2019 MAZDA MODEL CX-30 seats

Do not operate a vehicle with
damaged air bag/seat belt
pretensioner system components:
Expended or damaged air bag/seat
belt pretensioner system components
must be replaced after any collision
which caused them to deploy or
damage them. Only a trained expert
repairer (we recommend an
Authorised Mazda Repairer) can fully
evaluate these systems to see that they
will work in any subsequent accident.
Driving with an expended or damaged
air bag or pretensioner unit will not
afford you the necessary protection in
the event of any subsequent accident
which could result in serious injury or
death.
Do not remove interior air bag parts:
Removing any components such as the
front seats, front instrument panel, the
steering wheel or parts on the front
and rear window pillars and along the
roof edge, containing air bag parts or
sensors is dangerous. These parts
contain essential air bag components.
The air bag could accidentally activate
and cause serious injuries. Always have
an expert repairer (we recommend an
Authorised Mazda Repairer) remove
these parts.
Properly dispose of the air bag
system:
Improper disposal of an air bag or a
vehicle with live air bags in it can be
extremely dangerous. Unless all safety
procedures are followed, injury could
result. Have an expert repairer (we
recommend an Authorised Mazda
Repairer) safely dispose of the air bag
system or scrap an air bag equipped
vehicle.NOTE
xWhen an air bag deploys, a loud
inflation noise can be heard and
some smoke will be released.
Neither is likely to cause injury,
however, the texture of the air bags
may cause light skin injuries on body
parts not covered with clothing
through friction.
xShould you sell your Mazda, we urge
you to tell the new owner of its air
bag systems and that familiarization
with all instructions about them,
from the Owner's Manual, is
important.
xThis highly-visible label warns against
the use of a rear-facing
child-restraint system on the front
passenger seat.
(Except Taiwan)
(Taiwan)
k0dS<

Sunroof*
▼Sunroof
The sunroof can be opened or closed
when operating the overhead tilt/slide
switch at the front seats.
WARNING
Do not let passengers stand up or
extend part of the body through the
open sunroof while the vehicle is
moving:
Extending the head, arms, or other
parts of the body through the sunroof
is dangerous. The head or arms could
hit something while the vehicle is
moving. This could cause serious injury
or death.
Never allow children to play with the
tilt/slide switch:
The tilt/slide switch would allow
children to operate the sunroof
unintentionally, which could result in
serious injury if a child's hands, head
or neck becomes caught by the
sunroof.
Make sure the opening is clear before
closing the sunroof:
A closing sunroof is dangerous. The
hands, head, or even neck of a person,
especially a child, could be caught in it
as it closes, causing serious injury or
even death.
Make sure nothing blocks the sunroof
just before it reaches the fully closed
position:
Blocking the sunroof just before it
reaches the closed position is
dangerous.
In this case, the jam-safe function
cannot prevent the sunroof from
closing. If fingers are caught, serious
injuries could occur.
CAUTION
¾Do not sit on or put heavy items on
the area where the sunroof opens
and closes. Otherwise, the sunroof
could be damaged.
¾Do not open or close the sunroof
forcefully during freezing
temperatures or snowfall. Otherwise,
the sunroof could be damaged.
¾The sunshade does not tilt. To avoid
damaging the sunshade, do not push
it up.
¾Do not close the sunshade while the
sunroof is opening. Trying to force
the sunshade closed could damage
it.
▼Tilt/Slide Operation
The sunroof can be opened or closed
electrically only when the ignition is
switched ON.
xBefore leaving the vehicle or washing
your Mazda, make sure the sunroof
is completely closed so that water
does not get inside the cabin area.
xAfter washing your Mazda or after it
rains, wipe the water off the sunroof
before operating it to avoid water
Before Driving
Windows
3-44*Some models.

Theft-Deterrent System*
▼Theft-Deterrent System
If the theft-deterrent system detects an
inappropriate entry into the vehicle or
the intrusion sensor detects movement
in the vehicle which could result in the
vehicle (with the intrusion sensor) or
its contents being stolen, the alarm
alerts the surrounding area of an
abnormality by sounding the siren/
horn and flashing the hazard warning
lights.

The system will not function unless it's
properly armed. So when you leave the
vehicle, follow the arming procedure
correctly.
Intrusion sensor
*
The intrusion sensor uses ultrasonic
waves to detect movement inside the
vehicle and to raise an alert of an
intrusion into the vehicle.

The intrusion sensor detects certain
kinds of movement inside the vehicle,
however, it may also respond to
phenomenon outside the vehicle such
as vibrations, loud noise, wind, and air
currents.
CAUTION
In order for the intrusion sensor to
operate appropriately, be aware of the
following:
¾Do not hang clothing or objects from
a head restraint or a coat hook.
¾Return the extension sunvisors to
their original positions.
¾Do not blind the intrusion sensor by
covering it or placing objects over it.
¾Do not allow the intrusion sensor to
get soiled or wipe it with a liquid.
¾Do not shock or cause an impact to
the intrusion sensor or the intrusion
sensor bezel.
¾Do not install seats that are not
Mazda genuine products.
¾To prevent obstruction of intrusion
sensor, do not place objects or cargo
near the intrusion sensor that are
higher than the head restraints.

1. Intrusion sensor and intrusion
sensor bezel
▼Operation
Siren/Horn triggering conditions
The siren/horn sounds intermittently
and the hazard warning lights flash for
about 30 seconds when the system is
triggered by any one of the following:
With the intrusion sensor
xUnlocking a door with the auxiliary
key, door lock switch, or an inside
door-lock knob.
xForcing open a door, the bonnet or
the liftgate.
xOpening the bonnet by operating
the bonnet release handle.
xSwitching the ignition ON without
using the push button start.
xThe intrusion sensor detects a
movement in the vehicle.
Before Driving
Security System
*Some models.3-49

xWhen there is insufficient darkness
such as at dawn or dusk.
xWhen the luggage compartment is
loaded with heavy objects or the rear
passenger seats are occupied.
xWhen visibility is reduced due to a
vehicle in front of you spraying water
from its tyres onto your windscreen.
▼To Operate the System
The HBC operates to switch the
headlights automatically between high
and low beams after the ignition is
switched ON and the headlight switch
is in the AUTO and low beam position.
The HBC determines that it is dark
based on the brightness of the
surrounding area. At the same time,
the HBC indicator light (green) in the
instrument cluster illuminates.

NOTE
Operation of the HBC function can be
disabled.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
▼Manual Switching
Switching to low beams
Switch the headlight switch to the
position, or press the high beam
control switch.
The HBC indicator light (green) turns
off.
1. High beam control switch

If the HBC is turned off using the high
beam control switch, press the high
beam control switch again to turn the
HBC back on.
Switching to high beams
Shift the lever to the high beam
position.
The HBC indicator light (green) turns
off and the headlight high-beam
indicator light is illuminated.
When Driving
i-ACTIVSENSE
4-100

xWhen there are other sources of light
in the area such as street lamps,
illuminated signboards, and traffic
signals.
xWhen there are reflective objects in
the surrounding area such as
reflective plates and signs.
xWhen visibility is reduced under rain,
snow and foggy conditions.
xWhen driving on roads with sharp
curves or undulations.
xWhen the headlights/rear lamps of
vehicles ahead or in the opposite
lane are dim or not illuminated.
xWhen there is insufficient darkness
such as at dawn or dusk.
xWhen the luggage compartment is
loaded with heavy objects or the rear
passenger seats are occupied.
xWhen visibility is reduced due to a
vehicle ahead spraying water from its
tyres onto your windscreen.
▼To Operate the System
The ALH operates to control Glare-Free
High Beam, Wide-Range Low Beam
and Highway Mode automatically after
the ignition is switched ON and the
headlight switch is in the
and
low beam position.
The ALH determines that it is dark
based on the brightness of the
surrounding area. At the same time,
the ALH indicator light (green) in the
instrument cluster illuminates.
NOTE
Operation of the ALH function can be
disabled.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
▼Manual Switching
Switching to low beams
Switch the headlight switch to the
position, or press the ALH switch.
The ALH indicator light (green) turns
off.
1. ALH switch

If the ALH is turned off using the ALH
switch, press the ALH switch again to
turn the ALH back on.
Switching to high beams
Shift the lever to the high beam
position.
The ALH indicator light (green) turns
off and the headlight high-beam
indicator light is illuminated.
When Driving
i-ACTIVSENSE
4-102

¾Do not adhere stickers (including
transparent stickers) to the surface of
the radiator grille and front emblem
in and around the front radar sensor,
and do not replace the radiator grille
and front emblem with any product
that is not a genuine product
designed for use with the front radar
sensor.
¾The front radar sensor includes a
function for detecting soiling of the
radar sensor's front surface and
informing the driver, however,
depending on the conditions, it may
require time to detect or it may not
detect plastic shopping bags, ice or
snow. If this occurs, the system may
not operate correctly, therefore
always keep the front radar sensor
clean.
¾Do not install a grille guard.
¾If the front part of the vehicle has
been damaged in a vehicle accident,
the position of the front radar sensor
may have moved. Stop the system
immediately and always have the
vehicle inspected at an expert
repairer (we recommend an
Authorised Mazda Repairer).
¾Do not use the front bumper to push
other vehicles or obstructions such
as when pulling out of a parking
space. Otherwise, the front radar
sensor could be hit and its position
deviated.
¾Do not remove, disassemble, or
modify the front radar sensor.
¾For repairs, replacement or paint
work around the front radar sensor,
consult an expert repairer (we
recommend an Authorised Mazda
Repairer).¾Do not modify the suspensions. If
the suspensions are modified, the
vehicle's posture could change and
the front radar sensor may not be
able to correctly detect a vehicle
ahead or an obstruction.
NOTE
xUnder the following conditions, the
front radar sensor may not be able to
detect vehicles ahead or obstructions
correctly and each system may not
operate normally.
xThe rear surface of a vehicle ahead
does not reflect radio waves
effectively, such as an unloaded
trailer or an automobile with a
loading platform covered by a soft
top, vehicles with a hard plastic
tailgate, and round-shaped
vehicles.
xVehicles ahead with low vehicle
height and thus less area for
reflecting radio waves.
xVisibility is reduced due to a
vehicle ahead casting
off water,
snow, or sand from its tyres and
onto your windscreen.
xThe luggage compartment is
loaded with heavy objects or the
rear passenger seats are occupied.
xIce, snow, or soiling is on the front
surface of the front emblem.
xDuring inclement weather such as
rain, snow, or sand storms.
xWhen driving near facilities or
objects emitting strong radio
waves.
xUnder the following conditions, the
front radar sensor may not be able to
detect vehicles ahead or
obstructions.
xThe beginning and end of a curve.xRoads with continuous curves.
When Driving
i-ACTIVSENSE
4-221

Index
Rocking the Vehicle................... 3-56
Running-In................................ 3-53
S
Saving Fuel and Protection of the
Environment............................. 3-53
Scheduled Maintenance.............. 6-3
Seats
Driver's seat........................... 2-4
Driving position memory....... 2-10
Front passenger's seat........... 2-12
Front seat............................... 2-4
Head restraint...................... 2-15
Rear seat..............................2-13
Seat warmer......................... 2-17
Seat Belt System
Emergency locking................ 2-22
Pregnant women.................. 2-21
Seat belt precautions............ 2-20
Seat Belt Warning Beep............. 7-67
Security System
Immobilizer system............... 3-47
Theft-deterrent system.......... 3-49
Shift Position Warning Beep....... 7-69
Smart Brake Support (SBS)....... 4-175
Collision warning................ 4-176
Stopping the Smart Brake Support
(SBS) system operation........4-177
Smart Brake Support [Rear Crossing]
(SBS-RC).................................4-181
Collision warning................ 4-184
Stopping the Smart Brake Support
[Rear Crossing] (SBS-RC) system
operation........................... 4-184
Smart Brake Support [Rear] (SBS-
R)........................................... 4-177
Collision warning................ 4-180
Stopping the Smart Brake Support
[Rear] (SBS-R) system
operation........................... 4-180
Spare Tyre................................. 7-25
Specifications
Brakes.................................. 9-12
Capacities.............................. 9-7
Cleaner.................................. 9-7
Dimensions............................ 9-9
Electrical system..................... 9-4
Engine................................... 9-4
Light bulbs............................. 9-9
Lubricant quality..................... 9-6
Tyres.................................... 9-10
Speed Limiter Warning Beep...... 7-72
SRS Air Bags
Front passenger air bag
deactivation switch............... 2-51
How the SRS air bags work.... 2-55
Limitations to SRS air bag...... 2-60
Monitoring........................... 2-62
SRS air bag deployment
criteria................................. 2-58
Supplementary restraint system
components......................... 2-54
Supplementary restraint system
(SRS) precautions................. 2-45
Starting the Engine...................... 4-5
Steering Wheel
Heated steering wheel.......... 2-18
Horn.................................... 4-67
Storage Compartments.............. 5-39
Centre console..................... 5-40
Glove compartment..............5-40
Luggage compartment.......... 5-41
Overhead console................ 5-39
Storage pocket..................... 5-40
Storage Pocket.......................... 5-40
Sunroof.....................................3-44
Sunshade.................................. 3-46
Sunvisors.................................. 5-32
10-9