2017 MAZDA MODEL 2 Owners Manual (in English)

8–21
Customer Information
Declaration of Conformity

8–22
Customer Information
Declaration of Conformity
Distance Recognition Support System (DRSS)/Mazda Radar Cruise Control
(MRCC)/Smart Brake Support (SBS)

8–23
Customer Information
Declaration of Conformity

8–24
Customer Information
Declaration of Conformity

8–25
Customer Information
Declaration of Conformity
For Vehicles sold in Moldova
MODEL: DNMWR006

8–26
Customer Information
Electromagnetic Compatibility
Electromagnetic Compatibility
Your Mazda has been tested and certi¿ ed to the UNECE *1 10 regulation as related to
electromagnetic compatibility. Radio Frequency (RF) transmitter equipment (e.g. cellular
telephones, amateur radio transmitters, etc.) may only be ¿ tted to your Mazda if they
comply with the parameters shown in the table below.

*1 UNECE stands for United Nations Economic Commission for Europe.

It is your responsibility to ensure that any equipment you have ¿ tted complies with
applicable local legislations. Have any equipment ¿ tted by properly trained technicians.
CAUTION

 Do not mount any transceiver, microphones, speakers, or any other item in the
deployment path of the air bag system.
  Do not fasten aerial lead to original vehicle wiring, fuel pipes or brake pipes. Avoid
running the aerial lead parallel with the wire harness to the best extent possible.
  Keep the aerial and power leads at least 100 mm (3.9 in) from any electronic modules
and the air bags.
  Avoid using the cigar lighter or accessory socket as a power source for the RF-
transmitting equipment.

8–27
Customer Information
Electromagnetic Compatibility

Aerial positions:
: front right of roof
: front left of roof
: centre of roof
: both sides of liftgate (Hatchback)

Frequency Band (MHz) Maximum output power (Wattage) Aerial Positions
50 — 54 50


68 — 87.5 50


142 — 176 50


380 — 470 50


806 — 940 10


1200 — 1300 10


1710 — 1885 10


1885 — 2025 10


2400 — 2500 0.01 *1 In a cabin *1
*1 Only for Bluetooth
®

NOTE
After the installation of RF transmitters, check for disturbances from and to all electrical
equipment in the vehicle, both in the standby and transmit modes.
Check all electrical equipment:
 
 with the ignition ON 
 with the engine running 
 during a road test at various speeds.

8–28
Customer Information
Collection/Disposal of Old Equipment/Used Battery
Information for Users on Collection and Disposal of Old
Equipment and Used Batteries
When disposing your old battery, please refer to the information as follows.
Information on Disposal in the European Union

These crossed-out wheeled bin symbols on the products, packaging, and/or accompanying
documents mean that used electronic products and batteries should not be mixed with
general household waste. For proper treatment, recovery and recycling of old products and
used batteries, please take them to applicable collection points, in accordance with your
national legislation and the Directives 2006/66/EC.

By disposing of these products and batteries correctly, you will help to save valuable
resources and prevent any potential negative effects on human health and the environment
which could otherwise arise from inappropriate waste handling.

For more information about collection and recycling of old products and batteries, please
contact your local municipality, your waste disposal service or the point of sales where you
purchased the items.
NOTE

The bottom two letters might be used in combination with the crossed-out wheeled bin
symbol. In this case it complies with the requirement established by the Directive for the
chemical involved.
“Pb” and “Cd” mean lead and cadmium respectively.