2014 MITSUBISHI OUTLANDER SPORT wiring

Plug-in Hybrid EV System2-6 General information
2
•Open the windows, doors and tailgate.•Put the operation mode in OFF.•Turn on the hazard warning flashers.• Move the key away from the vehicle toprevent unintended start-up of the sys-tem by inadvertent contact with a switchor impact from the crash.
zNever touch high-voltage wiring, connec-tors, and other high-vol
tage parts, such as
the inverter unit and drive battery. Anelectric shock may occur if exposed elec-tric wires are visible when viewed frominside or outside of
your vehicle. For their
locations, see “High-
voltage components”
on page 2-7.zIf the vehicle receives a strong impact tothe floor while driving, stop the vehicle ina safe place and
check the floor.
zNever start the plug-in hybrid EV systemif you found the leak
of a liquid (except
water of the air conditioner) while check-ing the outside of the vehicle because thereis possibility the fuel system has beendamaged and causing of fire or exploding.In such case, immediately contact yourMITSUBISHI MOTORS Authorized Ser-vice Point.WA R N I N G
zLeaks or damage to the drive battery mayresult in a fire. If you discover them, con-tact emergency services immediately.Since the fluid leak may be lithium man-ganite from the Lithium-ion battery, nevertouch any fluid leaking from the inside oroutside of the vehicle. If the fluid contactsyour skin or eyes, wash
it off immediately
with a large amount of water and receiveimmediate medical attention to help avoidserious injury.zIf you are unable to safely assess the vehi-cle due to vehicle damage, do not touchthe vehicle. Leave the vehicle and contactemergency services. Advise emergencyresponders that this is a Plug-in Hybridvehicle.zIf a fire occurs in this vehicle, leave thevehicle as soon as possible and contactemergency services. Do not attempt toextinguish a fire by yourself. If the fireinvolves a lithium-ion battery, it willrequire large, sustained volumes of waterfor extinguishment. Using a small amountof water or the incorrect fire extinguishercan result in serious injury or death fromelectrical shock.zWhen you leave the vehicle, if possible,open the windows, doors and tailgate toprevent accumulation of poisonous/com-bustible gasses. This will
also assist in the
rescue and fire fighting process.WA R N I N G
zAs with any vehicle fire, the byproducts ofcombustion can be toxic. Do not inhalesmoke, vapors, or gas from the vehicle.Move to a safe distance upwind and uphillfrom the vehicle fire and out of the way ofany oncoming traffic while awaiting thearrival of emergency responders.zIf you detect leaking fluids, sparks, smoke,flames, gurgling, popping or hissing noisesoriginating from the high voltage batterycompartment, contact emergency servicesimmediately. This may result in a fire.zPhysical damage to the vehicle or highvoltage battery may result in immediate ordelayed release of toxic and/or flammablegases and fire.zIf your vehicle needs to be towed, trans-port the vehicle on a
flatbed truck or tow
the vehicle with all wheels off the ground.If the any wheels are on the ground whentowing, this may cause damage to the elec-tric motors. This may also cause a fire, ifwiring in the electric motor unit roombecomes damaged. Refer to “Towing” onpage 9-19.zDo not attempt to repair a damaged Plug-in Hybrid vehicle by yourself. Please con-tact a MITSUBISHI MOTORS Author-ised Service Point for service.WA R N I N G
BK0203201EN.book 6 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Plug-in Hybrid EV SystemGeneral information 2-7
2
E00204300020
When performing inspection and mainte-nance, be careful in the following points.
zIn the event of an accident that requiresbody repair and painting, the vehicleshould be delivered to a MITSUBISHIMOTORS Authorised Service Point tohave the drive battery and high voltageparts such as the inverter, including theattached wiring harness, removed prior topainting. If exposed to heat in the paintbooth, the drive battery will experiencebattery capacity loss.A damaged drive battery can also posesafety risks to untr
ained mechanics and
repair personnel.NOTE
zThe emergency shut-off system will be acti-vated and the high-voltage system will auto-matically turn off under the followingconditions:•Certain front, side or rear collisions.•Certain Plug-in Hybrid EV system mal-functions.
zWhen the emergency shut
-off system is acti-
vated, the ready indicator
is turned off. Refer
to “Indicator and warning lamps” on page6-21.zIf the emergency shut-off system activates,contact a MITSUBISHI
MOTORS Author-
ised Service Point.WA R N I N G
Inspection and maintenance
WA R N I N GzBefore performing inspection or mainte-nance, be sure to disconnect the chargeconnector from the vehicle and confirmthat put the operation mode of the powerswitch in “OFF”.zNever touch, disassemble, remove orreplace highvolt
age parts, exposed electri-
cal components, cables or connectors.Failure to follow this instruction canresult in severe burns or electric shockcausing serious injury or death. High-volt-age cables are colored orange. The vehiclehigh voltage system has no user servicea-ble parts. Take your vehicle to a MITSUB-ISHI MOTORS Authorised Service Pointfor any necessary maintenance.zNever touch the service plug under therear seat. Improper ha
ndling of this could
cause an electric shock which result in aserious injury or death. The service plug isused to shut off the high voltage from thedrive battery when repairing the vehicleat a MITSUBISHI MOTORS AuthorisedService Point.
High-Voltage components 1- On board charger/DC-DC converter 2- Rear motor3- Service plug4- Electric heater*5- Drive Battery6- Front motor7- Generator8- Air conditioner compressor9- Power drive unit (PDU)10- Rear electric motor control unit (MCU)11- Charge port
BK0203201EN.book 7 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Supplemental restrain
t system (SRS)-airbag
5-30 Seat and seat belts
5
E00407802673
There is a supplemental restraint system(“SRS”) warning lamp on the instrumentpanel. The system checks itself every time theoperation mode of the power switch is put inON. The SRS warning lamp will come on forseveral seconds and then go out. This is nor-mal and means the system is working prop-erly.If there is a problem involving one or more ofthe SRS components, the warning lamp willcome on and stay on. At the same time, thewarning display will appear on the informa-tion screen in the mu
lti information display.
The SRS warning lamp/display is shared bythe SRS airbag and the seat belt pre-tensionersystem.
E00407901619
SRS warning lamp/display
WA R N I N GzIf any of the following conditions occur,there may be a problem with the SRS air-bags and/or seat belt
pre-tensioners, and
they may not function
properly in a colli-
sion or may suddenly
activate without a
collision:•Even when the operation mode is in ON,the SRS warning lamp does not come onor it remains on.• The SRS warning lamp and/or the warn-ing display comes on while driving.The SRS airbags and seat belt pre-ten-sioners are designed to help reduce therisk of serious injury
or death in certain
collisions. If either of the above conditionsoccurs, immediately
have your vehicle
checked by a MITSUBISHI MOTORSAuthorised Service Point.
SRS servicing
WA R N I N GzWe re commend any main tenanc e per-formed on or near the components of theSRS to be performed by a MITSUBISHIMOTORS Authorised Service Point.Improper work on the SRS components orwiring could result in inadvertent deploy-ment of the airbags,
or could render the
SRS inoperative; either situation couldresult in serious injury.
zDo not modify your steering wheel, seatbelt retractor or any other SRS compo-nents. For example, replacement of thesteering wheel, or modifications to thefront bumper or body structure (forexample fitment of a frontal protectionbar, including roo bars and bull barsexcept approved MITSUBISHI MOTORSGENUINE accessory parts) can adverselyaffect SRS performance and lead to possi-ble injury.zIf your vehicle has received any damage,we recommend you to have the SRSinspected to ensure it is in proper workingorder.zDo not modify your front seats, centre pil-lar and centre console.It can adversely affect SRS performanceand lead to possible injury.zIf you found any tear, scratch, crack ordamage to the portion where the airbag isstored, you should h
ave the SRS inspected
by a MITSUBISHI MOTORS AuthorisedService Point.NOTE
zIf your vehicle has to be scrapped, do this inline with local legislation and contact a MIT-SUBISHI MOTORS Authorised ServicePoint to safely dismantle the airbag system.WA R N I N G
BK0203201EN.book 30 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Towing caravans and trailers7-72 Starting and driving
7
brake/hitch requirements, adjust the positionof the load in the trailer to achieve the specifi-cation requirements.Select the appropriate hitch combinationwhich is to be used in conjunction with theMITSUBISHI MOTORS approved parts tow-bar. If you use the load distributing hitch, itmust be installed in accordance with the man-ufacturer’s instructions.It is recommended that two safety chains areused. The chains should be
crossed
under the
trailer draw bar so that the draw bar is pre-vented from touching the ground if itbecomes detached from the vehicle. Thechains must not stop the trailer from turningfreely. Correct load rated shackles must beused to attach the chains. In some states andterritories, a single safety chain is permittedby regulation. Be sure it is attached with cor-rect load rated shackles.For further information about the selectionand use of towing equipment, consult a MIT-SUBISHI MOTORS Authorised ServicePoint.
Have your vehicle serviced prior to towing aheavy trailer or caravan, taking particularcare of the state of Plug-in Hybrid EV Systemtune, the condition of brakes, steering andtyres.Adjust tyre pressures to those quoted for afully laden vehicle (see Tyre placard).Check the tyres, wiring and brakes (if fitted)on the caravan / trailer.Have the cooling system checked and ensurethat the radiator intake is clear to allow maxi-mum air flow through the radiator. Do not
place restrictions in front of the radiator(water bags, driving lamps, insect screens,non MITSUBISHI MOTORS approved bull-bars, etc.) as they restrict air flows.Check that tow bar fixing bolts are tightenedto specification.After a loaded caravan has been connected tothe vehicle, there may be a slight change invehicle attitude which for your night drivingsafety may require the headlamps to be re-aimed.If you have never towed before, connect yourtrailer or caravan and take it for a run overfamiliar ground in your own district. Feel thedifference in acceleration, handling and brak-ing and you are less likely to be surprised ifan emergency does occur, when you are awayfrom home territory. The other driving mem-bers of your family should also becomefamiliar with the vehicle in this condition.If particularly steep or long downgrades areencountered, avoid “riding” the brakes.Apply the brakes firmly to reduce speed andthen remove your foot from the pedal to
Operating hints Ve h i c l e p r e p a r a t i o n Example
Driver preparation Hill climbing
BK0203201EN.book 72 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分