2018 FIAT 500 brake sensor

19
ESC SYSTEM (for versions/markets, where required)
The warning light switches on when the ignition key is turned to MAR, but it should switch off after a few seconds.
ESC system activation
Flashing of the warning light while driving indicates the intervention of the ESC system.
ESC system failure
If the warning light does not go off or stays on together with the LED on the ASR OFF button while driving.
The display will show a dedicated message.
Contact a Fiat Dealership.
Hill Holder failure
This warning light switches on, on some versions together with a dedicated message on the display, in the event of a Hill
Holder system fault.
In this case, contact a Fiat Dealership as soon as possible. Parking sensor fault
The warning light turns on and the dedicated message is shown on the display when a parking sensor fault is detected.
Start&Stop system fault (versions with multifunction display)
A fault of the system is indicated by the warning light switching on. A dedicated message will appears on the instrument
panel.
Airbag warning light fault (for versions/markets, where provided)
The warning light will blink when a fault of the
¬warning light is detected.
ESCESC
BRAKE PAD WEAR
The warning light switches on, together with a dedicated message on the display, if the front or rear brake pads (on
version/markets, where provided) are worn.
In this case have them replaced as soon as possible.
dd
POSSIBLE ICE ON ROAD
The symbol is shown on the display (on some versions together with a dedicated message) when the outside temperature
is equal to or below 3°C.
èè
(versions with
multifunction
display)
(versions with
multifunction
display)

IN AN EMERGENCY
142
FuseAmpereDescription
F13 5 •
Left dipped headlight and headlight alignment control unit power supply
F36 15 Diagnosis socket, radio, climate control, EOBD
F37 5 Brake light switch, instrument panel node
F38 15 Central door locking
F43 15 Windscreen/rear window washer pump
F47 20 Driver’s side power window
F48 20 Passenger’s side power window
F49 5 Parking sensor, control backlighting, electric mirrors
F51 7.5 Climate control, brake lights, clutch, sunroof, electric mirrors
F53 5 Instrument panel node
•
For versions/markets, where provided
ENGINE COMPARTMENT
JUNCTION BOX
The fuse box is located on the right
side of the engine compartment.
To access the fuses, proceed as
follows:
❒ Fully press the screw A fig. 130;
❒ at the same time slowly rotate the
screw anticlockwise, until resistance
is encountered (do not overtighten);
❒ slowly release the screw;
❒ opening is indicated by the entire
screw head coming out of its
housing;
❒ remove cover B, sliding it upwards
on the side guides, as indicated in
the figure.
❒ after replacing the fuse, refit the
cover, making sure that it is closed
properly.
130DVDF0S0201c

IMPORTANT INFORMATION AND RECOMMENDATIONS
190(CONTINUES)
PERSONAL SAFETY
(CONTINUED)
•The HH system is not a parking brake, therefore do not leave
the vehicle without activating the handbrake, switching off the
engine, and engaging first gear, with the vehicle parked in safe
conditions.
•There may be situations on small gradients
(less than 8%), with car laden or a trailer attached to it (where
provided), in which the HH system may not activate, causing a
slight reversing motion and increasing the risk of collision with
another vehicle or object.
The driver is, in any case, responsible for safe driving.
•The HBA system cannot increase tyre grip on the road over
the limits imposed by laws of physics: always drive carefully
according to the conditions of the road surface.
•The HBA system is an aid for the driver, who must always pay
full attention while driving.
The responsibility always rests with the driver.
16) ENGINE BONNET
•Before opening the bonnet, check that windscreen wiper
arm is not lifted from the windscreen.
•The bonnet may drop suddenly if the supporting rod is not
positioned correctly.
Only perform these operations when the car is stationary.
•Be careful working inside engine compartment when the
engine is hot to avoid burning yourself. Do not place your
hands near the engine fan as it may be activated even when
the key is removed. Wait until the engine has cooled.
•Be very careful not to allow scarves, neck ties and other
loose articles of clothing from touching, even accidentally, any
moving parts. This may cause the clothing to be pulled into the
part, resulting in serious injury to the wearer. •For safety reasons, the bonnet must always be properly closed
while the car is travelling. Make sure that the bonnet is properly
closed and that the lock is engaged. If you notice when driving
that the bonnet has not been properly locked, stop immediately
and close the bonnet correctly.
•Use both hands to lift the bonnet. Before lifting, check that the
windscreen wiper arms are not raised from the windscreen, that
the vehicle is stationary and that the handbrake is engaged.
17) CONTROLS
•It is absolutely forbidden to carry out any after-market operation
involving steering system or steering column modifications
(e.g. installation of anti-theft device) that could adversely affect
performance and safety, invalidate the warranty and also result in
non-compliance of the vehicle with type-approval requirements.
•Before performing any maintenance operations, always stop
the engine and remove the key from the ignition to lock the
steering column (especially when the car wheels are not touching
the ground). If this is not possible (for example if the key needs to
be turned to MAR or the engine must be running), remove the
main fuse that protects the electric power steering.
18) PARKING SENSORS
Parking manoeuvres, however, are always the driver’s
responsibility. While carrying out these manoeuvres, always make
sure that no people (especially children) or animals are in the area
concerned.
The parking sensors are used to assist the driver, who must
never allow his attention to lapse during potentially dangerous
manoeuvres, even those executed at low speeds.