IN AN EMERGENCY
130
❒ Fit the handle to operate the jack
and raise the car until the wheel is a
few centimetres above the ground.
When turning the jack handle, make
sure that it can turn freely without
scraping your hand against the
ground. The moving components of
the jack (screws and joints) can also
cause injuries: avoid touching them.
If you come into contact with
lubricating grease, clean yourself
thoroughly.
❒ Loosen the bolts completely and
remove the wheel to be replaced.
❒ Make sure the contact surfaces
between space-saver wheel and
resting surfaces are clean so that
the fastening bolts will not come
loose.
❒ Fit the space-saver wheel aligning
the pin with one of the holes on the
wheel.
❒ Tighten the 4 fixing bolts, turn the
jack handle to lower the car and
remove the jack.
❒ Fasten the bolts completely,
passing alternately from one bolt to
the opposite one.REFITTING THE WHEEL
32) 40)
Versions with steel wheels
❒ Make sure the contact surfaces
between standard wheel and hub
are clean so that the fastening bolts
will not come loose.
❒ Fit the standard wheel inserting the
4 bolts into the holes, then tighten
them.
❒ Lower the car and remove the jack.
❒ Use the wrench provided to fully
tighten the bolts, passing alternately
from one bolt to the opposite one;
❒ Insert the pressure-fit cup making
the suitable slot coincide with the
inflation valve;
❒ Place the inner part of the hub cap
on the wheel rim;
❒ Engage the hub cap by applying an
axial force in several points as
shown in fig. 104 to allow the
correct coupling between hub cap
and wheel.
Versions with alloy wheels
❒ Place the wheel onto the hub and
tighten the bolts using the wrench
provided.
❒ Lower the car and remove the jack.
❒ Using the spanner provided, fully
tighten the bolts.
❒ Reinsert the press-fitted hub cap,
making sure that the reference hole
on the wheel is aligned with the
reference pin on the cap.
IMPORTANT: if it is not fitted correctly,
the hub cap may detach when the car
is running.
104DVDF0S461c
