2016 Citroen C4 driver seat adjustment

82
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Driver's seat electric adjustments
Forwards-backwards
F Tilt the rear part of the control upwards or downwards   to   obtain   the   required   height.
F

T
ilt the front part of the control upwards or
downwards
  to   obtain   the   required   angle.
Cushion height and angle
F Tilt the control for wards or rear wards to adjust   the   angle   of   the   seat   backrest.
Seat backrest angle
F Push the control for wards or rear wards to slide   the   seat. Before
  moving   the   seat   backwards,   ensure   that   there   is   nothing   that   might   prevent   the   full  
t

ravel   of   the   seat,   so   as   to   avoid   the   risk   of   of   jamming   the   seat   caused   by   the   presence   of  
o

bjects   on   the   floor   behind   the   seat   or   rear   passengers.   If   the   seat   jams,   stop   the   movement  
i

mmediately.
The   electrical   functions   of   the   driver's   seat
 a

re   deactivated   approximately   one   minute
 a

fter   the   ignition   is   switched   off.
To   reactivate   them,   switch   on   the   ignition.
Ease of use and comfort

85
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Storing driving positions
Storing a position
Using buttons M / 1 / 2
F Switch  on   the   ignition.
F  A djust   your   seat   and   the   door   mirrors.
F

P
ress button M , then press button 1 or 2
within
  four   seconds.
 A

n   audible   signal   indicates   that   the   position  
h

as   been   stored.
Recalling a stored position
Ignition on or engine running
F Press button 1 or 2 to recall the corresponding p osition.
 A

n   audible   signal   confirms   that   adjustment  
i

s   complete.
System
 
which
 
registers
 
the
 
electrical
 
settings
 
o

f
 
the
 
driver's
 
seat
 
and
 
door
 
mirrors.
 
It
 
enables
 
y

ou
 
to
 
store
 
and
 
recall
 
two
 
positions
 
using
 
the
 b
uttons
 
on
 
the
 
side
 
of
 
the
 
driver's
 
seat.
Storing
 
a
 
new
 
position
 
cancels
 
the
 
p

revious
 p

osition. You
  can   interrupt   the   current   movement  
b

y   pressing   button M, 1 or 2
  or   by   using  
o

ne   of   the   seat   controls.
A stored position cannot be recalled
while
  driving.
Recalling
  stored   positions   is  
d

eactivated   45   seconds   after   switching  
o

ff   the   ignition.
3
Ease of use and comfort

146
C4-2_en_Chap05_securite_ed02-2015
The driver must ensure that passengers use the seat belts correctly and that they are all
fastened
  before   setting   off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do
  not   interchange   the   seat   belt   buckles   as  
t

hey   will   not   fulfil   their   role   fully.
The seat belts are fitted with an inertia reel
permitting
  automatic   adjustment   of   the   length  
o

f   the   strap   to   your   size.   The   seat   belt   is  
s

towed   automatically   when   not   in   use.
Before and after use, ensure that the seat belt
is
  reeled   in   correctly.
The
  lower   part   of   the   strap   must   be   positioned  
a

s   low   as   possible   on   the   pelvis.
The
  upper   part   must   be   positioned   in   the  
h

ollow   of   the   shoulder.
The
  inertia   reels   are   fitted   with   an   automatic  
l

ocking   device   which   comes   into   operation   in  
t

he   event   of   a   collision,   emergency   braking  
o

r   if   the   vehicle   rolls   over.   You   can   release  
t

he   device   by   pulling   the   strap   firmly   and   then  
r

eleasing   it   so   that   it   reels   in   slightly.Recommendations for children
Use a suitable child seat if the passenger is less than 12 years old or shorter than one
and
  a   half   metres.
Never
  use   the   same   seat   belt   to   secure   more  
t

han   one   person.
Never
  allow   a   child   to   travel   on   your   lap.
For
  more   information   on   child   seats,   refer   to  
t

he   corresponding   section.
In the event of an impact
Depending on the nature and seriousness
of the impact,
  the   pretensioning   device   may  
b

e deployed before and independently of the
airbags.
  Deployment   of   the   pretensioners  
i

s   accompanied   by   a   slight   discharge   of  
h

armless   smoke   and   a   noise,   due   to   the  
a

ctivation   of   the   pyrotechnic   cartridge  
i

ncorporated   in   the   system.
In
  all   cases,   the   airbag   warning   lamp   comes   on.
Following
  an   impact,   have   the   seat   belts  
s

ystem   checked,   and   if   necessary   replaced,  
b

y   a   CITROËN   dealer   or   a   qualified  
w

orkshop.
Advice
In order to be effective, a seat belt must:
-  b e   tightened   as   close   to   the   body   as  
p

ossible,
-
 
b
e   pulled   in   front   of   you   with   a   smooth  
m

ovement,   checking   that   it   does   not  
t

wist,
-

b
e used to restrain only one person,
-
 
n
ot   bear   any   trace   of   cuts   or   fraying,
-
 
n
ot   be   converted   or   modified   to   avoid  
a

ffecting
 it
s
 p
erformance.
In accordance with current safety
regulations,
  for   all   repairs   on   your   vehicle's  
s

eat   belts,   go   to   a   qualified   workshop   with  
t

he   skills   and   equipment   needed,   which   a  
C

ITROËN   dealer   is   able   to   provide.
Have
  your   seat   belts   checked   regularly   by  
a

  CITROËN   dealer   or   a   qualified   workshop,  
p

articularly   if   the   straps   show   signs   of  
d

amage.
Clean the seat belt straps with soapy
water
  or   a   textile   cleaning   product,   sold   by  
C

ITROËN   dealers.
After
  folding   or   moving   a   seat   or   rear   bench  
s

eat, ensure that the seat belt is positioned
and
  reeled   in   correctly.
Safety