use of the ISOFIX system is
promoted to avoid faulty installation of
the child restraint system;
efficiency in the choice of the child
restraint system, which isn't made
according to weight any more
but according to the child's height, is
increased;
compatibility between the vehicle
seats and the child restraint systems is
better: the i-Size child restraint systems
can be considered as "Super ISOFIX";
this means that they can be perfectly
fitted in type-approved i-Size seats, but
can also be fitted in ISOFIX (ECE R44)
type-approved seats.NOTE: See the table shown on the
following page to check whether your
car is approved for installing i-Size child
restraint systems.
65F0S0649
83

The following table, according to European standard ECE 129, indicates the possibility of i-Size child restraint system
installation.
i-Size POSITIONS ON THE CAR
Device Front passenger Rear right passenger Rear left passenger
i-Size child restraint
systemsISO/R2X i-U(*) X
ISO/F2X i-U(*) X
X Seat not suitable for Universal i-Size child restraint systems.
i-U(*) Installation only possible by moving the corresponding front seat forward. In this configuration, the seat must not be occupied.
84
SAFETY

CHILD RESTRAINT SYSTEMS RECOMMENDED BY FIAT FOR YOUR VEHICLE
Lineaccessori MOPAR
®includes a complete range of child restraint systems to be fixed using the seat belt with three
anchorage points or the ISOFIX anchorages.
IMPORTANT FCA recommends fitting the child restraint system according to the instructions, which must be included.
Weight group Child restraint system Type of child restraint system Child restraint system installation
Group 0+:
from birth to 13 kg
from 40 cm to 80
cm
BeSafe iZi Go Modular
Fiat order code: 71808564
Universal/i-Size child restraint system.
It must be installed facing rearwards,
using the car seat belts only, or the
dedicated i-Size base (which can be
purchased separately) and the car
ISOFIX anchorages.
It must be fitted on the rear outer
seats. ++
BeSafe iZi Modular i-Size
Base
Fiat order code: 71808566
85

Weight group Child restraint system Type of child restraint system Child restraint system installation
Group 0+/1:
from9upto18kg
from 67 cm to 105
cm
BeSafe iZi Modular iSize
Fiat order code: 71808565
i-Size approved child restraint system.
It must be installed on the car
together with the iZi Modular i-Size
Base (available separately). It can
be installed facing forwards or
facing backwards (refer to the
child restraint system manual). ++
BeSafe iZi Modular i-Size
Base
Fiat order code: 71808566
Group 2:
from 15 up to 25 kg
from 95 cm to 135
cm
Britax Römer KidFix XP
(for versions/markets, where
provided)
Fiat order code: 71807984It can only be fitted facing forwards,
using the three-point seat belt and the
ISOFIX anchorages of the vehicle, if
present.Fiat recommends installing
it using the vehicle’s ISOFIX
anchor points.
It must be fitted on the rear outer
seats.
86
SAFETY