Warning lamps6-38 Instruments and controls
6
With the operation mode in ON, a buzzersounds under the following condition: zThe vehicle speed exceeds 8 km/h withthe parking brake applied.
E00502602938
This lamp is a part of anonboard diagnostic systemwhich monitors the emissions,engine control system.If a problem is detected in one
of these systems, this lamp illuminates orflashes.Although your vehicle will usually be driva-ble and not need towing, we recommend youto have the system checked as soon as possi-ble.This lamp will also illuminate when the oper-ation mode of the power switch is put in ON,and goes off after the Plug-in Hybrid EV Sys-tem has started. If it does not go off after thePlug-in Hybrid EV System has started, werecommend you to have the vehicle checked.
This data will be erased if a auxiliary batterycable is disconnected which will make a rapiddiagnosis difficult. Do not disconnect a auxil-iary battery cable when the check enginewarning lamp is ON.
CAUTION zIn the situations listed below, brake perfor-mance may be compromised or the vehiclemay become unstable if brakes are appliedsuddenly; consequen
tly, avoid driving at
high speeds or applyi
ng the brakes suddenly.
Furthermore, immediately the vehicle shouldbe brought to a stop in
a safe location and we
recommend you to have it checked.•The brake warning lamp does not illumi-nate when the parking brake is applied ordoes not turn off when the parking brake isreleased.•The brake warning lamp and the ABSwarning lamp illuminate at the same time.For details, refer to “ABS warning lamp”on page 7-30.•The brake warning lamp remains illumi-nated while driving.
zThe vehicle should be brought to a halt in thefollowing manner when brake performancehas deteriorated.• Depress the brake pedal harder than usual.Even if the brake pedal moves down to thevery end of its possible stroke, keep itpressed down hard.
• Should the brakes fail, use regenerativebraking to reduce your speed and carefullypull the parking brake lever.Depress the brake pedal to operate the stoplamp to alert the vehicles behind you.
Check engine warning lamp
CAUTION
CAUTION zProlonged driving with this lamp on maycause further damage to the emission controlsystem. It could also
affect fuel economy and
drivability. zIf the lamp does not illuminate when theoperation mode is put in ON, we recommendyou to have the system checked. zIf the lamp illuminates while the Plug-inHybrid EV System is
operating, avoid driv-
ing at high speeds and have the systeminspected by a MITSUBISHI MOTORSAuthorised Service Poin
t as soon as possible.
NOTE
zThe engine electronic control moduleaccommodating the onboard diagnostic sys-tem has various fault data (especially aboutthe exhaust emission) stored.
BK0203201EN.book 38 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分
Accessory socket8-66 For pleasant driving
8
E00711602516
To u s e a p l u g - i n t y p e a c c e s s o r y, o p e n t h e l i dor remove the cap, and insert the plug in theaccessory socket.The accessory socket can be used while theoperation mode is in ON or ACC.
E00712002328
Accessory socket
CAUTION zBe sure to use a “plug-in” type accessoryoperating at 12 V and
at 120 W or less.
When using more than one socket at thesame time, make sure that the electricalaccessories are 12 V accessories and that thetotal power consumption does not exceed120 W. zLong use of the electric appliance when theready indicator is not illuminated may rundown the auxiliary battery. zWhen the accessory socket is not in use, besure to close the lid or install the cap,because the socket might become clogged byforeign material and
be short-circuited.
NOTE
zAccessory sockets in 2 locations can be usedat the same time.
Floor consoleFloor console box
Interior lamps 1- Luggage room lamp2- Room lamp (rear)3- Map & room lamps (front)4- Downlight
m P.6-40
NOTE
zIf you leave the lamps on when the readyindicator is not illuminated, you will rundown the auxiliary battery.Before you leave the vehicle, make sure thelamps are turned off.
BK0203201EN.book 66 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分
