2018 FIAT 500 door lock

KNOWING YOUR CAR
14
R
S
DOORS/BONNET/LUGGAGE COMPARTMENT OPEN (colour display)
The symbols appear on the display, together with a dedicated message, on some versions, when one or more doors, the
tailgate or the bonnet
(for versions/markets, where provided) are not properly closed.
An acoustic signal is also emitted with the doors open and the car in motion.
R
S
“DUALOGIC” GEARBOX FAULT (for versions/markets, where provided)
When the ignition key is turned to MAR, the warning light switches on but should switch off after a few seconds.
The warning light comes on flashing, along with a dedicated message on the display and an acoustic signal, to indicate a
gearbox fault.
SEAT BELTS NOT FASTENED
The warning light switches on constantly with the vehicle stationary and the driver’s side or passenger side seat belt
(when the passenger is present) not fastened.
The warning light will flash and a buzzer will sound if the car is in motion and the front seat belts are not correctly fastened.
For permanent deactivation of the acoustic signal (buzzer) of the S.B.R. (Seat Belt Reminder) system contact
a Fiat Dealership. The system can be reactivated at any time using the Setup Menu.
<<
EBD FAULT (Multifunction display)
The simultaneous switching on of the warning lights with the engine on indicates either a failure of the EBD system or that
the system is not available. In this case, the rear wheels may suddenly lock and the vehicle may swerve when braking
sharply.
On some versions the display shows the dedicated message.
Drive very carefully to a Fiat Dealership to have the system inspected.
x
>x
>

27
HEADLIGHT
ALIGNMENT
With the ignition key at MAR and
dipped beam headlights on, press the
+ button to adjust the headlights
upwards and the – button to adjust the
headlights downwards.
TYRE RESET (ITPMS
RESET)
(for versions/markets, where provided)
With this function it is possible to reset
the iTPMS (see paragraph “iTPMS”). To
carry out the Reset procedure proceed
as follows:
❒ briefly press the MENU
N; the
display will show “Reset”;
❒ press button + or – to select (“Yes”
or “No”); a dedicated reset
confirmation message will appear;
❒ briefly press the MENU
N; the
display will show “Confirm”;
THE KEYS1)
1) 1)
CODE CARD
(for versions/markets, where provided)
The car is delivered with two copies of
the ignition key and with the CODE
card fig. 7 which bears the following:
A: the electronic code;
B: the mechanical key code to be given
to the Fiat Dealership when ordering
duplicate keys.
You should have the electronic code
with you at all times.
IMPORTANT All the keys and the
CODE card must be handed over to
the new owner when selling the car.
MECHANICAL KEY
The metal insert A-fig. 8 operates:
❒ the ignition switch;
❒ the door locks and the tailgate (for
versions/markets, where provided);
❒ the locking/unlocking of the fuel
cap.
KEY WITH REMOTE
CONTROL
(for versions/markets, where provided)
The metal insert A-fig. 9 operates:
❒ the ignition switch;
❒ the door locks;
❒ the locking/unlocking of the fuel
cap.
7DVDF0S0103c
8DVDF0S0104c

KNOWING YOUR CAR
28
FIAT CODE
SYSTEM
The Fiat Code system is an electrical
engine immobiliser system which
increases protection against attempted
car theft. It is automatically activated
when the ignition key is removed.
Each time the vehicle is started by
turning the ignition key to MAR, the Fiat
CODE system control unit sends a
recognition code to the engine control
module to deactivate the immobiliser.
If, during ignition, the code is not
correctly recognized, a warning light
is lit on the instrument panel .
In this case, turn the key to STOP and
then to MAR-ON; if it is still locked, try
again with the other keys that come
with the car.
Contact a Fiat Dealership if you still
cannot start the engine.
NOTE Each key has its own code
which must be stored by the control
unit of the system.
Contact a Fiat Dealership to have new
keys (up to 8) stored with a code.
IGNITION
DEVICE
The key can be turned to three
different positions fig. 10:
❒ STOP: engine stopped, key can be
removed, steering column locked.
Some electrical devices (e.g. audio
system, central door locking
system, etc.) can operate;
❒ MAR: driving position.
All electrical devices are enabled;
❒ AVV: engine starting.
The ignition device is fitted with a
safety system that requires the ignition
key to be turned back to STOP if the
engine does not start, before the
starting operation can be repeated.
10DVDF0S011c
Pressing button B opens/closes the
metal insert.
Briefly press button
Ë: for unlocking of
doors and tailgate, timed switching-on
of interior lights and double flashing of
direction indicators (for
versions/markets, where provided).
Briefly press button
Á: for remote
locking of doors and tailgate,
switching-off of the internal ceiling
lights and single flashing of direction
indicators (for versions/markets, where
provided).
Press the Rbutton: remote opening
of the luggage compartment and
double flashing of the direction
indicators.
9DVDF0S0105c

43
❒ The activation of the heated rear
windscreen, upon request by the
user, is carried out only if the soft
top is completely closed. If the soft
top is closed incorrectly, the heated
rear window does not operate and
the relevant warning light does not
come on.
❒ When the soft top is opened using
the relevant control, if the heated
rear windscreen had been engaged
it is automatically deactivated and
the warning light switches off.
❒ Do not remove ice from the soft top
with sharp items.
❒ Do not use scrapers or sprays to
remove ice from the heated rear
window to prevent damage.
❒ Do not put objects on the top: they
could fall if the top is operated
causing damage and injury.
❒ It is advisable to cover the top with
a protective sheet if the car is left
parked in the open for a long time.❒ Do not keep the soft top folded for
a long time: this could cause folds
and creases in the fabric.
❒ Before moving the soft top, check
that there is enough room to carry
out the operation and that there are
no obstacles or people close to the
moving parts of the soft top.
❒ The cooled air flow into the
passenger compartment may
decrease if the automatic climate
control system is on and the top is
not all closed.
❒ With the top open and the car
travelling, the speech recognition
system may be recognised voice
controls because of the background
noise: then the top is closed the dial
number command may not be
recognised.DOORS
12) 9)
To open manually from outside
(driver side door)
From outside, insert the key, turn it in
direction 1 fig. 38 and pull the handle. If
the car has central locking, turning the
key opens all the locks.
38DVD F0S0109c

KNOWING YOUR CAR
44
To open manually from outside
(passenger side door)
Pull the handle. Opening the door is
permitted only if the internal handle is in
position 1 fig. 39.
Manual locking from outside
With the driver side door wing closed,
insert the key and turn in direction
2 fig. 38.
If the car has central locking, turning
the key simultaneously closes all the
locks.
The passenger side door can only be
locked from inside, by bringing the
handle to position 2 fig. 39 (red area
A visible).
39DVD F0S0110c
Locking/unlocking from inside
Operate the handles on the door
panels fig. 39:
– position 1: door unlocked.
– position 2: door unlocked.
If the car features central locking,
operating the driver or passenger side
handle lock/unlocks all the doors.
With remote control
Press the ;button: door locking.
Press the :button: door unlocking.ELECTRIC
WINDOWS
10)
These operate when the ignition key is
turned to MAR and for about 2 minutes
after turning the key to STOP or
removing it.
The electric window control buttons
fig. 40 are located beside the gear
lever.
A Opening/closing of the left window.
B Opening/closing of the right window.
Hold the button raised for a few
seconds to wind the window up
automatically or hold is pressed to wind
the window down automatically (with
the key at MAR only).
40DVDF0S177c

45
BOOT 13)
ELECTRIC HANDLE
(SOFT TOUCH)
❒ Operate the electric handle A-fig. 41
to open the tailgate.
❒ To release the lock manually, use
the metal insert of the ignition key.
❒ To release the lock with the remote
control, press button R.
❒ To close, use the handle located
inside the tailgate.
❒ If the tailgate is not shut properly the
dedicated instrument panel or
colour display warning light (where
provided) will switch on.
41DVDF0S025c
Opening the tailgate with soft top
all open
❒ Pressing the tailgate opening
one-touch button A-fig. 41 to
automatically close the soft top to
spoiler position. The tailgate can be
opened in spoiler position.
Hatchback emergency opening
To open the tailgate from the
passenger compartment if the car
battery is run down or the electric
tailgate lock is faulty, proceed as
follows:
❒ remove the rear head restraints;
❒ fold the seat backrests over;
❒ press lever A-fig. 42 inside the
luggage compartment.
42DVDF0S026c
ROOF RACK/SKI
RACK 14) 7)
FASTENERS
The fasteners are located in the areas
shown in fig. 43.
To use the front fasteners, remove the
cap A fig. 43, accessible with the door
open.
The rear fixing areas B can be found
according to measurements shown in
fig. 44.
Lineaccessori Mopar
®at provides a
specific roof rack/ski rack for the
tailgate.
43DVDF0S178c

KNOWING YOUR CAR
46
IMPORTANT Follow the instructions
contained in the assembly kit carefully.
Assembly must be performed by
qualified personnel.
44DVDF0S150c
BONNET 16)
To open the bonnet:
❒ Pull lever A-fig. 45 in front of the
driver’s door.
❒ move the release lever B in the
direction of the arrow and then lift
the bonnet and locate the safety
prop.
45DVDF0S027c
❒ Insert the safety prop in its housing
A-fig. 46 integral to the bonnet.
❒ To close the bonnet, remove the
bonnet stay and put it back in its
own locking device, slowly lower
the bonnet to about 20 cm from the
engine compartment, then let it
drop into position and check that it
is completely closed. If not, repeat
the procedure.
46DVDF0S028c

51
FUEL CUT-OFF
SYSTEM 8)
This intervenes in the case of an
impact causing:
❒ the fuel supply cut-off with the
engine consequently switching off
❒ automatically unlocking the doors
❒ switching on of all interior lights.
The intervention of the system is
indicated by a message shown on the
display.
IMPORTANT Carefully check the car
for fuel leaks, for instance in the engine
compartment, under the car or near
the tank area.
After a collision, turn the ignition key to
the STOP position to avoid draining the
battery.
To reset car operation, follow this
procedure:
❒ turn the ignition key to MAR
❒ activate the right direction indicator
❒ deactivate the right direction
indicator
❒ activate the left direction indicator
❒ deactivate the left direction indicator
❒ activate the right direction indicator
❒ deactivate the right direction
indicator
❒ activate the left direction indicator
❒ deactivate the left direction indicator
❒ ignition key turned to the OFF
position
❒ turn the ignition key to MAR.PARKING SENSORS
18) 25
(for versions/markets, where provided)
Located in the rear bumper fig. 51
these detect and inform the driver,
through an intermittent acoustic signal,
of the presence of obstacles at the rear
of the car.
As the distance from the obstacle
behind the car decreases, the acoustic
alarm becomes more frequent. The
buzzer becomes continuous when the
distance separating the vehicle from
the obstacle is less than about 30 cm.
It remains constant if the distance
between the vehicle and the obstacle
is unchanged.
If this situation concerns the side
sensors, the signal will stop after
approximately 3 seconds to avoid, for
example, indications in the event of
manoeuvres along a wall.
If several obstacles are detected by the
sensors, only the nearest one is
considered.