2016 Citroen C4 Owner's Manual

79
C4-2_en_Chap02_ouvertures_ed02-2015
Boot
Opening
Complete unlocking
F After  unlocking   the   vehicle   or   the   boot   with  t
he   Keyless   Entry   and   Starting   system  
e

lectronic   key   on   your   person   in   the  
r

ecognition   zone   A,
  press   the   boot   opening  
c

ontrol   then   raise   the   tailgate.
Selective unlocking
When unlocking of the boot only is activated:
F  
W
ith   the   electronic   key   on   your   person   and  
i

n   the   recognition   zone   A, press the boot
unlocking
  control   to   unlock   just   the   boot,  
t

hen   raise   the   tailgate.
By
  default,   complete   unlocking   is   activated.
This   setting   is   done   in   the   "Driving"
 
menu,  
t

hen "Vehicle settings"
and "Vehicle
access" .
The
 
vehicle
 
or
 
just
 
the
 
boot
 
is
 
unlocked,
 
d

epending
 o

n
 t

he
 se

tting.
Use  this   button   for   access   to  
a

dditional
 in
formation.
Closing
F Lower  the   tailgate   using   one   of   the   interior  g
rab han dles.
If
  the   boot   is   not   closed   correctly:
-
 
w
ith   the   engine   running   or   the  
v

ehicle   moving   (speed   below  
6

  mph   (10   km/h)),   this   warning  
l

amp   comes   on,   accompanied   by  
t

he   display   of   an   alert   message  
f

or   a   few   seconds.
-
 
w
ith   the   vehicle   moving   (speed   above  
6 m

ph   (10   km/h)),   in   addition   to   the   warning  
l

amp   and   alert   message,   there   is   an   an  
a

udible   signal   for   a   few   seconds.
Unlocking
 
is
 
signalled
 
by
 
rapid
 
flashing
 
of
 
the
 
d

irection
 
indicators
 
for
 
a
 
few
 
seconds.
2
Access

80
C4-2_en_Chap02_ouvertures_ed02-2015
Tailgate release
Unlocking
F Fold  back   the   rear   seats   to   gain   access   to  t
he   lock   from   inside   the   boot.
F
 
I
nsert   a   small   screwdriver   into   hole   A of the
lock
  to   unlock   the   tailgate.
F
 
M
ove   the   latch   to   the   left.
Locking after closing
If the fault persists after closing again, the boot will   remain   locked.
System
 
allowing
 
the
 
mechanical
 
unlocking
 
o

f the boot in the event of a battery or central
locking
 
system
 
malfunction.
Access

81
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Front seats
Manual adjustments
Forwards-backwardsSeat heightSeat backrest angle
F Raise the control and slide the seat
for wards   or   backwards.
F
 
R
elease   the   control   to   lock   the   position.F
P ull the control upwards to raise or push
it   downwards   to   lower,   as   many   times   as  
n

ecessary,   to   obtain   the   position   required.F
 T urn   the   control   knob   to   adjust   the   seat  b
ackrest   angle.
As
  a   safety   measure,   seat   adjustments  
s

hould   only   be   done   when   stationary.
Before   moving   the   seat   backwards,   ensure   that   there   is   nothing   that   might   prevent   the   full  
t

ravel   of   the   seat,   so   as   to   avoid   the   risk   of   of   jamming   the   seat   caused   by   the   presence   of  
o

bjects   on   the   floor   behind   the   seat   or   rear   passengers.   If   the   seat   jams,   stop   the   movement  
i

mmediately.
3
Ease of use and comfort

82
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Driver's seat electric adjustments
Forwards-backwards
F Tilt the rear part of the control upwards or downwards   to   obtain   the   required   height.
F

T
ilt the front part of the control upwards or
downwards
  to   obtain   the   required   angle.
Cushion height and angle
F Tilt the control for wards or rear wards to adjust   the   angle   of   the   seat   backrest.
Seat backrest angle
F Push the control for wards or rear wards to slide   the   seat. Before
  moving   the   seat   backwards,   ensure   that   there   is   nothing   that   might   prevent   the   full  
t

ravel   of   the   seat,   so   as   to   avoid   the   risk   of   of   jamming   the   seat   caused   by   the   presence   of  
o

bjects   on   the   floor   behind   the   seat   or   rear   passengers.   If   the   seat   jams,   stop   the   movement  
i

mmediately.
The   electrical   functions   of   the   driver's   seat
 a

re   deactivated   approximately   one   minute
 a

fter   the   ignition   is   switched   off.
To   reactivate   them,   switch   on   the   ignition.
Ease of use and comfort

83
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Additional adjustments
Head restraint height and angle
F To  raise   a   head   restraint,   pull   it   upwards.
F  T o   lower   the   head   restraint,   press   the   lug   A
and
  the   head   restraint   at   the   same   time.
F
 
T
o   adjust   the   angle   of   the   head   restraint,   tilt  
i

ts   lower   part   for wards   or   rear wards.
Heated seats control
With the engine running, the front seats can be heated s eparately.
F
 
U
se   the   adjustment   dial,   placed   on   the   side  
o

f each front seat, to switch on and select
the
  level   of   heating   required:
0:

  Off.
1:

  Low.
2:

  Medium.
3:

  High.
Removing a head restraint
F To  remove   the   head   restraint,   press   the  l
ug A   and   pull   the   head   restraint   upwards.
F
 
T
o   put   the   head   restraint   back   in   place,  
e

ngage   the   head   restraint   stems   in   the  
o

penings   keeping   them   in   line   with   the   seat  
b

ack   and   press   the   lug   A   at   the   same   time.
The
 
head
 
restraint
 
is
 
fitted
 
with
 
a
 
frame
 
w

ith
 
notches
 
which
 
prevents
 
it
 
from
 
l

owering;
 
this
 
is
 
a
 
safety
 
device
 
in
 
case
 
o

f
 
impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head. Never drive with the head restraints
removed;
  they   must   be   in   place   and  
adj

usted
 c
orrectly.
3
Ease of use and comfort

84
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Manual lumbar adjustment
F Turn  the   knob   to   obtain   the   desired   level   of  l
umbar sup port. This
  function   provides   a   back   massage;   it   only  o
perates   when   the   engine   is   running.
F  P ress   the   switch   to   activate   the   function.
The
  warning   lamp   on   the   switch   comes   on   and  
t

he   massage   function   is   activated   for   a   period  
o

f   60   minutes.   During   this   time,   massage   is  
p

er formed   in   6   cycles   of   10   minutes   each   cycle  
(

6   minutes   of   massage   followed   by   4   minutes  
b

reak).
After
  an   hour,   the   function   is   automatically  
d

eactivated.   The   warning   lamp   in   the   switch  
g

oes   off.
Deactivation
You can deactivate the massage function at any   time   by   pressing   the   switch.   The   movement  
i

n   progress   continues   until   the   initial   non-
massage
  position   is   reached.
Massage function
Electric lumbar adjustment
F Press the front or rear of the control to obtain   the   desired   lumbar   support.
Ease of use and comfort

85
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Storing driving positions
Storing a position
Using buttons M / 1 / 2
F Switch  on   the   ignition.
F  A djust   your   seat   and   the   door   mirrors.
F

P
ress button M , then press button 1 or 2
within
  four   seconds.
 A

n   audible   signal   indicates   that   the   position  
h

as   been   stored.
Recalling a stored position
Ignition on or engine running
F Press button 1 or 2 to recall the corresponding p osition.
 A

n   audible   signal   confirms   that   adjustment  
i

s   complete.
System
 
which
 
registers
 
the
 
electrical
 
settings
 
o

f
 
the
 
driver's
 
seat
 
and
 
door
 
mirrors.
 
It
 
enables
 
y

ou
 
to
 
store
 
and
 
recall
 
two
 
positions
 
using
 
the
 b
uttons
 
on
 
the
 
side
 
of
 
the
 
driver's
 
seat.
Storing
 
a
 
new
 
position
 
cancels
 
the
 
p

revious
 p

osition. You
  can   interrupt   the   current   movement  
b

y   pressing   button M, 1 or 2
  or   by   using  
o

ne   of   the   seat   controls.
A stored position cannot be recalled
while
  driving.
Recalling
  stored   positions   is  
d

eactivated   45   seconds   after   switching  
o

ff   the   ignition.
3
Ease of use and comfort

86
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Steering wheel adjustment
F When stationary , pull the control lever to
release   the   adjustment   mechanism.
F
 
A
djust   the   height   and   reach   to   suit   your  
d

riving   position.
F
 
P
ush   the   control   lever   to   lock   the  
a

djustment
 m
echanism.
As
  a   safety   measure,   these   operations  
s

hould only be carried out with the
vehicle
  stationary.
Ease of use and comfort