2018 Peugeot iOn Owner's Manual

47
Emergency or assistance
call
Peugeot Connect SOS
* In accordance with the general conditions of use for the ser vice available from dealers
and subject to technological and technical
limitations.
**

A
s per the geographic coverage of
"Peugeot Connect SOS", "Peugeot Connect
Assistance" and the official national
language chosen by the owner of the vehicle.
The list of countries covered and PEUGEOT
CONNECT services is available from dealers
or on the website for your country.
In an emergency, press this
button for more than 2

seconds.
The flashing green indicator lamp and the voice
message confirm that the call has been made
to the "Peugeot Connect SOS" call centre*. Pressing this button again
immediately cancels the request.
The green indicator lamp goes
of f.
The green indicator lamp remains on (without
flashing) when communication is established.
It goes off at the end of the call. expressly declined, the call is sent directly
to the emergency services (112) without the
vehicle location.
"Peugeot Connect SOS" immediately locates
your vehicle, contacts you in your own
language** and – if necessary – requests that
relevant emergency services be dispatched**.
In countries where the ser vice is not available,
or when the locating ser vice has been If an impact is detected by the airbag
control unit, and independently of the
deployment of any airbags, an emergency
call is made automatically.
If you benefit from the Peugeot Connect
Packs offer with the SOS and assistance
pack included, there are additional
ser vices available to you in your personal
space, via the website for your country.
Operation of the system
When the ignition is switched on,
the green indicator lamp comes
on for 3
seconds indicating that
the system is operating correctly.
If the orange indicator lamp
flashes then goes off: the system
has a fault.
If the orange indicator lamp is permanently on:
the back-up battery should be replaced.
In both cases, the emergency and assistance
calls ser vice may not work.
Contact a qualified repairer as soon as
possible.
The fault with the system does not prevent
the vehicle being driven.
Peugeot Connect
Assistance
Press this button for more than
2 seconds to request assistance
if the vehicle breaks down.
A voice message confirms that the call has
been made**. Pressing this button again
immediately cancels the request.
5
Safety

48
** As per the geographic coverage of "Peugeot Connect SOS", "Peugeot Connect
Assistance" and the official national
language chosen by the owner of the vehicle.
The list of countries covered and PEUGEOT
CONNECT services is available from dealers
or on the website for your country.
Geo-location
If you purchased your vehicle outside the
PEUGEOT dealer network, we invite you
to have a dealer check the configuration of
these ser vices and, if desired, modify it to
suit your wishes.
In a multi-lingual country, configuration is
possible in the official national language
of your choice. For technical reasons and in particular
to improve the quality of PEUGEOT
CONNECT ser vices to customers, the
manufacturer reser ves the right to carry
out updates to the vehicle's on-board
telematic system.
The cancellation is confirmed by a voice
message.
You can deactivate geo-location by
simultaneously pressing the "Peugeot Connect
SOS" and "Peugeot Connect Assistance"
buttons, followed by pressing "Peugeot
Connect Assistance" to confirm.
To reactivate geolocation, simultaneously press
the "Peugeot Connect SOS" and "Peugeot
Connect Assistance" buttons again, followed
by a press on "Peugeot Connect Assistance"
to confirm.
Braking assistance
systems
Group of supplementary systems which help
you to obtain optimum braking in complete
safety in emergency situations:
-

a
nti-lock braking system (ABS),
-

e
lectronic brake force distribution (EBFD),
-
em

ergency braking assistance (EBA).
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the stability and
manoeuvrability of your vehicle when braking,
in particular on poor or slippery sur faces.
Activation
The anti-lock braking system comes into
operation automatically when there is a risk of
wheel lock.
Normal operation of the ABS may make itself
felt by slight vibrations of the brake pedal.If you need to brake in an emergency,
press very firmly and maintain this
pressure.
Malfunction
Stationary vehicle If this warning lamp comes on,
it indicates an anti-lock braking
system malfunction that could cause
control of the vehicle to be lost
during braking.
Contact a PEUGEOT dealer or a qualified
workshop.
Safety

49
The warning lamp comes on for a few
seconds when switching on (ON position).
If it does not go out or come on, contact a
PEUGEOT dealer or a qualified workshop.
Moving vehicle If this warning lamp remains on
constantly, it indicates an anti-lock
braking system malfunction that
could cause control of the vehicle to
be lost during braking.
You must stop as soon as it is safe to do so.
Contact a PEUGEOT dealer or a qualified
workshop.
If both these warning lamps come
on, they indicate a malfunction in the
electronic brake force distribution
that could cause control of the
vehicle to be lost during braking.
You must stop as soon as it is safe to do so.
Contact a PEUGEOT dealer or a qualified
workshop.
When replacing wheels (tyres and rims),
ensure that they comply with manufacturer
recommendations.Emergency braking assistance
System which, in an emergency, enables you
to obtain the optimum braking pressure more
quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake
pedal is pressed.
The effect of this is a reduction in the
resistance of the pedal and an increase in
braking efficiency. In emergency braking, press very firmly
and maintain this pressure.
Trajectory control systems
Anti-slip regulation (ASR)
and dynamic stability
control (DSC)
The anti-slip regulation (also known as traction
control) optimises traction to prevent skidding of
the wheels, by acting on the brakes of the driving
wheels and on the engine.
The stability control acts on the brake of one
or more wheels and on the engine to keep the
vehicle on the trajectory required by the driver,
within the limits of the laws of physics.
Activation
These systems are activated automatically
every time the vehicle is started.
They come into operation in the event of a
problem with grip or trajectory. This is indicated by flashing of this
warning lamp in the instrument
panel.
Deactivation
In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft
ground, etc.), it may be advisable to deactivate
the ASR and DSC systems, so that the wheels
can regain grip.
F

P
ress this button until the corresponding
symbol appears in the instrument panel.
The display of this symbol indicates
that the ASR and DSC systems are
deactivated.
5
Safety

50
Excessive wheel slippage may damage
the differential of your vehicle.
Reactivation
These systems are not reactivated
automatically.
F
P
ress the button again to reactivate them
manually.
The symbol going off in the instrument panel
indicates reactivation of the ASR and DSC
systems.
Operating fault
Illumination of these warning lamps
in the instrument panel indicates
malfunction of these systems.
Contact a PEUGEOT dealer or a qualified
workshop to have the ASR /DSC systems
checked. Although the ASR /DSC systems help
improve safety in normal driving, they
should not encourage the driver to take
extra risks or drive at high speed.
The risk of loss of traction increases in
conditions of reduced grip (rain, snow,
ice). For your safety, you should therefore
keep these systems activated at all times,
particularly in poor conditions.
The correct operation of these systems
depends on observing the manufacturer's
recommendations regarding wheels (tyres
and rims), braking system components
and electronic components, as well as
assembly and repair procedures used by
the PEUGEOT dealer network.
After an impact, have these systems
checked by a PEUGEOT dealer or a
qualified workshop.
Engine brake reduction
indicator lamp
Your vehicle is equipped with a system for the
recovery of energy during deceleration which
uses the engine brake.
It recovers into the traction battery some of the
energy generated when the vehicle slows down
(e.g. on a long descent) to improve the range
of the battery and so the distance that can be
travelled between charges.
When the traction battery has been charged
fully and for the first few miles (or kilometres) of
use of the vehicle, the engine brake is reduced
temporarily.
This indicator lamp flashes on the
instrument panel, inviting you to
adapt your driving accordingly.
We therefore recommend that you anticipate
your braking as much as possible: use the
brake pedal to slow down or stop the vehicle.
Safety

51
Seat belts
Front seat belts
The front seat belts are fitted with a
pretensioning and force limiting system.
This system improves safety in the front
seats in the event of a front or side impact.
Depending on the severity of the impact, the
pretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of
the seat belt on the passenger’s chest, thus
improving their protection.
Fastening
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
The braking power is never reduced while
the indicator lamp is flashing.
Unfastening
F Press the red button on the buckle.
Front seat belt not fastened/
unfastened warning lamp
When the ignition is switched on,
this warning lamp comes on for a
few seconds, accompanied by an
audible signal, if the driver and/or
the passenger have not fastened
their seat belt. Within one minute after switching on the
ignition, if the driver does not fasten their seat
belt, this warning lamp flashes, accompanied
by an intermittent audible signal.
After about 90
seconds, the warning lamp and
the audible signal will go off, then come on
again and stay on until the driver fastens their
seat belt.
While the vehicle is in motion , if the seat belt
is unfastened, you will be notified by the same
alerts.
Rear seat belts
The rear seats are equipped with two 3 -point
seat belts each fitted with an inertia reel.
5
Safety

52
Fastening
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
Unfastening
F Press the red button on the buckle.
Seat belt unfastened warning
lamps
Rear right seat belt warning lamp.
Rear left seat belt warning lamp.
Illumination of one of these warning lamps
in the instrument panel indicates that a rear
passenger has unfastened their seat belt.
Safety

53
Advice
The driver must ensure that passengers use
the seat belts correctly and that they are all
restrained securely before setting off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do not interchange the seat belt buckles as
they will not completely fulfil their role.
The seat belts are equipped with an
inertia reel which allows the strap length
to automatically adjust to your shape. The
seat belt returns to its storage position
automatically when it is not used.
Before and after use, ensure that the seat belt
is reeled in correctly.
The lower part of the strap must be positioned
as low as possible on the pelvis.
The upper part must be positioned in the
hollow of the shoulder.
The inertia reels are fitted with a device which
automatically locks the strap in the event
of a collision or emergency braking or if the
vehicle rolls over. You can release the device
by pulling the strap firmly and then releasing it
so that it reels in slightly.In order to be effective, a seat belt:
-
M ust be tightened as close to the body as
possible,
-

M
ust be pulled in front of you with a
smooth movement, ensuring that it is not
twisted,
-

M
ust only be used to secure one person,
-

M
ust not show signs of tearing or fraying,
-

M
ust not be changed or modified, in order
to avoid affecting its performance.
In accordance with current safety regulations,
for all repairs on your vehicle's seat belts, go
to a qualified workshop with the skills and
equipment needed, which a PEUGEOT dealer
is able to provide.
Have your seat belts checked regularly by a
PEUGEOT dealer or by a qualified workshop,
particularly if the straps show signs of
damage.
Clean the seat belt straps with soapy water or
a textile cleaning product, sold by PEUGEOT
dealers.
After folding or moving a seat or a rear bench
seat, ensure that the seat belt is positioned
and reeled in correctly. Instructions for children
Use a suitable child seat, if the passenger is
less than 12
years old or shorter than one and
a half metres.
Never use the same seat belt to secure more
than one person.
Never allow a child to travel on your lap.
For more information on Child seats , refer to
the corresponding section.
In the event of an impact
Depending on the nature and seriousness
of the impacts , the pyrotechnic device may
trigger before and independently of airbag
deployment. Deployment of the pretensioners
is accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
In all cases, the airbag warning lamp comes
on.
After an impact, have the seat belt system
checked and, if necessary, replaced
by a PEUGEOT dealer or a qualified
workshop.
5
Safety

54
Airbags
The airbags do not operate when the
ignition is switched off.
This equipment will only deploy once. If a
second impact occurs (during the same or
a subsequent accident), the airbag will not
be deployed again.
Impact detection zones
A.Front impact zone.
B. Side impact zone.
Airbag deployment generates slight
smoke emissions and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
This smoke is not harmful, but sensitive
individuals may experience slight irritation.
The detonation noise associated with the
deployment of an air bag may result in a
slight loss of hearing for a short time.
The airbags are designed to help enhance the
safety of occupants in the event of a serious
collision. They complement the action of the
safety belts equipped with force limiters.
If a collision occurs, the electronic detectors
record and analyse the front and side impacts
sustained in the impact detection zones:
-

i

f there is a violent impact, the airbags
deploy instantly and help better protect
occupants of the vehicle; immediately after
the impact, the airbags deflate rapidly
in order not to hinder the visibility or the
possible exit of the occupants.
-

i

n the case of a minor or rear impact or in
certain roll-over conditions, the airbags
may not be deployed; the seat belt
alone contributes towards ensuring your
protection in these situations.
Front airbags
This system protects the driver and front
passenger from the risk of injury to the head
and chest in the event of a severe frontal
impact.
The driver's airbag is fitted in the centre of the
steering wheel; the front passenger's airbag is
fitted in the dashboard above the glove box.
Activation
The airbags are deployed (except the
passenger's front airbag if it is deactivated) in
the event of a severe frontal impact to all or part
of the frontal impact zone A , in the longitudinal
centreline of the vehicle on a horizontal plane
and directed from the front to the rear of the
vehicle.
The front airbag inflates between the front
occupant of the vehicle and the dashboard, to
cushion their forward movement.
Safety