2018 Peugeot iOn Owner's Manual

23
Always remove the key from the ignition
when leaving the vehicle, even for a short
time.
In the event of contact during operation of
the electric windows, you must reverse the
movement of the window. To do this, press
the corresponding control.
When operating the passenger electric
window switches, the driver must ensure
that no-one is preventing correct closing
of the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
Charging flaps
Normal charging
F Pull control A in the lower part of the dashboard, driver's side, to unlock the
access flap.
F

O
pen the access flap on the right-hand
side of the vehicle.
F

P
ress on latch B to open the socket cover.
Fast charging
(Depending on equipment.) F
P
ull control C under the driver's seat, near
the door, to unlock the access flap.
F
O
pen the access flap on the left-hand side
of the vehicle.
F
P
ress on latch D to open the socket cover.
For more information on Recharging the
main battery , refer to the corresponding
section.
2
Access

24
Front seats
Manual adjustments
1.Adjusting the height of the head restraint.
2. Adjusting the seat backrest angle.
Operate the control lever and adjust the
position of the backrest for wards or
backwards.
3. Adjusting the height of the driver's seat
cushion.
Raise or lower the control lever the
number of times required to obtain the
desired position.
4. Seat forwards-backwards adjustment.
Raise the control bar and slide the seat
forwards or backwards.
Adjusting the height of the head
restraintNever drive with the head restraints
removed and in the vehicle, they may
become projectiles in severe braking
situations - they must always be in place
and properly adjusted.
After installing the head restraint, make
sure that the height adjustment button has
properly locked in place.
The adjustment is correct when the top of
the head restraint is aligned with the top of
the head of the person seated.
Heated seat control
Press the switch on the dashboard to turn on
the driver's seat heating.
The indicator lamp in the switch comes on.
The temperature is controlled automatically.
Pressing a second time stops operation.
F

T

o raise it, pull it upwards.
F

T

o lower it, push it down while pressing the
height adjustment button.
F

T

o remove it, move it to the high position,
then remove it while pressing the height
adjustment button.
F

T

o replace it, engage the head restraint
rods in the holes while pressing the height
adjustment button.
Ease of use and comfort

25
When the seat and passenger
compartment have reached an adequate
temperature, you can switch off the
function; reducing the consumption
of electrical current reduces fuel
consumption.
Do not use the function when the seat is
e m pt y.
Prolonged use is not recommended for
those with sensitive skin.
There is a risk of burns for people whose
perception of heat is impaired (illness,
taking medication, etc.).
There is a risk of overheating the system if
material with insulating properties is used,
such as cushions or seat covers.
Do not use the system:
-

i
f wearing damp clothing,
-

i
f child seats are fitted.
To avoid breaking the heating element in
the seat:
-

d
o not place heavy objects on the seat,
-

d
o not kneel or stand on the seat,
-

d
o not place sharp objects on the seat,
-

d
o not spill liquids onto the seat.
To avoid the risk of short-circuit:
-

d
o not use liquid products for cleaning
the seat,
-
n

ever use the heating function when
the seat is damp.Rear seats
Bench seat consisting of two adjustable and
foldable backrests and a fixed seat cushion.
Rear head restraints
Never drive with passengers seated at
the rear while the head restraints are
removed; they must be in place and in the
high position.
Adjusting the seat backrest
angle
Always check that the backrest is fixed
properly.
These have a high position (for comfort and
better safety) and a low position (to give the
driver better rear visibility).
They can also be removed.
To remove a head restraint:
F
p
ull the head restraint fully upwards,
F
t
hen press on the lug. To adjust the backrest:
F

p
ull the control for wards to release the
backrest.
F

a
djust the backrest, then release the
control.
There are seven possible adjustment notches
for adjusting the angle.
3
Ease of use and comfort

26
Folding the backrest
1.Place the head restraints in the low
position or remove them if necessary.
2. Pull the control for wards to release the
seat backrest.
3. Tilt the backrest for wards.
Returning the backrest to the normal position
When returning the seat backrest to its
normal position, take care not to trap the
seat belts and their buckles.
Mirrors
Door mirrors
Adjustment
Adjustment is possible when the switch is in
position "ON" or "ACC".
F

M
ove control A to the right or to the left to
select the corresponding mirror.
F

M
ove control B in any of the four directions
to adjust the mirror.
After adjustment, return control A to the central
position.
F Put the seat backrest in the upright position and lock it in place.
F

R
efit or put the head restraints back in place.
Ease of use and comfort

27
Rear view mirrorInterior fittings
1.Glove box
2. Retractable cup holders
Press the lid to open the cup holder.
3. 12
V accessor y socket (120 W)
Obser ve the maximum power rating to
avoid damaging your accessory.
Adjust the rear view mirror by moving it
upwards, downwards and/or to the left or right.
The rear view mirror has two positions:
-

d

ay (normal),
-

n

ight (anti-dazzle).
To change from one to the other, push or pull
the lever on the lower edge of the mirror.
Electric door mirror folding/
unfolding
(Depending on version.)
F
I
gnition switch in the "ON" or "ACC"
position: press control C to unfold them.
F

I
gnition switch in the "LOCK" position: press
control C within 30
seconds to fold them.
The door mirrors can also be folded
manually.
However, they must never be unfolded
manually because they may not remain in
position when driving.
Always use control C to unfold them.
3
Ease of use and comfort

28
Mats
To take out the driver's side mat, move the seat
back as far as possible and remove the fixings.
To re-install, position it correctly on the pins
and snap on the fixings. Check that the mat is
secured correctly.To avoid any risk of jamming the pedals:
-

O
nly use mats which are suited to the
fixings already present in the vehicle;
these fixings must be used.
-

N
ever place one mat on top of another.
12 V accessory socket
F To connect a 12 V accessory (max. power:
120 W), lift the cover and connect a suitable
adaptor.
The connection of an electrical device
not approved by PEUGEOT, such as a
USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor radio
reception or inter ference with displays in
the screens.
Sun visor
Glove box
Never drive with the glove box open when
a passenger is at the front – risk of injury
in the event of sharp deceleration!
The sun visors fold for wards and sideways
when unhooked.
They are fitted with a vanity mirror and ticket
h o l d e r. 4.
Open storage compartment
5. Peugeot Connect USB – USB Player
6. Door pocket
Ease of use and comfort

29
Peugeot Connect USB – USB Player
This USB port allows the connection of a
portable device, such as an iPod® type digital
audio player, or a USB memory stick.
It reads the audio files which are sent to your
audio system, to be listened to through the
vehicle's speakers.
You can manage these files using the audio
system controls.
When connected to the USB port, the portable
device can be charged automatically.
For more information on how to use this
equipment, refer to the section on Audio
equipment and telematics .
Ventilation
System which creates and maintains good
conditions of comfort and visibility in the
vehicle's passenger compartment.
Air intake
The air circulating in the passenger
compartment is filtered and originates either
from the outside via the grille located at the
base of the windscreen or from the inside in air
recirculation mode.
Controls
The incoming air follows various routes
depending on the controls selected.
The temperature control gives you the desired
level of comfort by mixing the air of the various
circuits.
The air distribution control is used to select
the air vents to be used in the passenger
compartment.
The air flow control enables you to increase or
reduce the speed of the ventilation fan.
These controls are grouped together on control
panel A on the centre console.
Air distribution
1.Windscreen demisting/defrosting vents.
2. Front side window demisting/defrosting
vents.
3. Adjustable and closable side air vents.
4. Adjustable and closable central air vents.
5. Air outlets to the front footwells.
3
Ease of use and comfort

30
Recommendations for ventilation and air conditioning
In order for these systems to be fully effective,
follow the operation and maintenance
guidelines below:
F
I
f after an extended stop in sunshine,
the interior temperature is very high, first
ventilate the passenger compartment for a
few moments by opening the windows.
Put the air flow control at a setting high
enough to quickly change the air in the
passenger compartment.
F

T
he condensation created by the air
conditioning results in a discharge of
water under the vehicle which is per fectly
normal.
F

T
o ensure that the air is distributed evenly,
keep the external air intake grilles at the
base of the windscreen, the nozzles, the
vents, the air outlets and the air extractor
in the boot free from obstructions.
F

I
n normal conditions, use the intake
of exterior air as prolonged use of air
recirculation may cause misting of the
windscreen and side windows.
F

O
perate the air conditioning system for 5
to 10
minutes, once or twice a month to
keep it in good working order. The heating and air conditioning operate
using the energy supplied by the main
battery. Their use increases the vehicle's
consumption of electrical energy and
reduces its range.
Remember to switch off the heating or
air conditioning as soon as you judge it
to no longer be necessary.
Ventilation, heating, and air conditioning
can be activated during normal charging
of the vehicle when the ignition is set to
the ACC position.
During fast charging of the vehicle,
ventilation, heating, and air conditioning
cannot be activated.
F
E nsure that the passenger compartment
filter is in good condition and have the
filter elements replaced regularly.
F

T
o ensure correct operation of the air
conditioning system, you are also advised
to have it checked regularly.
F

I
f the system does not produce cold air,
do not use it and contact a PEUGEOT
dealer or a qualified workshop.
Ease of use and comfort