2018 HYUNDAI I20 Owners Manual

29
"&t%'s%st&'!"'%!'&&

Installing a child restraint systemby lap\fshoulder belt
To install a child restraint system on
the outboard or center rear seats, do
the following:
1. Place the child restraint system in
the seat and route the lap\fshoul
der belt around or through the
restraint, following the restraintmanufacturer’s instructions. Be
sure the seat belt webbing is not
twisted. 2. Fasten the lap\fshoulder belt latch
into the buckle. Listen for the dis
tinct “click” sound.Position the release button so that it is easy to access in case of an emergency.
3. Buckle the seat belt and allow the seat belt to take up any slack. After
installation of the child restraint
system, try to move it in all direc
tions to be sure the child restraint
system is securely installed.
If you need to tighten the belt, pull
more webbing toward the retractor.
When you unbuckle the seat belt and
allow it to retract, the retractor will
automatically revert back to its nor
mal seated passenger emergency
locking usage condition.
MMSA3030E2BLD310
E2MS103005


"&t%'s%st&'!"'%!'&&
Child seat restraint suitability for seat position using the seat belt
Use child safety seats that have been officially approved and are appropriate for your children. When using the child safety seats,
refer to the following table.
For 60:40 split rear seat
For bench type rear seat (without 60:40 split rear seat)
Age groupSeating position
Co Driver Rear Left Rear Right Rear center
0 : Up to 10 kg UU
0\b : Up to 13 kg UU
I : 9 kg to 18 kg UU
II : 15 kg to 25 kg UU
III : 22 kg to 36 kg UU
U : Suitable for "universal" category restraints approved for use in this mass group
Remarks: Front LH Seat upright. Rearmost position. Seat belt shoulder anchorage to
lowest position.
Age group Seating position
Co Driver Rear Left Rear Right Rear center
0 : Up to 10 kg UUU
0\b : Up to 13 kg UUU
I : 9 kg to 18 kg UUU
II : 15 kg to 25 kg UUU
III : 22 kg to 36 kg UUU

1
"&t%'s%st&'!"'%!'&&

# "#G
!$M$N%#!"$
%"# N%

%$M(
"
)
The actual air bags in the vehicle may differ from the illustration.
1. Driver’s front air bag*
2. Passenger’s front air bag*
3. Side impact air bag*
4. Curtain air bag*
* : if equipped
OIB037032R

2
"&t%'s%st&'!"'%!'&&
How does the air bag system
operate
• Air bags are activated (able to
inflate if necessary) only when the
ignition switch is placed to the ON
or START position.
• Air bags inflate instantly in the event of serious frontal or side col
lision in order to help protect the
occupants from serious physical
injury.
• There is no single speed at which the air bags will inflate.
Generally, air bags are designed to
inflate based upon the severity of a
collision and its direction. These
two factors determine whether the
sensors produce an electronic
deployment\f inflation signal.
• Air bag deployment depends on a number of factors including vehicle
speed, angles of impact and the
density and stiffness of the vehi
cles or objects which your vehicle
hits in the collision. The determin
ing, factors are not limited to those
mentioned above. • The front air bags will completely
inflate and deflate in an instant.
It is virtually impossible for you to
see the air bags inflate during an
accident.
It is much more likely that you will
simply see the deflated air bags
hanging out of their storage com
partments after the collision.
• In order to help provide protection in a severe collision, the air bags
must inflate rapidly. The speed of
air bag inflation is a consequence
of extremely short time in which a
collision occurs and the need to
get the air bag between the occu
pant and the vehicle structures
before the occupant impacts those
structures. This speed of inflation
reduces the risk of serious or life
threatening injuries in a severe col
lision and is thus a necessary part
of air bag design.
However, air bag inflation can also
cause injuries which can include
facial abrasions, bruises and bro
ken bones because the inflation
speed also causes the air bags to
expand with a great deal of force.•Even in vehicles with air bags,
you and your passengers must
always wear the safety belts pro
vided in order to minimize the risk
and severity of injury in the event
of a collision or rollover.
•SRS and pretensioners contain
explosive chemicals.
If scraping a vehicle without
removing SRS and pretensioners
from a vehicle, it may cause fire.
Before scraping a vehicle, we
recommend that you contact an
authorized HYUNDAI dealer.
•Keep the SRS parts and wirings
away from water or any liquid. If
the SRS components are inoper
ative due to exposure to water or
liquids, it may cause fire or severe
injury.
WARNING


"&t%'s%st&'!"'%!'&&

• There are even circumstancesunder which contact with the steer
ing wheel air bag can cause fatal
injuries, especially if the occupant is
positioned excessively close to the
steering wheel.Noise and smoke
When the air bags inflate, they make
a loud noise and they leave smoke
and powder in the air inside of the
vehicle. This is normal and is a result
of the ignition of the air bag inflator.
After the air bag inflates, you may
feel substantial discomfort in breath
ing due to the contact of your chest
with both the seat belt and the air
bag, as well as from breathing the
smoke and powder. Open your doors
and\for windows as soon as possible
after impact in order to reduce dis
comfort and prevent prolonged expo
sure to the smoke and powder.
Though smoke and powder are non
toxic, it may cause irritation to the
skin (eyes, nose and throat, etc.). If
this is the case, wash and rinse with
cold water immediately and consult
with the doctor if the symptom per
sists.
•To avoid severe personal injury
or death caused by deploying air
bags in a collision, the driver
should sit as far back from the
steering wheel air bag as possi
ble. The front passenger should
always move their seat as far
back as possible and sit back in
their seat.
•Air bag inflates instantly in an
event of a collision, passengers
may be injured by the air bag
expansion force if they are not in
a proper position.
•Air bag inflation may cause
injuries including facial or bodily
abrasions, injuries from broken
glasses or burns.
When the air bags deploy, the air
bag related parts in the steering
wheel and\for instrument panel
and\for in both sides of the roof
rails above the front and rear
doors are very hot. To prevent
injury, do not touch the air bag
storage areas internal compo
nents immediately after an air bag
has inflated.
WARNING
WARNING


"&t%'s%st&'!"'%!'&&
Do not install a child restraint on
the front passenger’s seat.
(if equipped)
Never place a rearfacing child
restraint in the front passenger’s
seat. If the air bag deploys, it would
impact the rearfacing child restraint,
causing serious or fatal injury.
In addition, do not place frontfacing
child restraints in the front passen
ger’s seat either. If the front passen
ger air bag inflates, it would cause
serious or fatal injuries to the child.
Air bag warning and indicator
(if equipped)
Air bag warning light
The purpose of the air bag warning
light in your instrument panel is to
alert you of a potential problem with
your air bag Supplemental Restraint
System (SRS).
OYDESA2042
•NEVER use a rearward facing
child restraint on a seat protect
ed by an ACTIVE AIR BAG in
front of it, DEATH or SERIOUS
INJURY to the CHILD can
occur.
•Never put a child restraint in the
front passenger’s seat. If the
front passenger air bag inflates,
it would cause serious or fatal
injuries.
•When children are seated in the
rear outboard seats of vehicle
equipped with curtain air bags,
be sure to install the child
restraint syst

em as far away
from the door side as possible,
and securely lock the child
restraint system in position.
Inflation of curtain air bags could
cause serious injury or death to
an infant or child.
WARNING
W7147


"&t%'s%st&'!"'%!'&&

When the ignition switch is turned
ON, the warning light should illumi
nate for approximately 6 seconds,
then go off.
Have the system checked if:
• The light does not turn on brieflywhen you turn the ignition ON.
• The light stays on after illuminating for approximately 6 seconds.
• The light comes on while the vehi cle is in motion.
• The light blinks when the ignition switch is in ON position.SRS components and functions
The SRS consists of the following
components:
(1) Driver's front air bag module*
(2) Passenger's front air bag module*
(3) Pretensioner seatbelt system*
(4) Air bag warning light*
(5) SRS control module (SRSCM)*
(6) Front impact sensors*
(7) Side impact air bag modules*
(8) Curtain air bag modules *
(9) Side impact sensors *
* : if equipped The SRSCM continuously monitors
all SRS components while the igni
tion switch is ON to determine if a
crash impact is severe enough to
require air bag deployment or pre
tensioner seat belt deployment.
The SRS air bag warning light on the
instrument panel will illuminate for
about 6 seconds after the ignition
switch is turned to the ON position,
after which the air bag warning light
should go out.
OIB034043\fQ


"&t%'s%st&'!"'%!'&&The air bag modules are located
both in the center of the steering
wheel and in the front passenger's
panel above the glove box. When the
SRSCM detects a sufficiently severe
impact to the front of the vehicle, it
will automatically deploy the front air
bags. Upon deployment, tear seams mold
ed directly into the pad covers will
separate under pressure from the
expansion of the air bags. Further
opening of the covers then allows full
inflation of the air bags.
If any of the following conditions
occurs, this indicates a malfunc
tion of the SRS. We recommend
that the system be inspected by
an authorized HYUNDAI dealer.
•The light does not turn on briefly
when you turn the ignition ON.
•The light stays on after illuminat
ing for approximately 6 seconds.
•The light comes on while the
vehicle is in motion.
•The light blinks when the ignition
switch is in ON position.
WARNING
B240B01L

Driver’s front air bag (1)
B240B02L
Driver’s front air bag (2)