2015 Citroen C4 Owner's Manual

95
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Storing driving positions
Storing a position
Using buttons M / 1 / 2
F Switch  on   the   ignition.
F  A djust   your   seat   and   the   door   mirrors.
F

P
ress button M , then press button 1 or 2
within
  four   seconds.
 A

n   audible   signal   indicates   that   the   position  
h

as   been   stored.
Recalling a stored position
Ignition on or engine running
F Press button 1 or 2 to recall the corresponding p osition.
 A

n   audible   signal   confirms   that   adjustment  
i

s   complete.
System
 
which
 
registers
 
the
 
electrical
 
settings
 
o

f
 
the
 
driver's
 
seat
 
and
 
door
 
mirrors.
 
It
 
enables
 
y

ou
 
to
 
store
 
and
 
recall
 
two
 
positions
 
using
 
the
 b
uttons
 
on
 
the
 
side
 
of
 
the
 
driver's
 
seat.
Storing
 
a
 
new
 
position
 
cancels
 
the
 
p

revious
 p

osition. You
  can   interrupt   the   current   movement  
b

y   pressing   button M, 1 or 2
  or   by   using  
o

ne   of   the   seat   controls.
a

stored position cannot be recalled
while
  driving.
Recalling
  stored   positions   is  
d

eactivated   45   seconds   after   switching  
o

ff   the   ignition.
4
Comfort

96
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Rear seats
Rear head restraints
These have one position for use (up) and a stowed   position   (down).
They
  can   also   be   removed.
To
  remove   a   head   restraint:
F
 
r
elease   the   backrest   using   control   1,
F
 
t
ilt   the   backrest   2   slightly   for wards,
F

p
ull the head restraint upwards to the stop,
F
 
t
hen,   press   the   lug   A. F
 
M
ove   the   corresponding   front   seat   for ward  
i

f   necessary.
F

P
osition the seat belt between the outer
and centre head restraints to avoid
trapping
  the   belt   when   repositioning   the  
s

eat   backrest.
F

P
lace the head restraints in the low
position. F

P
ull control 1 for wards to release the seat
back
  2.
F
 
F
old   the   seat   back   2   on   to   the   cushion.
ne

ver drive with the head restraints
removed;
  they   must   be   in   place   and  
c

orrectly
 adj
usted.
Folding the backrest
Bench seat with fixed one-piece cushion and split backrest (left hand 2/3, right hand 1/3) which can be   folded   individually   to   adapt   the   load   space   in   the   boot.
Comfort

97
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Repositioning the seat backrest
F Straighten  the   seat   back   2   and   secure   it.
F  C heck  t hat  t he  r ed  i ndicator,  l ocated  n ext  t o  
t

he control 1 ,
  is   no   longer   visible.
F
 
P
ut   the   seat   belt   back   in   place   on   the   side  
o

f   the   seat   backrest.
When
  repositioning   the   seat   backrest,  
t

ake   care   not   to   trap   the   seat   belts.
4
Comfort

98
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Mirrors
Each fitted with an adjustable mirror glass permitting t he la teral r earward v ision n ecessary f

or   overtaking   or   parking.   They   can   also   be  
f

olded   for   parking   in   confined   spaces.
Demisting - Defrosting Adjustment
F Move control A
  to   the   right   or   to   the   left   to  s
elect   the   corresponding   mirror.
F

M
ove control B in all four directions to
adjust.
F

R
eturn control A   to   the   central   position.
Folding
F From  outside:   lock   the   vehicle   using   the  r
emote   control   or   the   key.
F
 
F
rom   inside:   with   the   ignition   on,   pull   the  
c

ontrol A   in   the   central   position   rear wards.
If your vehicle is fitted with heated
mirrors,
 
the
 
demisting-defrosting
 
o

perates
 
by
 
switching
 
on
 
the
 
h

eated
 
rear
 
screen.
Refer
 
to
 
the
 
"Rear
 
screen
 
demist-
defrost"
 s

ection. As
 
a
 
safety
 
measure,
 
the
 
mirrors
 
should
 
b

e
 
adjusted
 
to
 
reduce
 
the
 
blind
 
spots.
The
 
objects
 
observed
 
are,
 
in
 
reality,
 
c

loser
 
than
 
they
 
appear.
Take
 
this
 
into
 
account
 
in
 
order
 
to
 
c

orrectly
 
judge
 
the
 
distance
 
of
 
vehicles
 
a

pproaching
 
from
 
behind. If
  the   mirrors   are   folded   using   control   A,
they will not unfold when the vehicle is
unlocked.
  Pull   again   on   control   A.
Door mirrors
Comfort

99
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Automatic tilting in reverse gear
System which provides a view of the ground during   parking   manoeuvres   in   reverse   gear.
Programming
F With  the   engine   running,   engage   reverse  g
e a r.
F
 
S
elect   and   adjust   the   left-hand   and   right-
hand
  mirrors   in   succession.
The
  adjustment   is   stored   immediately.
Switching on
F With  the   engine   running,   engage   reverse  g
e a r.
F

M
ove control A   to   the   right   or   to   the   left   to  
s

elect   the   corresponding   mirror.
The
  glass   of   the   mirror   selected   tilts  
d

ownwards, in accordance with its
programming.
Switching off
F Exit   reverse   gear   and   wait   ten   seconds.
or
F

R
eturn control A   to   the   central   position.
The
  mirror   glass   returns   to   its   initial   position.
The
  mirror   glass   also   returns   to   its   initial  
p

osition:
-
 
i
f   the   speed   exceeds   6   mph   (10   km/h),
-
 
i
f   the   engine   is   switched   off.
Unfolding
F From  outside:   unlock   the   vehicle   using   the  r
emote   control   or   the   key.
F
 
F
rom   inside:   with   the   ignition   on,   pull   the  
c

ontrol A   in   the   central   position   rear wards.
If
  necessary   the   mirrors   can   be   folded  
m

anually.
The
  folding   and   unfolding   of   the   door  
m

irrors   using   the   remote   control   can   be  
d

eactivated by a CITR
oËn
dealer or a
qualified
 w

orkshop.
4
Comfort

100
C4-2_en_Chap04_confort_ed01-2015
C4-2_en_Chap04_confort_ed01-2015
Automatic day/night model
By means of a sensor, which measures the light   from   the   rear   of   the   vehicle,   this   system  
a

utomatically   and   progressively   changes  
b

etween   the   day   and   night   uses.
Steering wheel adjustment
F When stationary , pull the control lever to
release   the   adjustment   mechanism.
F
 
A
djust   the   height   and   reach   to   suit   your  
d

riving   position.
F
 
P
ush   the   control   lever   to   lock   the  
a

djustment
 m
echanism.
Rear view mirror
Manual day/night model
Adjustment
F Adjust  the   mirror   so   that   the   glass   is  
directed   correctly   in   the   "day"   position.
Day/night position
F Pull  the   lever   to   change   to   the   "night"   anti-
dazzle   position.
F
 
P
ush   the   lever   to   change   to   the  
normal
  "day"   position.
as a s
afety precaution, these
operations should only be carried out
with   the   vehicle   stationary.
In   order   to   ensure   optimum   visibility  d
uring   your   manoeuvres,   the   mirror  l
ightens   automatically   when   reverse  
g

ear
 i
s
 enga
ged.
Adjustable
  mirror   providing   a   central   rear ward   view.
Equipped   with   an   anti-dazzle   system,   which   darkens   the   mirror   glass   and   reduces   the   nuisance   to  
t

he   driver   caused   by   the   sun,   headlamps   from   other   vehicles...
Comfort

101
C4-2_en_Chap05_amenagement_ed01-2015
C4-2_en_Chap05_amenagement_ed01-2015
Front fittings
1. Grab handle
2. Sun visor
 (

see   details   on   a   following   page)
3.
T

icket/map holder
4.
I

lluminated glove box
 (

see   details   on   a   following   page)
5.
Doo

r pocket s
6.
L

arge open storage box
(without audio system)


or


S
mall storage box with flap
(with audio system)
7.
S

mall open storage box
(without audio system)
8.
U

SB por t / Auxiliar y socket
 (

see   details   on   a   following   page)
9.
1

2 V accessory socket
 (

see   details   on   following   pages)
10.
C

entre armrest with storage
  (

see   details   on   a   following   page)
5
Fittings

102
C4-2_en_Chap05_amenagement_ed01-2015
C4-2_en_Chap05_amenagement_ed01-2015
12 V accessory socket
F To  connect   a   12   V   accessory   (max   power:  1
20   W),   lift   the   cover   and   connect   a  
s

uitable
 a
daptor.
Component
 
which
 
protects
 
against
 
sunlight
 f
rom
 
the
 
front
 
or
 
the
 
side,
 
also
 
equipped
 
with
 
an
 
i

lluminated
 v

anity
 m

irror.
F
 
W

ith
 
the
 
ignition
 
on,
 
raise
 
the
 
concealing
 
f

lap;
 
the
 
mirror
 
is
 
illuminated
 
automatically.
This
 
sun
 
visor
 
is
 
also
 
equipped
 
with
 
a
 
ticket
 
h

o l d e r.
Sun visor Illuminated glove box
It has dedicated locations for storing a water b
ottle,   the   vehicle's   handbook   pack...
Its
  lid   has   locations   for   storing   a   pen,   a   pair   of  
g

lasses,   tokens,   maps,   a   cup...
F
 
T
o   open   the   glove   box,   raise   the   handle.
The
  glove   box   is   illuminated   when   the   lid   is  
ope

ned.
It
  gives   access   to   the   passenger's   front   airbag  
d

eactivation switch A .
It
  contains   an   adjustable   ventilation   nozzle   B,
distributing
  the   same   conditioned   air   as   the  
v

ents   in   the   passenger   compartment.
Fittings