2018 Peugeot iOn Owner's Manual

15
In cold weather, the capacity to regenerate
through braking is reduced.
Total distance recorder "Charge" zone
The needle moves to the left, in proportion to
the level of charge going into the main battery,
during periods of deceleration and braking.
Instrument panel display
screen
When the switch is in the "ON" position, you
can display various information on the screen
by successively pressing button A .
System which measures the total distance
travelled by the vehicle during its life. Press button A
.
The total distance appears in the display.
Switching the speedometer unit
When the total distance recorder is displayed,
hold button A down for a few seconds to
change the speedometer unit (mph or km/h).
When remaining range indicator is displayed in
the unit (miles or km) corresponding to that of
the speedometer unit (mph or km/h).
Trip distance recorder
(trip
A o
r B)
These two trips indicate the distance travelled
since the trip recorder was last reset. Press button A to display the desired trip.
Reset
With the ignition on, when one of the trips A or
B is displayed, press the button for more than
two seconds.
1
Dashboard instruments

16
Lighting dimmer
System that allows the brightness of the
instruments and controls to be adjusted
manually to suit the ambient light level.
With the headlamps on or off, press button A to
select the function, then hold it down to adjust
the brightness of the instruments and controls
lighting to "day" or "night".
The brightness of the lighting increases every
time you press button A.
When the lighting reaches the maximum
setting, press again to move to the minimum
setting.
Release button A as soon as the lighting
reaches the desired brightness.
The setting is registered as soon as you
release button A and is stored when the ignition
switch is turned to OFF.
Service indicator
System which informs the driver when the
next ser vice is due, in accordance with the
manufacturer's servicing schedule.
This due date is calculated from the last reset
of the service indicator.
There are two different ways to indicate when
the next ser vice is due:
-

r
emaining distance (in kilometres or miles),
-

t
ime (in months) left before the next
service.
Once the ignition is switched on, press
button
A successively until the ser vice indicator
is displayed in the desired units.
Operation
1. The display shows the distance or time
remaining before the next service.
2. The display shows that the ser vice is due.
Each time the ignition is switched on, the
ser vice spanner is displayed for a few
seconds to notify you that the ser vice
must be carried out very soon.
3. Once the ser vice has been completed,
the distance or the time remaining before
the next ser vice is displayed.
Dashboard instruments

17
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F
T
urn off the ignition (switch to LOCK or
ACC position).
F

P
ress the reset button A in succession until
the service indicator is displayed.
F

P
ress and hold the reset button down for a
few seconds to make the spanner flash .
F

P
ress the reset button whilst the spanner
is flashing to move the display " ---" to
" CLEAR ".
The distance (or the time) remaining before
the next ser vice is displayed. The distance "
---" indicating that the
ser vice is now due is reset automatically
after a certain time and a certain distance
travelled. The display will then indicate the
remaining time before the next service.
Under-inflation detection
You must reinitialise the under-inflation
detection system after adjusting one or more
tyre pressures and after changing one or more
wheels.
The procedure for this is as follows.
F

P
ress button A to select the system.
F

P
ress and hold button A down for at least
three seconds .
An audible signal sounds and the under-
inflation warning lamp flashes slowly until
reinitialisation has been completed.
1
Dashboard instruments

18
Choice of set of tyres fitted
If you have registered a second set of tyres
with sensor, after every change, select the
corresponding set in the instrument panel
display screen.
The procedure for this is as follows.
F
P
ress button A to select the system.
F

P
ress and hold button A for more than ten
seconds to move from tyre set 1 to tyre
set
2 in succession or vice versa.
Range indicator
This function provides you with an estimated
range that your vehicle can still travel, taking
into account your recent conditions of use
(driving style, use of heating, air conditioning,
e t c .) .When the remaining range is too low, " ---"
is displayed in the instrument panel.
The remaining range can be displayed in
miles or kilometres.
For more information on the distance
recorder , and the unit change in
particular, refer to the corresponding
section.
Dashboard instruments

19
Remote control key
System used to lock or unlock the vehicle's
central locking system with a key or remotely.
It also starts the vehicle and provides anti-theft
protection.
Unfolding/folding the key
F Press button A to unfold or fold the key.
Unlocking the vehicle
Unlocking using the remote
control
F Press the open padlock button to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15
seconds
and the direction indicators flashing twice.
Unlocking using the key
F Turn the key towards the right in the
driver's door lock to unlock the vehicle.
Unlocking is confirmed by illumination of the
interior courtesy lamp for about 15

s
econds and
the direction indicators flashing twice .
However, the door mirrors do not unfold.
The passenger door lock does not allow
the locking or unlocking of the other doors
and/or of the boot.
The vehicle will lock again automatically
after thirty seconds unless a door or the
boot is opened. This mechanism helps
avoid unlocking by mistake.
Locking the vehicle
The door mirrors unfold at the same time
(depending on version).
Normal locking using the remote
control
F Press the closed padlock button to lock the vehicle. Locking is confirmed by the direction indicators
flashing once
.
The door mirrors fold at the same time
(depending on version).
Normal locking using the key
F Turn the key towards the left in the driver's door lock to lock the vehicle.
Locking is confirmed by the direction indicators
flashing once .
However, the door mirrors do not fold.
Anti-theft protection
Electronic immobiliser
The key contains an electronic chip which has
a specific code. When the ignition is switched
on, this code must be recognised to enable the
vehicle to start.
This electronic immobiliser locks the motor
management system a few minutes after the
ignition is switched off and prevents the engine
being started by anyone who does not have
t h e key.
In the event of a fault, or if your vehicle does
not start, contact a PEUGEOT dealer as soon
as possible.
2
Access

20
In the event of a fault with the remote control,
you can no longer unlock or lock your vehicle.
F
F
irst of all, use the key in the driver's door
lock to unlock or lock your vehicle.
F

S
econdly, ask a PEUGEOT dealer to check
the operation of the remote control and to
replace the battery if necessary. Lost keys
See a PEUGEOT dealer with the vehicle
registration certificate and your ID.
A PEUGEOT dealer can retrieve the key
code and the transponder code to order the
replacement key.
Remote control problemAnti-theft protection
Do not make any modifications to the
electronic vehicle immobiliser system; this
could cause malfunctions.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while
it is in your pocket as there is a possibility
that it may unlock the vehicle without you
being aware of it.
Do not repeatedly press the buttons of
your remote control when out of range and
out of sight of your vehicle, as it may stop
working.
The remote control does not operate when
the key is in the ignition, even when the
ignition is switched off.
Locking the vehicle
Driving with the doors locked may make
access to the passenger compartment by
the emergency ser vices more difficult in an
emergency.
As a safety precaution (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a short
time. When purchasing a second-hand vehicle
Have the key codes memorised by a
PEUGEOT dealer, to ensure that the keys in
your possession are the only ones which can
start the vehicle.
Access

21
Doors
Opening
From outside
F After unlocking the vehicle using the remote control or the key, pull the door
handle.
From inside
F Pull the front or rear door control to open the door.
If the doors are locked:
-
o

pening the driver's door unlocks the other
doors,
-

t
he front passenger door or the rear doors
must first be manually unlocked using the
lock control before being opened.
Closing
If a door or the boot is not properly
closed, this warning lamp comes
on in the instrument panel until the
relevant door or the boot is closed.
Locking/unlocking from
inside
F Push the driver's door button for wards to lock or rear wards to unlock the entire
vehicle. The front and rear passenger door buttons
lock /unlock only the corresponding door.
Boot
Opening
F After unlocking the vehicle using the
remote control or the key, press the
handle


A, then raise the tailgate.
2
Access

22
Closing
F Pull the handle B and guide the tailgate downwards.
F

R
elease the handle and gently press on the
outside sur face of the tailgate to close it.
Electric windows
System designed for opening or closing a
window manually or automatically. Equipped
with a deactivation system to prevent misuse of
the rear controls. 1.
Driver's electric window.
2. Passenger's electric window
3. Rear right electric window.
4. Rear left electric window.
5. Deactivating the passenger and rear
window controls.
Operation
With the ignition on:
F
P ress the control to open or pull it to close,
without passing the point of resistance.
The window stops as soon as the control is
released. The electric window controls remain
operational for approximately 30
seconds
after switching off the ignition.
The windows can no longer be opened or
closed once the driver's door is closed.
Deactivating the passenger and
rear window controls
F For your children's safety, press control 5 to deactivate the passenger and rear window
controls irrespective of their position.
If the button is pushed, operation is deactivated.
If the button is raised, operation is reactivated.
Automatic mode (driver's side)
F P ress the control beyond the point of
resistance to open. The driver's window
opens fully when the control is released.
F

P
ressing the control again stops the
movement of the window.
Access