2017 Acura NSX Owner's Guide

172 || 173
HANDLING THE UNEXPECTEDHANDLING THE UNEXPECTED
n Passenger’s Side Fuse Box
Located below the glov
e box. Use a Phillips-head screwdriver to remove the clips, then open
the cover panel.
Fuse Bo x
Fuse Label
Clip
Under Cove r
AmpsCircuit Protected
a
(2 0A )
b
(2 0A )
c
(1 0A )
de7. 5A
f7. 5A
g7. 5A
h7. 5A
Passenger’s Power Seat
Sliding*
Passenger’s Power Seat Reclining *


Wiper EPS
DR1
Power System 3
*if equipped
n Interior Rear Fuse Box
Located near the r
ear-center speaker. The fuse label is the hood fuse box “A”.
Fuse Box
Circuit ProtectedAmps
1HCA- 220A
2345HCA- 120A
620 A
7DI-INJ
8TCU30 A

174 || 175
MAINTENANCEHANDLING THE UNEXPECTED
n Inspecting and Changing Fuses
Set the power mode to
VEHICLE OFF (LOCK). Turn off the
headlights and all accessories.
Remove the fuse box cover.
Check the large fuse in the hood.
If the fuse is blown, use a Phillips-head screwdriver to remove
the screws and replace the fuse with a new one. Reinstall the
screws.
Inspect the small fuses in the hood and the vehicle interior.
If there is a burned out fuse, remove it with the fuse puller and
replace it with a new one.
Blown fuse
Combined fuse
Fuse puller
Replacing a fuse with one that has a higher rating greatly increases the chances of damaging
the electrical system.
NOTICE
MAINTENANCE
Learn about basic maintenance that you can perform on the vehicle yourself, as well as
information about how to best maintain the vehicle.
Safety Precautions
Some of the most important safety precautions are listed below; however, we cannot warn you
of every conceivable hazard that can arise in performing maintenance. Only you can decide
whether or not you should perform a given task.
n
Maintenance Safety
To reduce the possibility
of fire or explosion, keep cigarettes, sparks, and flames away from
the battery and all fuel-related parts.
Never leave rags, towels, or other flammable objects in the engine compartment.
To clean parts, use a commercially available degreaser or parts cleaner, not gasoline.
Wear eye protection and protective clothing when working with the battery or compressed
air.
Do not run the engine in confined spaces where carbon monoxide gas can accumulate.
n
Vehicle Safety
The vehicle must be stationary

, and parked on level ground with the parking brake set and
the engine off.
Be aware that hot parts can burn you.
Be aware that moving parts can injure you.

176 || 177
MAINTENANCEMAINTENANCE
Improperly maintaining this vehicle or failing to correct a problem before driving
can cause a crash in which you can be seriously hurt or killed.
Always follow the inspection and maintenance recommendations according to
the schedules in this guide.
WARNING
Failure to properly follow maintenance instructions and precautions can cause
you to be seriously hurt or killed.
Always follow the procedures and precautions in this guide.
WARNING
Maintenance Minder™
When maintenance is due, the system message indicator comes on and the Maintenance
Minder appears on the multi-information display every time you turn the vehicle on. Press the
Info (p/q) buttons on the steering wheel to change displays.
See page 179 to check the indicated maintenance service(s).
Maintenance Service Items
Remaining Engine Oil Life
Righ t Selector Whee l

178 || 179
MAINTENANCEMAINTENANCE
Independent of the Maintenance Minder information:
•
Replace the brake

fluid every 3 years.
•
Inspect idle speed every 160,000 miles (256,000 km).
•
Adjust the val

ves during services A, B, 1, 2, or 3 if they are noisy.
•
Inspect the fuel injection systems every 3

years.
•
Inspect tire condition every 3,

100 miles (5,000 km).
For U.S. models: Maintenance, replacement, or repair of emissions control devices and systems may
be done by any automotive repair establishment or individuals using parts that are certified to EPA
standards.
According to state and federal regulations, failure to perform maintenance on the maintenance main items
marked with # will not void your emissions warranties. However, all maintenance services should be performed
in accordance with the intervals indicated by the multi-information display.
n Maintenance Minder Service Codes
These codes indicate what services are due on your vehicle.
*1: If a message SERVICE does not appear more than 12 months after the displ\
ay is reset,
CODE
change the engine oil every year.
See information on maintenance and emissions warranty.
A Maintenance Main Items
B
Inspect exhaust system#
Inspect fuel lines and connections#
Inspect direct injection + port injection fuel system
Replace engine oi
l*1
Replace engine oil*1 and oil lter
Inspect front and rear brakes
Check expiration date for temporary tire repair
kit bottle
Inspect tie rod ends, steering gearbox, and boots
Inspect suspension components
Inspect driveshaft boots
Inspect brake hoses and li nes (Including ABS/VSA)
Inspect all uid levels and condition of uids
#

180 || 181
MAINTENANCEMAINTENANCE
every year.
*4:D riving in mountainous areas at very low vehicle speeds results in higher\
transmission temperature.
This requires transmission uid and clutch uid changes more frequ\
ently than recommended by the
*2: If you drive in dusty conditions, replace the air cleaner element every \
15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of s\
oot in the air from industry and
from diesel-powered vehicles, replace the dust and pollen lters ever\
y 15,000 miles (24,000 km) or
Maintenance Minder. If you regularly drive your vehicle under this condi\
tion, have the transmission
uid and clutch uid changed every 20,000 miles (32,000 km).
*5:D riving in mountainous areas at very low vehicle speeds results in higher\
level of mechanical (Shear)
CODE
1
Inspect tire condition
2
Maintenance Sub Items
stress to uid. This requires Twin Motor Unit uid changes more frequently than recommended by the
Maintenance Minder. If you regularly drive your vehicle under these cond\
itions, have the Twin Motor
Unit uid changed at 7,500 miles (12,000 km), then every 15,000 mil\
es (24,000 km).
3
Replace air cleaner element*2
Replace dust and pollen flters*3
4
Replace transmission fuid*4
Replace clutch fuid*4
Inspect Active Exhaust Valve function Replace spark plugs
Inspect valve clearance
5 Replace Intake Sound Control
6
Replace engine coolan
t
Replace Twin Motor Unit fuid*5
n Opening the Hood
Park the
vehicle on a level surface, and set the parking brake.
Pull the hood release handle under the lower left corner of
the dashboard.
Push the hood latch lever to release the lock mechanism, and
open the hood.
Lift the hood up most of the way. The hydraulic supports will
lift it up the rest of the way and hold it up.
When closing, lower it to approximately 12 inches (30 cm),
then press down firmly with your hands and ensure that both
left and right latches are locked in place.
Pull
Hood Release Handle
Lever

182 || 183
MAINTENANCEMAINTENANCE
Under the Hood
Brake Fluid
(Black Cap)
Washer Fluid
(Black Cap)
12-Volt Battery
Inverter Coolant
Filler Tank
n Opening the Hatch
Park the
vehicle on a level surface, and set the parking brake.
Press the hatch release handle on the driver’s door.
Lift the hatch up most of the way. The hydraulic supports will
lift it up the rest of the way and hold it up.
When closing, lower it to approximately 12 inches (30 cm),
then press down firmly with your hands.
Hatch Release Button
n Removing the Engine Compartment Cover
Pull up on the co
ver to pull it off the pins.
Engine
CoversCompartment

184 || 185
MAINTENANCEMAINTENANCE
Under the Hatch
Engine Oil Fill Cap
Engine Coolant
Reserve Tank Cap
Reserve TankEngine Coolant
Engine Oil Dipstick
(Orange)
Engine Oil
We recommend you check the engine oil level each time you refuel.
n
Checking the Oil
From

inside the vehicle:
1.
Display the Oil Level

Check Assist in the driver
information interface (see page 51) .
2.
Run the engine until the W

arm Up gauge is full.
3. Park on level ground and shift to (P). Idle the engine until
the Idle Time gauge is full and and the Ready to Check
Oil Level message appears. Do not press the accelerator
during this time.
4. Set the power mode to VEHICLE OFF (LOCK). Start a two-
minute timer.
5.
Open the hatch

186 || 187
MAINTENANCEMAINTENANCE
From outside the vehicle:
1.
Remove

the passenger-side engine cover (see page 183)
2.
When the two-minute timer completes, remo

ve the
dispstick (orange loop), wipe it clean, and reinsert it (flat
side of loop toward oil fill cap)
3.
Remove

the dipstick and check the oil level. It should be
between the upper and lower marks. Add oil if needed.
When finished, select a different display in the driver
information interface.
Upper Mark
Lower Mark
n Recommended Engine Oil
Use full synthetic, 0W-40 motor oil such as
Ultimate
Full Synthetic Motor Oil, Type 3, 0W-40, available at your
authorized Acura NSX dealer.
Ambient Temperature
Acura cannot ensure proper engine operation and durability if other engine oil is used..
NOTICE n
Adding Oil
Unscrew and remo

ve the engine oil fill cap.
Add oil slowly.
Reinstall the engine oil fill cap and tighten it securely.
Recheck the engine oil level (see page 185).
Oil Fill CapFlat Side
Do not fill the engine oil above the upper mark. Overfilling the engine oil can result in leaks
and engine damage.
NOTICE
Use only oil that displays an API Certification Seal on the
container. This seal indicates the oil is energy conserving
and that it meets the American Petroleum Institute’s latest
requirements.