2017 Peugeot 208 Owner's Manual

63
Sunroof blind
Opening
F Take the blind by its handle and push it rearward to the desired position.
Locking
F Take the blind by its handle and pull it for ward to the desired position.
Interior fittings
Mats
Fitting
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on the
carpet.
3
Ease of use and comfort

64
Removal
To remove the mat on the driver's side:
F m ove the seat as far back as possible,
F

un
clip the fixings,
F

r
emove the mat.
Refitting
To refit the mat on the driver's side:
F p osition the mat correctly,
F

p
ut on the fixings again by pressing,
F

c
heck that the mat is secured correctly.
To avoid any risk of jamming of the pedals:
-

o
nly use mats which are suited to the
fixings already present in the vehicle;
these fixings must be used,
-

n
ever place one mat on top of another.
The use of mats not approved by
PEUGEOT may inter fere with access to
the pedals and hinder the operation of the
cruise control / speed limiter.
The mats approved by PEUGEOT have
two fixings located below the seat.
12 V accessory socket
F To connect a 12 V accessory (maximum
power: 120 Watts), lift the cover and
connect a suitable adaptor.
Do not exceed the maximum power rating
of the socket (risk of damage to your
device).
The connection of an electrical device
not approved by PEUGEOT, such as a
USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor telephone
reception or inter ference with displays in
the screens.
USB port/Jack auxiliary socket
This connection box, consisting of a USB port
and a JACK auxiliary socket is located on the
centre console.
You can connect a portable device, such as a
digital audio player e.g. iPod
® or USB memory
stick.
It reads the audio files which are transmitted to
your audio system and played via the vehicle's
speakers.
You can manage these files using the steering
mounted controls or the audio system control
panel and display them on the screen.
When the USB port is used, the portable
device charges automatically.
While charging, a message is displayed if the
power consumption of the portable device
exceeds the amperage supplied by the vehicle.
Ease of use and comfort

65
Boot fittings1.Rear shelf
2. Hooks
3. Boot lamp
4. Stowing rings (depending on version)
Rear shelf
To remove the shelf:
F
u nhook the two cords,
F

g
ently lift the shelf, then remove it.
3
Ease of use and comfort

66
To stow it:
To refit the shelf:
F
e
ngage it on each side of the supports and
slide it until it reaches the notches,
F

r
aise it to refit the two cords.When sharp deceleration occurs, objects
placed on the load space cover can turn
into projectiles.
-
v

ertically behind the rear seats,
-
v

ertically behind the front seats.
Ease of use and comfort

67
Lighting control stalk
Travelling abroad
If planning to use your vehicle in a country
that drives on the other side of the road,
the headlamp dipped beams must be
adjusted to avoid dazzling oncoming
drivers. Contact a PEUGEOT dealer or a
qualified workshop.
Selection of main lighting
mode
Turn the ring to align the desired symbol with
the marking.Lighting off (ignition off) / Front
daytime running lamps (engine
running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Dipping the headlamps
Pull the lever to switch the lighting between
dipped and main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by keeping the
lever pulled.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
4
Lighting and visibility

68
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
If the lighting is switched off automatically
(version with AUTO lighting) or the dipped
beams are switched off manually, the foglamps
and sidelamps remain on.
F

T
urn the ring rear wards to switch off the
foglamps, the sidelamps will then switch off. In good or rainy weather, both day and
night, using the front foglamps and the
rear foglamp is prohibited. In these
situations, the power of their beams may
dazzle other drivers. They should only be
used in fog or falling snow.
In these weather conditions, it is your
responsibility to switch on the foglamps
and dipped beam headlamps manually as
the sunshine sensor may detect sufficient
light.
Do not forget to turn off the front foglamps
and the rear foglamp as soon as they are
no longer necessary.
Switching off of the lighting when the
ignition is switched off
On switching off the ignition, all of the
lighting turns off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated.
Switching on the lighting after the
ignition is switched off
To reactivate the lighting control, set the
ring to 0 – lamps off, then to the desired
position.
When the driver's door is opened, a
temporary audible signal warns you that
the vehicle's lighting is on.
The lamps, with the exception of the
sidelamps, switch off automatically after
a maximum duration of 30
minutes to
prevent discharging of the battery.
Direction indicators
F Lower the lighting control stalk fully when turning left.
F

R
aise the lighting control stalk fully when
turning right.
Lighting and visibility

69
Three flashes
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
three times.This function can be used at any speed,
but it is particularly useful for changing
lane on fast roads.
Automatic illumination of
headlampsIf you forget to cancel the direction
indicators for more than 20 seconds, the
volume of the audible signal will increase if
the speed is above 40
mph (60 km/h).When a low level of ambient light is detected
by a sunshine sensor, the number plate lamps,
sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver. They can also come
on if rain is detected, at the same time as
automatic operation of the windscreen wipers.
As soon as the brightness returns to a
sufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Switching on
F Turn the ring to the AUTO
position.
Activation of the function is accompanied by
a message in the screen.
Switching off
F Turn the ring to another position. Deactivation of the function is accompanied
by a message in the screen.
In fog or snow, the sunshine sensor may
detect sufficient light. In this case, the
lighting will not come on automatically.
Do not cover the sunshine sensor, linked
with the rain sensor and located in the
centre of the windscreen behind the rear
view mirror; the associated functions
would no longer be controlled.
Automatic guide-me-home
lighting
Association with automatic illumination of
headlamps provides the guide-me-home
lighting with the following additional options:
-

s
election of the lighting duration of 15, 30 or
60


seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation.
4
Lighting and visibility

70
The guide-me-home lighting can be
configured in the menu Driving /
Vehicle.
In the event of a malfunction of the
sunshine sensor, the lighting comes
on, this warning lamp is displayed
in the instrument panel and/or a
message appears in the screen,
accompanied by an audible signal.
Contact a PEUGEOT dealer or a
qualified workshop.
Manual guide-me-home
lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual guide-me-home lighting
is also available from the remote
control lighting button.
Switching off
Manual guide-me-home lighting goes off
automatically at the end of a given period of
time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.
F

W
ithin one minute after switching off the
ignition, operate the lighting control stalk
up or down depending on the traffic side
(example: parked on the right; lighting
control stalk downwards; the left-hand
sidelamp comes on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Lighting and visibility