Page 193 of 396

191
C4-2_en_Chap06_conduite_ed02-2015
Hill start assist
On an ascending slope, with the vehicle
stationar y, the vehicle is held for a brief
moment when you release the brake pedal:
-
i
f you are in first gear or neutral with a
m
anual
g
earbox,
-
i
f you are in position D or M with an
automatic
gearbox.
Operation
On a descending slope, with the vehicle
stationary and reverse gear engaged, the
vehicle is held for a brief moment when you
release the brake pedal.
Operating fault
If a fault occurs with the system, these warning lamps come on. Contact a CITROËN dealer
o
r a qualified workshop to have the system
c
hecked.
System
which
keeps
your
vehicle
immobilised
t
emporarily
(approximately
2
seconds)
when
s
tarting
on
a
gradient,
the
time
it
takes
to
m
ove
your
foot
from
the
brake
pedal
to
the
a
ccelerator
ped
al.
This
function
is
only
active
when:
-
t
he
vehicle
is
completely
stationary,
with
y
our
foot
on
the
brake
pedal,
-
w
hen
certain
conditions
of
gradient
are
m
et,
-
w
ith
the
driver’s
door
closed.
The hill start assist function cannot be
deactivated.
Do
not
leave
the
vehicle
while
it
is
being
h
eld
in
the
hill
start
assist
phase.
If you need to leave the vehicle while
the
engine
is
running,
apply
the
parking
b
rake
manually
then
ensure
that
the
p
arking
brake
warning
lamp
is
on
(not
f
lashing)
in
the
instrument
panel.
6
Driving
Page 194 of 396

192
C4-2_en_Chap06_conduite_ed02-2015
Tyre under-inflation detection
System which automatically checks the p
ressures of the tyres while driving.
The
system continuously monitors the
p
ressures of the four tyres, as soon as the
vehicle
is moving.
A pressure sensor is located in the valve of
each
tyre (except the spare wheel).
The
system triggers an alert if a drop in
p
ressure is detected in one or more tyres.
The
tyre under-inflation detection system is an
a
id to driving which does not replace the need
f
or vigilance on the part of the driver.This
system does not avoid the need
t
o check the tyre pressures regularly
(
including the spare wheel) and before
a
long journey.
Driving with under-inflated tyres
a
dversely affects road holding,
e
xtends braking distances and causes
p
remature tyre wear, particularly under a
rduous conditions (vehicle loaded, h
igh speed, long journey).The tyre pressures for your vehicle can
be
found on the tyre pressure label.
The tyre pressures must be checked
w
hen the tyres cold (vehicle stopped
f
or 1 hour or after driving for less then
6
miles (10 km) at moderate speed).
O
ther wise, add 0.3 bar to the values
i
ndicated on the label.
For m ore i nformation o n id entification m
arkings, including the tyre pressure
l
abel, refer to the corresponding
s
ection.
Driving
with under-inflated tyres
i
ncreases fuel consumption.
Driving
Page 195 of 396

193
C4-2_en_Chap06_conduite_ed02-2015
The flashing and then fixed illumination of the under-inflation w
arning lamp accompanied by the
i
llumination of the service warning
l
amp indicates a fault with the system.
Operating fault
The alert is given by the fixed illumination of this warning lamp,
a
ccompanied by an audible signal,
a
nd depending on equipment, the
d
isplay of a message.
Under-inflation alert
In the event of a problem on one of the tyres, the symbol or the message appears, according
t
o equipment, to identify it.
F
R
educe speed, avoid sudden steering
m
ovements or harsh brake applications.
F
S
top as soon as it is safe to do so. In
this case, monitoring of the tyre pressures is
n
ot assured.
F
I
f you have a compressor (the one in the
t
emporary puncture repair kit for example),
c
heck the four tyre pressures when cold.
I
f it is not possible to check the tyre
p
ressures at the time, drive carefully at
r
educed
s
peed.
or
F
I
n the event of a puncture, use the
temporary puncture repair kit or the spare
w
heel (according to equipment).
Go to a CITROËN dealer or a qualified w
orkshop to have the system checked or,
f
ollowing the repair of a puncture, to have the
o
riginal wheel, equipped with a sensor, refitted.
Any
tyre repair or replacement on a wheel
f
itted with this system must be carried out by a
C
ITROËN dealer or a qualified workshop.
If
after changing a tyre, a wheel is not detected
b
y your vehicle (fitting snow tyres for example),
y
ou must have the system reinitialised by a
C
ITROËN dealer or a qualified workshop.
The loss of pressure detected does not
always
lead to visible deformation of
t
he tyre.
Do
not rely on just a visual check.This alert is also displayed when one or
more
wheels is not fitted with a sensor
(
for example, a space-saver or steel
spar
e
w
heel).
The alert is maintained until the tyre or t
yres concerned is reinflated, repaired
or replaced.
The
spare wheel (space-saver type or a
s
teel rim) does not have a sensor.
6
Driving
Page 196 of 396

194
C4-2_en_Chap06_conduite_ed02-2015
Lane departure warning system
Activation
Deactivation
DetectionOperating fault
System which detects the involuntary crossing o
f longitudinal traffic lane markings on the
g
round (solid or broken line).
Sensors,
fitted below the front bumper, trigger
a
warning if the vehicle drifts over a lane
m
arking (speed higher than 50 mph (80 km/h)).
This
system is particularly useful on motor ways
a
nd main roads. In
the event of a malfunction, the
s
ervice warning lamp comes on,
a
ccompanied by an audible signal
a
nd a message in the screen.
Contact a CITROËN dealer or a qualified
w
orkshop.
The lane departure warning system
c
annot in any circumstances replace
t
he need for vigilance on the part of the
d
river.
It
is necessary to observe driving
r
egulations and take a break every
t
wo hours. The
detection may be impeded:
- i f the sensors are dirty (mud, snow...),
-
i
f the markings on the ground are
w
orn,
-
i
f there is little contrast between the
markings
on the ground and the
r
oad sur face.
You
are warned by the vibration of the driver's
s
eat cushion:
-
o
n the right-hand side, if the marking on
t
he ground has been crossed on the right,
-
o
n the left-hand side, if the marking on the
g
round has been crossed on the left.
No
warning is transmitted while the direction
i
ndicator is active and for approximately
2
0 seconds after the direction indicator is
switched
off.
A
warning may be transmitted if a direction
m
arking (e.g. arrow) or non-standard marking
(
e.g. graffiti) is crossed.
F
W
hen switching the ignition on or with
t
he engine running, press this button; the
i
ndicator lamp comes on.
F
P
ress this button again, the indicator lamp
g
oes off.
The status of the system remains in the m
emory when the ignition is switched off.
Driving
Page 197 of 396

195
C4-2_en_Chap06_conduite_ed02-2015
Blind spot sensors
This driving assistance system warns the driver of the presence of another vehicle in the blind
spot
angle of their vehicle (areas masked from
t
he driver's field of vision), as soon as this
p
resents a potential danger.
Operation
F On switching on the ignition, or engine r
unning, press this button to activate the
f
unction; the warning lamp comes on.
Sensors
fitted in the front and rear bumpers
m
onitor the blind spots.
A
warning
lamp
appears
in
the
door
mirror
on
t
he
side
in
question:
-
i
mmediately,
when
being
overtaken,
-
a
fter a delay of about one second, when
overtaking
a
vehicle
slowly.
This
system
is
designed
to
improve
s
afety
when
driving
and
is
in
no
c
ircumstances
a
substitute
for
the
use
o
f
the
interior
rear
view
mirror
and
door
m
irrors.
It
is
the
driver's
responsibility
to
c
onstantly
check
the
traffic,
to
assess
t
he distances and relative speeds
of other vehicles and to predict their
movements
before
deciding
whether
to
c
hange
lan
e.
The
blind
spot
sensor
system
can
never
r
eplace
the
need
for
vigilance
on
the
p
art
of
the
driver.
6
Driving
Page 198 of 396

196
C4-2_en_Chap06_conduite_ed02-2015
No alert will be given in the following situations:
- i n the presence of immobile objects
(
parked vehicles, barriers, street lamps,
r
oad
s
igns...),
-
w
ith vehicles moving in the opposite
d
irection,
-
d
riving on a sinuous road or a sharp
c
o r n e r,
The
alert
is
given
by
a
warning
lamp
which
c
omes
on
in
the
door
mirror
on
the
side
in
q
uestion
as
soon
as
a
vehicle
-
car,
lorry,
cycle
-
is
detected.
For
this,
the
following
conditions
must
be
met:
-
a
ll
the
vehicles
must
be
moving
in
the
sa
me
d
irection,
-
t
he
speed
of
your
vehicle
is
between
7
and
7
5
mph
(12
and
140
km/h),
-
w
hen
you
overtake
a
vehicle
with
a
speed
d
ifference
of
less
than
6
mph
(10
km/h),
-
w
hen
a
vehicle
overtakes
you
with
a
speed
d
ifference
of
less
than
15
mph
(25
km/h),
-
t
he
traffic
must
be
flowing
normally,
-
i
n
the
case
of
an
overtaking
manoeuvre,
i
f
this
is
prolonged
and
the
vehicle
being
ov
ertaken
remains
in
the
blind
spot,
-
y
ou
are
driving
on
a
straight
or
slightly
c
urved road,
-
y
our
vehicle
is
not
pulling
a
trailer,
a
c
aravan... -
w hen overtaking (or being overtaken by) a v
ery long vehicle (lorry, coach...) which is
a
t the same time detected at the rear in the
b
lind spot angle and present in the driver's
f
orward field of vision,
-
i
n very heavy traffic: vehicles detected in
f
ront and behind are confused with a lorry
or
a stationary object,
-
w
hen overtaking quickly.
Driving
Page 199 of 396

197
C4-2_en_Chap06_conduite_ed02-2015
F To deactivate the system, press this button a
gain; the warning lamp goes off.
The
state of the system remains in memory on
s
witching off the ignition.
Operating fault
The system is automatically deactivated when towing with a towbar approved by
CIT
ROËN. The
system may suffer temporary
i
nterference in certain weather
conditions (rain, hail...).
In particular, driving on a wet sur face
o
r moving from a dry area to a wet area
c
an cause false alerts (for example, the
p
resence of a fog of water droplets in
t
he blind spot angle is interpreted as a
v
ehicle).
In bad or wintry weather, ensure that
the sensors are not covered by mud, ice
o
r snow.
Take care not to cover the warning zone
i
n the door mirrors or the detection
z
ones on the front and rear bumpers
w
ith adhesive labels or other objects;
t
hey may hamper the correct operation o
f the system.
In the event of a fault, the warning lamp in the
b
utton flashes then goes off.
Have it checked by a CITROËN dealer or a
q
ualified
w
orkshop.
6
Driving
Page 200 of 396
198
C4-2_en_Chap06_conduite_ed02-2015
6. Speed limiter on / pause indication.
7. S peed limiter mode selection indication.
8.
P
rogrammed speed value.
9.
S
election of a memorised speed setting.
Displays in the instrument panel
Speed limiter
1. Speed limiter mode selection wheel.
2. P rogrammed value decrease button.
3.
P
rogrammed value increase button.
4.
S
peed limiter on / pause button.
5.
D
isplay memorised speed settings button.
Steering mounted controls
System which prevents the vehicle from exceeding the speed programmed by the driver.
The speed limiter is switched on manually.
The minimum programmed speed is 2
0 mph (30 km/h).
The
programmed speed remains in the
s
ystem memory when the ignition is
s
witched off.
The speed limiter is a driving aid that cannot, in any circumstances, replace the n
eed to observe speed limits or the need
f
or vigilance on the part of the driver.
Driving